Home | Community | Message Board


MRCA Tyroler Gluckspilze
Please support our sponsors.

Mushrooms, Mycology and Psychedelics >> Mushroom Cultivation

Welcome to the Shroomery Message Board! You are experiencing a small sample of what the site has to offer. Please login or register to post messages and view our exclusive members-only content. You'll gain access to additional forums, file attachments, board customizations, encrypted private messages, and much more!

Amazon Shop for: ½ Pint Jars, Agar, Malt Extract, Petri Dish, Pressure Cooker, pH Test Strips

Jump to first unread post. Pages: 1
Offline13375C0R3
Stranger
Registered: 08/20/01
Posts: 20
Loc: Edmonton
Last seen: 14 years, 8 months
H202 in Substrate
    #388116 - 09/07/01 06:27 PM (15 years, 3 months ago)

Hello all,

I'm kind of new at this, I'll be inoculating for the first time tommorow and I understand from reading posts here for a while that h202 is fairly effective at preventing contams. I know that it is usually added to the water in the terrarium but I was also wondering if it is okay or wise to add it to the water that is being mixed into the substrate before innoculation? Will this ward off contams or just make it impossible for the spores to grow/survive?

Thanks all
-Liam P



Post Extras: Print Post  Remind Me! Notify Moderator
Invisibledimitri211
Carpal Tunnel
Registered: 04/27/01
Posts: 2,248
Re: H202 in Substrate [Re: 13375C0R3]
    #388119 - 09/07/01 06:31 PM (15 years, 3 months ago)

NO here is something that someone posted NOT ME this should help you out.

Author Topic: Peroxide Agar Tek
mycofile
GateKeeper
Posts: 1194
Registered: Mar 2000
posted 05-05-2000 07:19 PM
--------------------------------------------------------------------------------
Just thought more people might need to be reminded of this tek. I works wonders! This was a post written by placebo, and commented on by me (mycofile).
First of all, let me begin by saying that this is not my tek, and I'm not taking credit for it. As far as I know, the credit belongs to Dr Rush Wayne. Check out his website. If you find this information useful, and/or would like to find out more about the uses of peroxide in mushroom cultivation, please consider buying his manual.
I've noticed a few people lately asking about agar. I find it very useful and recommend that everyone give it a try. Most people are turned off of agar because of fears of unavoidable contamination problems. I've found that with the use of hydrogen peroxide in my agar mix, I can do transfers in the open, unfiltered air with little worry of contamination.

Many people seem a bit confused as to what peroxide can and can not do. Hydrogen peroxide will kill bacteria and fungal spores and inhibit the growth of yeasts. Unfortunately, mushroom spores fall under the category of fungal spores, so they will not germinate on peroxidated agar because they are killed on contact. The good part about this is that mold spores, such as spores from the dreaded green mold, fall under this category as well and are also killed upon contact with the agar surface. What will grow on peroxidated agar is existing fungal colonies, such as your living mushroom mycelium, because their cells can produce enzymes that will cause the peroxide to be broken down into water and oxygen. The downside, however, is that existing colonies of some molds, such as green mold, are also capable of producing these enzymes, so peroxide will not guard against mold spores that have already germinated. But perhaps the best attribute of peroxide is that it will kill all bacteria, so you will never have a problem with bacterial contamination on peroxide enriched agar.

Enough with the background information already... Tell me how to do it!

First you need to get a hold of some light malt extract powder and some agar agar. Malt extract can be found at your local wine and beer brewing store, and agar agar can be bought from Fungi Perfecti, among other places. You also need some petri dishes, also available from FP, or you can pour your agar into empty jars instead of plates if you prefer. Next, mix three grams of malt extract and three grams of agar (or, if you bought them pre-mixed, six grams of the mix) with 149 ml of water (you should use 149 ml instead of 150 because you want to account for an extra ml of peroxide that you will be adding later). I measure out my water with an empty syringe, keeping in mind that one cc is the same as one ml. I mix and sterilize this solution in a half pint jar, because the amount of agar solution is right for that size jar and because the size of the jar fits well in the pot that I use for sterilizing it. It works for me, but it is not ideal for pouring and I'm sure a better substitute could be found. Anyway, close up your container of agar and sterilize for 45 minutes. I sterilize mine by letting it sit in boiling water in a covered pot, but you could use a pressure cooker if you wanted to. While it is sterilizing, thoroughly clean your plates if you haven't already done so, and stack them on a tabletop. As soon as is possible without burning yourself, move the jar of molten agar to the tabletop, open the lid, and insert a clean thermometer into the agar. Sine hydrogen peroxide decomposes at 140 degrees fahrenheit, you need to let the temperature of the agar drop below that before you add the peroxide. Otherwise it will decompose into water and oxygen and be effectively useless. This is why the peroxide is added after sterilization. I have found that my agar begins to solidify at around 120 degrees fahrenheit, so fill a syringe with peroxide and when the temperature falls to 130 degrees, add one ml to the molten agar and stir it in with the thermometer. Then remove the thermometer and pour your plates, stacking them as you go. I can usually pour nine or ten plates with this amount of agar. If you want to make a larger or smaller amount, simply adjust the amounts of water, agar, malt, and peroxide, keeping all the ratios the same.

A good idea would be to order some antibiotic agar from FP to use for germinating spores. This stuff, while resistant to bacteria, is still susceptible to contamination by mold and yeast, so don't forget to use the proper sterile techniques (like a glove box, bleached down room, or a warm oven). Once the spores germinate, the mycelium can be transferred to peroxidated agar with less of a stress on sterility. It is important to remember to keep your scalpels clean and to thoroughly clean and sterilize your plates prior to pouring! If there are small mold colonies left in the plates when you pour them, they will be resistant to the peroxide and will grow.

