skrimplet said:

Yes it's cubes. The yellow I was thinking might be metabolites. This is actually the back of a plate that I poured super thin because at the time I didn't know how much agar you were supposed to put in the dish.

---

dextr0 said:

I wouldn’t personally use that plate. I’d actually probably wait until those pins get bigger and clone one. Then work that on agar till it’s clean.

---

auroradawn said:

Thinking to take transfer from the upper parts of this one?

I'm not sure if the really wonky looking part of the plate in the bottom left (but kinda everywhere) is from a problem or just from bubbling in the PC (no pour).

---

Nice clean myc.  It looks good all around but you want to take from the leading edge (upper left/upper) anywhere.

auroradawn said:

Thinking to take transfer from the upper parts of this one?

I'm not sure if the really wonky looking part of the plate in the bottom left (but kinda everywhere) is from a problem or just from bubbling in the PC (no pour).

---

logarithmic_rhythm said:

Is this tidal wave plate good to transfer from? Notice it germinate early, but took quite a lot of time to expand. The little white speckles sitting atop the mycelium especially makes me suspicious.

Aditionally, I have this B+ plate which I would like to take transfers to other plates and to grains. I wanna take from the two secotors present(at 6 o'clock, and then everything else). Stupid question, but I can just take transfers to plates first and then directly afterwards to grain?

---

To me,  that tidal wave plate looks suspicious

I am commenting to bump this thread up to the front to see if some more experienced eyes can give a credible answer to your question

logarithmic_rhythm said:

Is this tidal wave plate good to transfer from? Notice it germinate early, but took quite a lot of time to expand. The little white speckles sitting atop the mycelium especially makes me suspicious.

Aditionally, I have this B+ plate which I would like to take transfers to other plates and to grains. I wanna take from the two secotors present(at 6 o'clock, and then everything else). Stupid question, but I can just take transfers to plates first and then directly afterwards to grain?

---