Auto-SummaryThe author, Joe Momma, conducted an experiment to investigate the effect of rye seed germination time on the growth rate of Pleurotus ostreatus mycelium. The experiment involved germinating rye seeds for 0, 12, 24, 36, and 48 hours and then using the resulting grains to create "cakes" that were inoculated with a liquid culture of the mycelium. The results showed that the longer the seeds were germinated, the less growth was observed in the mycelium, contradicting the author's initial hypothesis that the longer germination time would lead to better growth. The author suspects that the presence of endospores in the seeds may be the cause of the contamination and slower growth in the 12 and 48-hour groups. The experiment also highlighted the importance of proper sterilization techniques, as the 12-hour group was contaminated, while the 0-hour group, which was not germinated, showed the best growth. The author plans to conduct further experiments to confirm these findings and to explore the effects of hormones and pressure cooking on mycelium growth.
The project changed some due to time restraints but will be ongoing.
FIRST LEGIT LAB REPORT... any pointers? there are standard deviations and graphs but dont want to do the work to get them on here.
The effect of seed germination time on the growth rate of Pleurotus ostreatus mycelium.
By: Joe Momma
Abstract: The main idea of this experiment is to find out if germination time of rye seed has any effect on Pleurotus ostreatus mycelium. The results were: the longer the germination time, the less growth. This could be due to more endospores being germinated and hindering growth rates. This could be that more PGR’s hinder growth of mycelium. More testing needs to be done to rule out the endospores and the hormones. That will prove it has to do with starch being converted into simple sugars. 0hr Group: Jar1 - 9.5cm, Jar2 – 9.5cm, Jar3 – 9cm, Jar4 – 9cm. (90-95% colonized in 10 days) 12hr Group: Jar1 - 2cm, Jar2 – 2cm, Jar3 – 1.5cm, Jar4 – 1cm. (10-20% colonized in 10 days) 24hr Group: Jar1 – 9cm, Jar2 – 9cm, Jar3 – 8.5cm, Jar4 – 8cm. (90-80% colonized in 10 days) 36hr Group: Jar1 - 8cm, Jar2 – 7.5cm, Jar3 – 7.5cm, Jar4 – 7cm. (80-70% colonized in 10 days) 48hr Group: Jar1 – 7.5cm, Jar2 – 7cm, Jar3 – 6.5cm, Jar4 – 6.5cm. (75-65% colonized in 10 days)
I am interested in mushroom production because it is a hobby of mine that I started a few years ago. This experiment will possibly help me speed up the time it takes from inoculation to fruit. My hypothesis is that the group that soaks the longest will perform the best. The foundation of this experiment is that seeds are dormant in the absence of water. When hydrated, seeds will produce hormones like gibberellins, auxins, cytokinins. These hormones will induce the production of enzymes like a-Amylase which cause the carbohydrate starch nutrition of the endosperm in the seed to be broken down into more simple sugars, which will be converted into energy that will be devoted to growth. The hormones of the seeds might affect the vigor of the mycelium. The conversion of the carbohydrate starch to more simple sugars also might affect the vigor of the mycelium. Less time soaking the seeds = more starch and less hormones. More time soaking = more simple sugars and more hormones. The presence of enzymes is irrelevant because they are proteins, and will readily denature with heating. Unfortunately, the hormones will also degrade with heat, but not as readily as the proteins so it was crucial to apply the minimum amount of heat necessary for sterilization. The main purpose of this experiment was to see if I could find the optimal germination time of rye seed for Pleurotus ostreatus mycelium growth rates.
Methods & Materials • 1/2pint mason jars with lids • Hammer/nail • 5 plastic “shoe” box’s • Strainer/bowl/pot with lid/baking pan • Paper towels/foil • Measuring cups • Rye grains • Oven/stove • Fan • Blender • Vermiculite • Gypsum (drywall) • Liquid culture (Pleurotus ostreatus) • Permanent marker • 91% rubbing alcohol • Candle • Glove box (still air box) • Incubation chamber • 10-14 days
Read completely before starting.
STEP ONE – Germination I germinated rye seed for 0, 12, 24, 36, and 48 hours in water soaked paper towels at 75F. The rye grains were measured out one cup per group. Each group needs rinsed in a strainer for 5 minutes to remove any dirt then drained for 5 minutes to remove excess water. The paper towel was laid in the bottom of a plastic “shoe box” container. The grains were dumped on top of the paper towel then spread out to a depth of 1cm. The rest of the paper towel was laid on top of the grains and the water (2/3 cup) was added, then the lid was placed on the container. The lid should not be air tight because the lack of oxygen will cause the grains to become anaerobic and possibly die. Group 0 hours grains were placed immediately into the room temperature baking pan that was then placed in an already pre-heated 210F oven for 20 minutes. This is done to stop enzyme activity and halt germination. After 20 minutes the grains were placed in front of a fan for 12 hours to cool and remove any moisture in the grains or on the grains. When the 0 hour group is done under the fan they were taken to the blender and set on grind for 5 minutes. The 12 hour group will now be ready to go in your already 210F pre-heated oven for 20 minutes. After 20 minutes, place the grains in front of the same fan on the same speed setting for 12 hours. Keep doing this process/cycle until you have baked all 5 groups and all 5 groups have been dried by the fan then ground. Remember to keep each group labeled so you don’t get the germination times mixed up. You will also need to be preparing “cakes” immediately after their done in the blender.
