|
Some of these posts are very old and might contain outdated information. You may wish to search for newer posts instead.
|
Jon
Registered: 06/28/03
Posts: 961
Last seen: 9 years, 1 month
|
DMT extraction tek 1
#5263533 - 02/04/06 05:56 PM (17 years, 11 months ago) |
|
|
I remember running into an extremely simply DMT pictorial/tek that used very few steps, and excluded the use of HCL acid. The only ones I am able to find are the ones that require sodium carbonate and HCL acid. Can anyone help me out? I think im pretty much fed up with the search function.
|
muistrue
Inspired by the mystery


Registered: 03/20/05
Posts: 12,899
Loc: Behind the Redwoods
|
Re: DMT extraction tek [Re: Jon] 1
#5263546 - 02/04/06 06:03 PM (17 years, 11 months ago) |
|
|
Here's Marsofold's tek which is well known for being very simple and producing a clean product. Hope you find it useful. 
Amazing simple clean DMT extraction How to easily extract DMT: ======================= Break 1-Pound of Mimosa Hostilis rootbark into 2" pieces and grind it all up in a glass-topped blender, a little at a time. ------------------------------------ Polar Extraction: Premix in an empty 1-Gallon plastic jug: 1-Quart White Vinegar & 3-Quarts Water. Put the ground up Mimosa in a 3-Liter crockpot, then fill it with the water-vinegar solution. Stir well and turn it on "high". After 2 hours, remove the crockpot ceramic liner, hold the lid on slightly offset, and pour off most of the liquid into a 1-gallon wide-mouthed glass or stainless container. Add the remaining water-vinegar solution to the crockpot again. Stir well and turn it on "high". After 2 hours, remove the crockpot ceramic liner, hold the lid on slightly offset, and pour off all of the liquid into the same container again. Discard the rootbark fiber and save the two combined extractions in the 1-gallon container. Allow the vegetable particles in the extraction in the 1-gallon container to settle to the bottom overnight. Then pour off the liquid into an empty 1-Gallon glass wine jug, being careful not to pour off any of the vegetable sludge at the bottom. Discard the sludge and keep the contents of the wine jug. ------------------------------------ Basification: Premix in advance a solution of: 5 Tablespoons (63grams) of Sodium Hydroxide ("Red Devil" lye) with 1-Pint of WARM Water. Stir well. Slowly add this solution to the wine jug, then cap the jug. Gently tilt the wine jug back and forth for 1 full minute to mix the contents. ------------------------------------ Nonpolar Extraction: Add 250ml of (Ace Hardware)VM&P Naptha to the wine jug. Add exactly enough warm water to the jug to raise the liquid level to an inch below the top, then cap the jug. Gently tilt the wine jug slowly back and forth for 5 full minutes to mix the contents. Allow the jug to sit undisturbed on a table for at least 4 hours. There should now be two layers visible in the jug, a lower dark one and a smaller clear one on top filling the neck of the jug. Use a glass turkey baster to suck up the top clear layer into a pint mason jar. Be careful not to suck up any of the lower brown/black layer into the mason jar. ------------------------------------- Freeze-precipitation/wash: place the sealed mason jar in a FREEZER for 3 days to precipitate the crystals. Prepare a filter setup by placing a funnel into a quart mason jar and putting a small coffee filter paper into the funnel. Shake the naptha in the mason jar strongly to stir up all the crystals at the bottom and quickly pour while still very cold into the funnel for filtering. Impure yellow-white DMT crystals will be seen on the coffee filter paper. Allow the crystals to completely dry out on the filter paper in the funnel. Premix a wash solution by mixing equal parts of Distilled Water and NON-SOAPY clear Ammonium Hydroxide(Ace Hardware Janitorial Strength Ammonia) into a pint container. Slowly pour 100ml of the wash solution over the crystals (still in the filter paper) to wash them. Remove the filter paper from the funnel, spread it out flat and allow the crystals to COMPLETELY dry out. You will now have 2-1/2 grams of white crystal DMT. At least 50 strong doses. Mix it with some parsley and smoke a little in your favorite pipe!
--------------------
|
tactik
Too stoned forthis.

