I've had mixed success with my first batch. First I had 5 PF cakes in 1/2 pint jars in a transparent plastic container. From them I got about 9 grams of dried goodies. I was hoping for 17.5, but not that bad for a first try, right? The problem is that I think the humidity was too high. There was always condensation on the sides of the container, even if I didn't spray. In fact I didn't spray very much at all. My question is was that bad? I figure if I can see the water on the side the humidity id pretty dam high, right? But my stuff seemed pretty much on the small side and there were many aborts. There were a lot of good ones, but a few seemed very squishy almost like they were starting to rot. Most of the larger one seemed to have problems supporting their own weight and when I went to get spores from one it completely tipped over. I can say I wasn't very careful about sterilization at that point but I wasn't foolish either. Many of the squishy ones had a dark center. Any ideas? Contamination?
I had originally made eight jars but only five fit into the container well. I wasn't too worried about the other three since this was just a test run. However after the first 5 I tried to see if I could do something with the rest. Now these jars were old - 3 to 4 months old. And one of them had what look like contamination even though is was probably just one that grew smashed up against the jar and got wet. Anyway the other too looked un-contaminated.
I broke these up on water saturated perilite that was baked in an oven covered with foil at 250 F for an hour (then cooled of course). This was set about a day and a half covered until the mycelium started to grow (wow its still alive). Then sterilized (pressure cooker 15 psi 25 mins) and cooled perat moss / vermiculite (1:1) was placed on top of the broken cakes. Everything looked good - Mycelium growth followed by pinning everywhere. I was very happy, but that was it. They all look aborted. The largest abort (1-2 cm) was picked after about a week after I noticed it and was very water logged, squishy, and dark on the inside.
Now I know these cakes were old, did that have something to do with it? I know you're supposed to have very high humidity, but could it be too high? I only say that because they almost seem to be drowning. At first I'd air out and spay about one daily but a good amount of water pooled under the pan holding the casing (large drops not completely covered). I didn't spray as much but continued to air once a day. Condensation was always present on the sides.
Anyway if any of you experienced people have some ideas or comment I would appreciate it. I'm going to have someone start my second batch and well I don't want to F it up.
Shroomadude
P.S. Also, the light I've been using is mostly indirect natural light. Does it help to keep the light on 24 hrs.? Direcly above or is indirect okay?
|