STEP TWO - Cakes You will need to prepare your 0 hour group immediately after they are done in the blender. You do this by mixing together 2 cups of vermiculite and one teaspoon of gypsum in a mixing bowl. This is done to keep the gypsum from clumping together and not mixing properly. Add 1 cup of water and mix the vermiculite/water/gypsum together. After mixing thoroughly you need to add 1 cup of your ground up rye grains. Mix the rye “flour” for about a minute into your vermiculite/water/gypsum. This is done last to keep the rye flour from clumping together. Spoon the mixture into 1/2pint canning jars. Leave about ½ inch of the jar empty at the top, you will be putting straight vermiculite in this top ½ inch to act as a contamination barrier. Make sure to wipe any of the mixture off of the glass if there is any before adding your dry vermiculite, this can lead to contamination if it is left there. Place the lid on the jar and label it 0hr: jar 1. Do this 4 more times so you have 4 labeled jars with the mixture in them and dry vermiculite on top of the mixture. You want to take a hammer and a nail (bigger than needle) and puncture 4 holes into your lid very close to the outside edge. These will be used later to inoculate the cakes. Place foil on the lid so it covers the lid completely leaving the bottom half of the jar uncovered. This is to keep moisture from getting in your jars when you steam sterilize them. Repeat for other groups.
STEP THREE – Steam Sterilization Take a pot big enough for all 4 jars with a lid and place a few paper towels in the bottom of the pot. Put your jars in the pot on top of the paper towels and add room temperature water so it comes up 1/2 of the jars height. Turn the stove on high and place the lid on the pot. Once the water starts to boil, turn the stove down to medium and start a timer. You want the water to continue boiling but not a “rolling boil”. Keep this boil for 90 minutes. Remember the placement of your boil setting, you will need to use the same setting for the other groups. After the 90 minutes is over place the pot by a fan to aid in cooling the jars. Repeat for other groups.
STEP FOUR – Inoculation and incubation I used an isolated strain of liquid culture to inoculate my jars. I used a still air box that was cleaned with 91% rubbing alcohol. Each jar was wiped down with alcohol then placed in the still air box. Shake your syringe to evenly distribute the liquid culture. The needle was flame sterilized then wiped with an alcohol soaked pad, do this between each jar. Inoculate each hole in each jar with 1cc of liquid culture for a total of 4cc of liquid culture per jar. Try to keep the needle under the dry vermiculite layer and close to the glass when you inject the culture. Place the jars in an area that will maintain a constant temperature. This temperature can be 75-80F but should not fluxuate. This area should not receive any light to remove the variable of light intensity and light hours effecting the growth of the mycelium. After 10 days of incubation you are going to want to record the amount of growth. I picked 10 days because I did not want them all to be 100% colonized. Jars are 10cm tall. Measure growth per 0.5cm.
PROCESS OF START/FINISH (11am – 11pm) Day 1 0hr group bake > fan (12hrs) Night 1 0hr group boil > fan (12hrs), 12hr group bake > fan (12hrs) Day 2 0hr group inoculated, 12hr group boil >fan (12hrs), 24hr group bake > fan (12hrs) Night 2 12hr group inoculated, 24hr group boiled > fan (12hrs), 36hr group baked > fan (12hrs) Day 3 24hr group inoculated, 36hr group boiled > fan (12hrs), 48hr group baked > fan (12hrs) Night 3 36hr group inoculated, 48hr group boiled > fan (12hrs) Day 4 48hr group inoculated Day 12 0hr group growth measured Night 12 12hr group measured Day 13 24hr group measured Night 13 36hr group growth measured Day 14 24hr group measured
Results 0hr Group: Jar1 - 9.5cm, Jar2 – 9.5cm, Jar3 – 9cm, Jar4 – 9cm. 12hr Group: Jar1 - 2cm, Jar2 – 2cm, Jar3 – 1.5cm, Jar4 – 1cm. (CONTAMINATED) 24hr Group: Jar1 – 9cm, Jar2 – 9cm, Jar3 – 8.5cm, Jar4 – 8cm. 36hr Group: Jar1 - 8cm, Jar2 – 7.5cm, Jar3 – 7.5cm, Jar4 – 7cm. 48hr Group: Jar1 – 7.5cm, Jar2 – 7cm, Jar3 – 6.5cm, Jar4 – 6.5cm. (Possible contaminates) I am positive the 12 hour group contaminated. I do not know why it contaminated but I believe it has something to do with germinating the endospores. The 48hr group also had a funky smell coming from the jars but the mycelium looks very healthy. I need to run more experiments under these same conditions and see if the same things happen to 12 and 48. The results were the total opposite of my hypothesis. I didn’t think any of the 0hr group had a snowballs chance in hell. Mainly because in my mind not soaking the grains would not germinate any endospores in the grains. I thought this would be the first to contaminate but it looks like, not giving the endospores any germination time when steam sterilizing is a benefit. I also want to see how each group performs under fruiting conditions. This will be my next experiment with these cakes. I will compare fruit weight of each group. I also want to determine if the hormones have any effect on the growth by pressure cooking the grains instead of steam sterilizing them. The differences in growth may or may not have anything to do with PGRs. Pressure cooking the grains at a high temperature should destroy or alter most of the hormones.
References: Gumba, Mycelio, and Rammy of Shroomery.com for helping me design the experiment and giving me ideas.
http://www.mathsisfun.com/data/standard-deviation-calculator.html
www.shroomery.com
-------------------- "In order to be a leader, you must FIRST be a follower!"
"Emancipate yourselves from mental slavery, None but ourselves can free our minds."
"Don't gain the world and lose your soul, Wisdom is better than silver and gold"
Edited by CorrosiveLiquid (12/01/11 02:36 AM)
|