Commentary added by mycofile 5-5-2000: A range of H2O2 concentrations is acceptable. cubensis seems to tolerate amounts ranging from 1 ml to 7ml for this mix. The more you use, the longer "adjustment" period for mycelium to adapt to the peroxidated agar. As a general rule, the least amount necessary is best. But since your mileage may varry, you may modify as to what works for you.

I have personally used the original formula to make plates that were left unsealed and unfiltered in a nasty NASTY kitchen for up to 2 weeks until they dried out. The agar never contaminated!


------------------
From a registered Mad Scientist (tm)

"From a certain point of view"
-Jedi Master Obi-Wan Kenobi (also a registered mad scientist tm)

[This message has been edited by mycofile (edited 05-05-2000).]


Jon Hash
Psychedelic Affiliate
Posts: 119
Registered: Apr 2000
posted 05-10-2000 01:18 PM
--------------------------------------------------------------------------------
wouldent the peroxide arrest the growth of mycelium or at least slow it down

placebo
Munchkin
Posts: 7
Registered: May 2000
posted 05-10-2000 02:21 PM
--------------------------------------------------------------------------------
Hey mycofile! This is my first visit to this board, and I like what I see. I thought this thread would make for a good first post, since I wrote most of it.
I highly recommend the use of agar to everyone with an interest in cultivation. Using peroxide makes agar work easy enough for beginners.

Jon Hash: There tends to be a "recovery period" that the mycelium goes through when transferred to agar containing peroxide, especially after the first transfer. The mycelium is slow during this recovery period, as it is building up the enzymes needed to break down the peroxide so it can digest the malt (in MEA). After that, the mycelium quickly picks up speed and grows just as quickly as it would if peroxide were not present. I've found this recovery period to usually last only a day or two.

[This message has been edited by placebo (edited 05-10-2000).]


Jon Hash
Psychedelic Affiliate
Posts: 119
Registered: Apr 2000
posted 05-17-2000 11:09 AM
--------------------------------------------------------------------------------
but if the mycelia destroyed the peroxide wouldent the agar be contaminant prone again ?

mycofile
GateKeeper
Posts: 1194
Registered: Mar 2000
posted 05-18-2000 09:30 AM
--------------------------------------------------------------------------------
No, once the mycelium has grown, it itself will not contaminate. The mycelium only destroys the peroxide in the agar it is groing on. The agar not right next to the mycelium will still be protected until the myc gets there.
Don't you trust us? I said it works perfectly, try it and you will see.


Dr Bluethumbs Old School Toadstools
----------------------------------------------
LILSHOPOFSPORES
THEHAWKSEYE


Post Extras: Print Post  Remind Me! Notify Moderator
Offline13375C0R3
Stranger
Registered: 08/20/01
Posts: 20
Loc: Edmonton
Last seen: 14 years, 8 months
Re: H202 in Substrate [Re: dimitri211]
    #388124 - 09/07/01 06:42 PM (15 years, 3 months ago)

okee doke
that was alot of info

Thanks Alot for the speedy reply dude

-LP




Post Extras: Print Post  Remind Me! Notify Moderator
Offlinetchyted
miestro
Registered: 09/03/01
Posts: 526
Loc: WA near seattle
Last seen: 2 years, 2 months
Re: H202 in Substrate [Re: 13375C0R3]
    #388478 - 09/08/01 02:59 AM (15 years, 3 months ago)

i bought R. Rush Wayne, Ph.D's papers from him. best investment in growing stuff ever. I also second the above. i had serious contam problems before use of Dr Waynes methods



Post Extras: Print Post  Remind Me! Notify Moderator
Jump to top. Pages: 1

Amazon Shop for: ½ Pint Jars, Agar, Malt Extract, Petri Dish, Pressure Cooker, pH Test Strips

Mushrooms, Mycology and Psychedelics >> Mushroom Cultivation

Similar ThreadsPosterViewsRepliesLast post
* No vermiculite! Substrate, peroxide and sterility? shaganoz 1,310 1 05/11/02 06:05 PM
by Anno
* Can I add certain % Peroxide to substrate mix? Numba9 4,118 5 08/23/01 11:31 AM
by shellacct
* misting casing w/ H202 jimsuzo 1,030 3 08/14/02 05:59 AM
by Anno
* Hydrogen Peroxide?
( 1 2 all )
o0brandnewcolony 1,693 24 02/17/05 07:18 AM
by Damn_Skippy
* H202 hurts cakes? Moxemerald 1,197 17 10/31/04 11:27 PM
by scatmanrav
* Hydrogen Peroxide growing in non sterile conditions Armageddon 2,705 4 01/18/05 04:42 PM
by Mig
* Rinsing in H202 better than soaking? donkey_lipz 514 7 08/24/04 04:52 PM
by Bi0TeK
* barley straw as substrate? water+barley straw produces H202 arp180 471 1 11/03/08 11:24 PM
by arp180

Extra information
You cannot start new topics / You cannot reply to topics
HTML is disabled / BBCode is enabled
Moderator: Magash, Shroomism, george castanza, Prisoner#1, RogerRabbit, Citric, total, FooMan, 13shrooms, stonesun, EvilMushroom666, cronicr, PussyFart
835 topic views. 13 members, 79 guests and 28 web crawlers are browsing this forum.
[ Toggle Favorite | Print Topic | Stats ]
Search this thread:
Sporeworks
Please support our sponsors.

Copyright 1997-2016 Mind Media. Some rights reserved.

Generated in 0.068 seconds spending 0.004 seconds on 14 queries.