Home | Community | Message Board

Magic Mushrooms Zamnesia
This site includes paid links. Please support our sponsors.


Welcome to the Shroomery Message Board! You are experiencing a small sample of what the site has to offer. Please login or register to post messages and view our exclusive members-only content. You'll gain access to additional forums, file attachments, board customizations, encrypted private messages, and much more!

Shop: Original Sensible Seeds Bulk Cannabis Seeds   Mushroom-Hut Substrate Mix   Sporeworks.EU Spores for European Microscopy   North Spore Bulk Substrate   MagicBag.co All-In-One Bags That Don't Suck

Jump to first unread post Pages: < First | | 66 | 67 | 68 | 69 | 70 | 71 | 72 | 73 | 74 | 75 | 76 | 77 | 78 | 79 | 80 | 81 | 82 | 83 | 84 | 85 | 86 | | Last >
Re: Pastywhyte’s Ez dialed monotubs [Re: ReverendMyc]
    #27761774 -

ReverendMyc said:
GhostHustler said:
Just measured, looks like I did around 4" whenever I made these up (prob bc of outdated info). Looks like im takin a trip to Big Lots to get some new ones 😂



It won't be as pretty, but you can put a small piece of tape (duck/duct) on the inside or outside over the too low holes and drill some higher. The shroomies don't mind the hillbilly-ghetto decor much.



Probably will run a few rounds of this before just trashing them, I remember when I used to do 1.5" polyfil stuffed holes the duct tape was always a giant PITA to scrub off when I went to clean the bins later on.

Extras: Filter Print Post Top
Re: Pastywhyte’s Ez dialed monotubs [Re: Pastywhyte]
    #27762292 -

So since this is going to be my first time around growing as well using this monotub, I just let it be and let it grow, only mist if needed? Just wondering since it isn't like the others where you use polyfil/tape


--------------------
'Tis is I who said "let us be friends!" or so the story goes.....

Extras: Filter Print Post Top
Re: Pastywhyte’s Ez dialed monotubs [Re: McCrumblton] * 2
    #27762334 -

Set it and forget it.



--------------------
Bod's Easy AF Search Engine TEK

Let's stay focused on what works consistently.

"Sitting in a bunker here behind my wall..."

Extras: Filter Print Post Top
Re: Pastywhyte’s Ez dialed monotubs [Re: myc_ousin_vinny]
    #27762351 -

My man, thought so but I'm a bit of a dumbass sometimes x.x


--------------------
'Tis is I who said "let us be friends!" or so the story goes.....

Extras: Filter Print Post Top
Re: Pastywhyte’s Ez dialed monotubs [Re: McCrumblton]
    #27762378 -

I'm running the hole set up on a larger mono with 4 shoeboxes in it, I'll let you guys know how it works out!

Extras: Filter Print Post Top
Re: Pastywhyte’s Ez dialed monotubs [Re: iceNock]
    #27762397 -

iceNock said:
I'm running the hole set up on a larger mono with 4 shoeboxes in it, I'll let you guys know how it works out!



I’ve done this with an 85L and it worked as advertised :thumbup:

Extras: Filter Print Post Top
Re: Pastywhyte’s Ez dialed monos (moved) [Re: SwabMarley]
    #27762456 -

Do yall tape the side and/or top holes during colonization with this tek, then pull the tape off to introduce fruiting conditions? I'm 4 days in, first time using this tek, and I taped the three holes on each of the long sides, but left the 5 holes on each of the short sides open. Things are smelling and looking good so far...I think.


Extras: Filter Print Post Top
Re: Pastywhyte’s Ez dialed monos (moved) [Re: makomeyer]
    #27762560 -

makomeyer said:
Do yall tape the side and/or top holes during colonization with this tek, then pull the tape off to introduce fruiting conditions? I'm 4 days in, first time using this tek, and I taped the three holes on each of the long sides, but left the 5 holes on each of the short sides open. Things are smelling and looking good so far...I think.





Nope, says right in the original post to go straight to fruiting. Ive been getting pins in 8-10 days on avg with straight to fruit.

Extras: Filter Print Post Top
Re: Pastywhyte’s Ez dialed monos (moved) [Re: GhostHustler]
    #27762583 -

If your using the same tub as pasty perhaps. All depends on your specific conditions though. I like to put a layer of mp on all holes and then open her up when I see pins. Just personal preference though I think.

Pretty sure Pasty designed it to just be left as is from spawn to harvest though but you know people are gunna play :heytheresexy:

Extras: Filter Print Post Top
Re: Pastywhyte’s Ez dialed monos (moved) [Re: SwabMarley]
    #27763491 -

My sub doesn't seem to be fully colonized around the bottom holes does this look alright? Still very much a noob here



--------------------
Good judgment comes from experience. Experience comes from bad judgment.

Extras: Filter Print Post Top
Re: Pastywhyte’s Ez dialed monos (moved) [Re: Charliethebum]
    #27763517 -

There is colonization,
but it´s getting dry from the holes.
Too much air exchange up to your environment.
Tape holes up with micropore.

        :cookiemonster:


--------------------

Extras: Filter Print Post Top
Re: Pastywhyte’s Ez dialed monos (moved) [Re: Charliethebum]
    #27763533 -

Charliethebum said:
My sub doesn't seem to be fully colonized around the bottom holes does this look alright? Still very much a noob here





It’s colonized but drying out. Those holes look to be far too low. I suggest in the OP to have them at 5” up assuming a sub of around 12-15 quarts and about 4 quarts spawn. That provides at least 2” of clearance for the sub below the holes. Alternatively drilling the holes too low is just as detrimental to the performance and will make for a sub optimal tub design. This is not really optional,  this design demands 2” clearance.

