bjjrev said:

Of what? The flush?

---

dbag2192 said:

When doing pseudo casing, do you compress your sub down and then add the casing or add the casing layer and then compress?

---

Yahra said:

Should i flip over PF cakes in a water tub on a regular basis so that the bottoms get misted too or just leave them in place?

---

Yuggoth said:

If you're using LC to inoculate any kind of jar or bag, is it better to squirt, wait for partial colonization, and then break 'n' shake... Or is it better to squirt and them shake it up to distribute the LC first thing? 

Is the answer any different if LC you start with is extra thick 'n' chunky?

(Yeah I know, it is better to inoculate with agar or g2g, but I have this LC and I wanna try it, too, it may even be the origin of my g2g stock if it stays clean.)

---

sprocket said:

Were the slants very cold when you inoculated them?

---

Tetrasage said:

sprocket said:

Were the slants very cold when you inoculated them?

---

Yeah they were only out of the fridge for about 15-20 minutes. I took the plates out at the same time as well. I figured if I could take the plates out and immediatley drop to grain to warm up I could do the same with the slant

---

HILLBILLY OUTLAW said:

dbag2192 said:

When doing pseudo casing, do you compress your sub down and then add the casing or add the casing layer and then compress?

---

I always compact the sub good and tight prior to the casing then compact again after.  I use liners so then I cut out the liner and compact again cause I always jack up the corners when trimming the liner.

---

fiddle_head said:

Bigworm said:

fiddle_head said:

I opened my tub for a suprise this morning. Does this look like rot or mold to anybody? Not sure what’s going on here, feel doink.

The tub was sitting on the bottom so I can’t help but feel this is related to FAE. 2nd flush.

---

Looks like Pseudomonas.

---

Would you harvest any of these or just say toss the whole thing?

---