Registered: 10/19/05
Posts: 437
Last seen: 14 years, 2 months
|
Re: DMT extraction tek [Re: muistrue]
#5263559 - 02/04/06 06:08 PM (17 years, 11 months ago) |
|
|
Quote:
FractalDust said: Here's Marsofold's tek which is well known for being very simple and producing a clean product. Hope you find it useful. 
Amazing simple clean DMT extraction How to easily extract DMT: ======================= Break 1-Pound of Mimosa Hostilis rootbark into 2" pieces and grind it all up in a glass-topped blender, a little at a time. ------------------------------------ Polar Extraction: Premix in an empty 1-Gallon plastic jug: 1-Quart White Vinegar & 3-Quarts Water. Put the ground up Mimosa in a 3-Liter crockpot, then fill it with the water-vinegar solution. Stir well and turn it on "high". After 2 hours, remove the crockpot ceramic liner, hold the lid on slightly offset, and pour off most of the liquid into a 1-gallon wide-mouthed glass or stainless container. Add the remaining water-vinegar solution to the crockpot again. Stir well and turn it on "high". After 2 hours, remove the crockpot ceramic liner, hold the lid on slightly offset, and pour off all of the liquid into the same container again. Discard the rootbark fiber and save the two combined extractions in the 1-gallon container. Allow the vegetable particles in the extraction in the 1-gallon container to settle to the bottom overnight. Then pour off the liquid into an empty 1-Gallon glass wine jug, being careful not to pour off any of the vegetable sludge at the bottom. Discard the sludge and keep the contents of the wine jug. ------------------------------------ Basification: Premix in advance a solution of: 5 Tablespoons (63grams) of Sodium Hydroxide ("Red Devil" lye) with 1-Pint of WARM Water. Stir well. Slowly add this solution to the wine jug, then cap the jug. Gently tilt the wine jug back and forth for 1 full minute to mix the contents. ------------------------------------ Nonpolar Extraction: Add 250ml of (Ace Hardware)VM&P Naptha to the wine jug. Add exactly enough warm water to the jug to raise the liquid level to an inch below the top, then cap the jug. Gently tilt the wine jug slowly back and forth for 5 full minutes to mix the contents. Allow the jug to sit undisturbed on a table for at least 4 hours. There should now be two layers visible in the jug, a lower dark one and a smaller clear one on top filling the neck of the jug. Use a glass turkey baster to suck up the top clear layer into a pint mason jar. Be careful not to suck up any of the lower brown/black layer into the mason jar. ------------------------------------- Freeze-precipitation/wash: place the sealed mason jar in a FREEZER for 3 days to precipitate the crystals. Prepare a filter setup by placing a funnel into a quart mason jar and putting a small coffee filter paper into the funnel. Shake the naptha in the mason jar strongly to stir up all the crystals at the bottom and quickly pour while still very cold into the funnel for filtering. Impure yellow-white DMT crystals will be seen on the coffee filter paper. Allow the crystals to completely dry out on the filter paper in the funnel. Premix a wash solution by mixing equal parts of Distilled Water and NON-SOAPY clear Ammonium Hydroxide(Ace Hardware Janitorial Strength Ammonia) into a pint container. Slowly pour 100ml of the wash solution over the crystals (still in the filter paper) to wash them. Remove the filter paper from the funnel, spread it out flat and allow the crystals to COMPLETELY dry out. You will now have 2-1/2 grams of white crystal DMT. At least 50 strong doses. Mix it with some parsley and smoke a little in your favorite pipe!
ah, i had read this tek a while ago, and was searching for it the other day, but with no luck. Thanks a bunch!
-------------------- Terrapin!
|
Jon
Registered: 06/28/03
Posts: 961
Last seen: 9 years, 1 month
|
Re: DMT extraction tek [Re: tactik]
#5263574 - 02/04/06 06:15 PM (17 years, 11 months ago) |
|
|
Yes this is it, thanks a shitload.
|
IwantELVES
ChronoSynclasticInfundibulumated


