Auto-Summary
The post describes the author's setup for maintaining high humidity (90-95%) and a consistent temperature (72°F) in their greenhouse using a Repti Fogger, R-Zilla 500 Watt Temperature Controller, Precision Hair Hygrometer, and a ceramic space heater. The fogger is controlled by a specialized timer that allows for shorter off periods, preventing water droplets on trays and shelves. The hygrometer and thermostat are placed inside the greenhouse for accurate readings and to prevent condensation. The setup is designed to be cost-effective, with links provided for purchasing the products at affordable prices.
Here are some pics of one of my greenhouses with the fogger, thermostat and hygrometer...it stays at a perfect 90-95% humidity and 72 degrees F all the time with no water droplets on trays, shelves, etc. I have four 4" square holes cut into the greenhouse for FAE (besides the FAE offered by the fogger).
I use the "Repti Fogger" from Zoo Med and the "500 Watt Temperature Controller" from R-Zilla with a ceramic space heater from amazon along with the "Precision Hair Hygromiter" from HAAR. ALL electronics are plugged into a grounded 16gauge surge protector and I have the space heater on a separate surge protector and circuit for additional safety. I run the fogger with a special 'repeat cycle timer' which offers off time as short as one minute! A big problem I have with all other cycle timers is they offer an off time of 5 minutes which is too long in my situation. Besides, I prefer finer grained control...
I tried using an impeller cool-mist (Vics 420) but it could not keep the humidity over 90% WITHOUT covering the greenhouse in water droplets. I keep the RH in the room around 50-60%. I live in an area where it gets fairly cold and arid in the winter. It is hard to keep humidity high (90-95%) in the greenhouse without keeping the RH of the room over 50%. I use a few impeller cool mists in the room running on a repeat cycle of 15 min on and 15 min off.
- I am not listing the greenhouse I use because you can use these directions on any type of FC. Be it a 'Martha' or a real greenhouse like the one most of us use (from Target).
- The links I offer for the products are some of the least expensive prices I found. BigApple Pet supply also has very good prices on all products I am listing (except the hygrometer in both cases).




...
Repti-Fogger:
It has a dial which adjusts the amount of fog emitted and a 1 liter reservoir bottle. I switched out the 1 liter bottle for a plastic 2 liter soda bottle. This way I can go out of town for a few days...

Thermostat:
EDIT:
I am ordering a different thermostat than the one listed below and in the pics. There is an issue with wattage, the R-Zilla thermostat can only handle 500watts. So I need a thermostat which is rated higher. I am going to use the Ranco HERE ($49.00), it requires very minor wiring to a low gauge cord. When I get my Ranco I will updated this thread with pics and a how-to for wiring it (it's minor). Later in this thread RogerRabbit and stealthc tell me how I am in danger of a fire and they are serious. So don't' buy the R-Zilla. I am goign to buy the Ranco but RogerRabbbit also listed another good option in place of the R-Zilla. I am leaving the info/pics of the R-Zilla as it was, otherwise a few posts in this thread would not make sense.This is neat and fairly inexpensive. It turns OFF a heat source once a preset temperature is reached. A big problem for some greenhouses is condensation on the walls due to temperature variation inside/outside the greenhouse. My fix for that is to put the thermostat sensor INSIDE of the greenhouse, now I have no condensation. This offers two additional benefits which help you save money:
- I keep my house thermostat at 68 degrees F all winter but we need greater than 70 degrees for p.cubensis. By using the R-Zilla thermostat connected to the space heater I can ONLY heat the room where I grow mushrooms.
- By placing the thermostat sensor inside the greenhouse it allows the heater to run less while the lights are on. I have two, 2' fluoros which provide a little heat (about 1 degree). The heat from the lights is used by the thermostat senor so my room temp is 69-71 F and greenhouse temp 72-73 F while the lights are on. When the lights are off the room temperature and greenhouse temperature are the same: 72 F.
Repeat Cycle Timer:Like I mentioned, I prefer this timer because it offers a very short off time of one minute. I like having finer grained control as I can tweak the time settings to prevent water droplets from build up in the greenhouse.
- ($85.00) HERE
(Scroll to bottom of page)
Hygrometer:There are many crappy hygrometers out there and only a few 'types' are trustworthy. Hair (either human or synthetic) are the most accurate. Some people like sling hygrometers but they rely too much on the skill of the user for accuracy. If you spend less than $30.00 you have a crappy hygrometer (unless it's used, etc).
- +/-5% RH ($34.00) HERE
(I use that one ^^ and I LOVE IT! Very, very accurate and easy to calibrate. Also the least expensive 'good' hair hygrometer I found.)
- +/-4% RH ($66.00) HERE
- +/-3% RH ($172.00) HERE
(This is the industrie's best as far as I know, its an Abbeon. It even comes calibrated with a certificate of calibration!)
Ceramic Space Heater:I use a Lesko space heater model "754200" from amazon. I set it to 90 degrees F (turn the dial half way) so whenever the R-Zilla thermostat turns on the space heater the space heater will produce heat.
EDIT:
The following info is no longer relevant once I have the Ranco. This info is about the R-Zilla thermostat.One thing to note is I keep the space heater on the low setting but even that draws 900watts. The thermostat is only rated for 500watts so I am overloading the thermostat a little but I have not noticed any ill effects (like wire heat, etc).
...All told it will cost you about $210.00 (no including shipping) to buy all the products I listed (no including greenhouse)...HTH-goose2r