Extras: Filter Print Post Top
Re: Pastywhyte’s Ez dialed monos (moved) [Re: Pastywhyte]
    #27763572 -

I like to put the side holes smack dab in the middle of the tote.


--------------------
weed gets you through times of no money better than money gets you through times of no weed...  -the fabulous furry freak bros
If you can buy it, you can burn it!



https://www.shroomery.org/forums/showflat.php/Number/25947396#25947396

Extras: Filter Print Post Top
Re: Pastywhyte’s Ez dialed monos (moved) [Re: TedsDead]
    #27763578 -

I should maybe say it demands a minimum 2” clearance :lol:

Extras: Filter Print Post Top
Re: Pastywhyte’s Ez dialed monos (moved) [Re: Pastywhyte]
    #27763604 -




Aw hell guess that's what I get for not following directions properly. Thanks for the response guess I'll just e tape the lower holes and re drill them higher up


--------------------
Good judgment comes from experience. Experience comes from bad judgment.

Edited by Charliethebum (05/05/22 08:19 PM)

Extras: Filter Print Post Top
Re: Pastywhyte’s Ez dialed monos (moved) [Re: Charliethebum]
    #27779574 -

I just want to say I think this is the way to go. Both tubs filled in thick!!! I really did not have to do much at all thoughout the whole process. The first two weeks I had tape over 10 of the 18 holes. The sides of the bins stayed humid/wet. The surface conditions stayed prime with hundreds of little droplets. Once it pinned I removed most of the tape leaving the two lower end holes covered.Another week and full flat canopy of healthy B+ and Z.

I ended up putting my RustyWhyte in a dubtub similar sized footprint as the 66qrt but not the height. I had two bins sitting around and did not want to drill in these as not sure if the method would work with only a couple inches from top of substrate to lid. I'll probably just open it up a little once it pins for FAE and just have a little more babysitting to do to maintain good surface conditions. Looking good so far.

Extras: Filter Print Post Top
Re: Pastywhyte’s Ez dialed monos (moved) [Re: Maphead]
    #27780024 -



Just wanted to say thx Pasty! you are the man!  Some White Rabbit...

Extras: Filter Print Post Top
Re: Pastywhyte’s Ez dialed monos (moved) [Re: LunarFoxx]
    #27780139 -

LunarFoxx said:


Just wanted to say thx Pasty! you are the man!  Some White Rabbit...



This isn't your first grow, is it? :lol:

That's a great tub.


--------------------
Being pissed on does not make you a real man.

...OR DOES IT?

Extras: Filter Print Post Top
Re: Pastywhyte’s Ez dialed monos (moved) [Re: Guerrilla]
    #27780296 -

pretty close,  started about 8 months ago and have had a few really good ones and now they are all looking like that thx to this tek

Extras: Filter Print Post Top
Re: Pastywhyte’s Ez dialed monotubs [Re: Pastywhyte]
    #27801883 -

:takingnotes:

Extras: Filter Print Post Top
Jump to top Pages: < First | | 66 | 67 | 68 | 69 | 70 | 71 | 72 | 73 | 74 | 75 | 76 | 77 | 78 | 79 | 80 | 81 | 82 | 83 | 84 | 85 | 86 | | Last >

Shop: Original Sensible Seeds Bulk Cannabis Seeds   Mushroom-Hut Substrate Mix   Sporeworks.EU Spores for European Microscopy   North Spore Bulk Substrate   MagicBag.co All-In-One Bags That Don't Suck


Similar ThreadsPosterViewsRepliesLast post
* bulk monotub grow without pasteurizing at home? pong 801 1 04/09/10 01:51 AM
by pong
* 3 Odd tubs, help define the action plan Huskies 62 2 09/02/26 09:45 AM
by Huskies
* Planning a first grow (cambodian in monotub) thizzness 9,174 14 04/12/09 07:01 PM
by FellowGrower
* Using a Cool Mist with a Monotub?
( 1 2 all )
M11 7,495 29 12/21/23 03:59 PM
by Screwup
* Ovoids in monotubs question Auphex 88 1 09/01/26 04:26 PM
by langten69
* The Monotub Bag Colonization Thread
( 1 2 3 4 ... 15 16 )
faceyneck 41,562 313 07/17/19 09:00 PM
by Spiritualscience
* What do you use? Polyfil or Micropore for Monotub.
( 1 2 3 all )
large_dose 20,441 51 06/21/19 11:36 PM
by Crackatoa
* one mushroom monotub?
( 1 2 all )
Electric305 4,208 20 06/01/09 08:46 AM
by Electric305

Extra information
You cannot start new topics / You cannot reply to topics
HTML is disabled / BBCode is enabled
Moderator: Shroomism, george castanza, RogerRabbit, veggie, mushboy, fahtster, the_chosen_one, LogicaL Chaos, 13shrooms, hamloaf, cronicr, Stipe-n Cap, Pastywhyte, bodhisatta, Tormato, Land Trout, A.k.a
182,922 topic views. 11 members, 384 guests and 165 web crawlers are browsing this forum.
[ Show Images Only | Sort by Score | Print Topic ]
Search this thread:

Copyright 1997-2026 Mind Media. Some rights reserved.

Generated in 0.032 seconds spending 0.012 seconds on 18 queries.