Registered: 02/08/06
Posts: 63
Last seen: 16 years, 2 months
|
Re: DMT extraction tek [Re: Jon]
#5281979 - 02/09/06 02:11 PM (17 years, 11 months ago) |
|
|
It says to smoke with parsley, but I was under the impression that flames are never to touch the DMT.
--------------------
|
Koala Koolio
TTAGGGTTAGGGTTAGGGTTAGGG

Registered: 01/07/04
Posts: 7,752
|
Re: DMT extraction tek [Re: IwantELVES]
#5282025 - 02/09/06 02:26 PM (17 years, 11 months ago) |
|
|
It isn't that big a deal.
-------------------- You're not like the others. You like the same things I do. Wax paper, boiled football leather... dog breath. We're not hitch-hiking anymore, we're riding!
|
rvrdennis
Stranger
Registered: 02/25/10
Posts: 1
Last seen: 13 years, 8 months
|
|
it definatly makes a difference never let the flame touch the product
|
wojowut
Cacti Enthusiast

Registered: 04/20/10
Posts: 7
Loc: Flagstaff, Arizona
Last seen: 13 years, 8 months
|
|
Its best consumed with a specifically blown DMT pipe
|------------|_____ __________________ |------------____ \ / _________________| |------------| \ \ / / |------------| \ \ / / |------------| \ / |_______| \__/
This way your able to heat the dmt from the bottom of the pipe, when it reaches its proper temperature it will vaporize and the smoke will rise to the top and be inhaled with a good mixture of air. Sometimes it can resolidify into a boiling goop where it can seriously fuck up your throat/mouth/tongue. With the dip in the stem of the pipe, if any boiling hot material is sucked into the stem, it will be caught at the bottom, and not go into your mouth 
If you dont have a DMT pipe and are using the parsly method, put flame over material being smoked and pull GENTLY in a way that the flame will come down close to the material but will not toutch it. You will vaporize the dmt without burning it. This method also works especially well when smoking a bowl of kief xD Happy Trails!
|
psykedelic
The Guide


Registered: 10/01/10
Posts: 6
Loc: Montreal
Last seen: 12 years, 11 months
|
Re: DMT extraction tek [Re: tactik]
#13870151 - 01/29/11 09:38 AM (13 years, 2 days ago) |
|
|
Hi,
I didn't see the naphta changing color still after 3-4 hours.
I followed this tek on a website i found but these kawk sukr removed important parts of the tek so i need to come here and find what is missing.
Now i have 2 liters waiting to see what is gonna happen. The naphta never get to the bottom. Since i puted in, he float on top.
Someone can help me? Thank you
|
walfredo
Stranger



Registered: 07/12/10
Posts: 115
Loc: omaha,ne
Last seen: 1 year, 3 months
|
|
cool i might try this
|
Dosile Kouki
derp

Registered: 03/08/10
Posts: 14,963
Loc: Paradise
Last seen: 11 years, 6 months
|
|
so you shake it up, not too vigorously, and mix the naptha into the bottom part of the jug via shaking, or get something you can use to stir the mixture so the naptha goes into the bottom of the solution.
Also warm naptha pulls across more goodies from the sludge mix, so put it in a hot water bath for a bit before you add it to the sludge mix.
--------------------
|
mousehat
Stranger
Registered: 11/12/11
Posts: 1
Last seen: 11 years, 11 months
|
Re: DMT extraction tek [Re: Jon]
#15360968 - 11/12/11 03:17 PM (12 years, 2 months ago) |
|
|
question, may be irrelevent, if i was to heat the left over liquid after removing the Naptha. & in seperated container heated the filtered naptha what would be the out come
|
|