Home | Community | Message Board



Please support our sponsors.

Mushrooms, Mycology and Psychedelics >> Mushroom Cultivation

Welcome to the Shroomery Message Board! You are experiencing a small sample of what the site has to offer. Please login or register to post messages and view our exclusive members-only content. You'll gain access to additional forums, file attachments, board customizations, encrypted private messages, and much more!

Amazon Shop for: Aquarium Heater

Jump to first unread post. Pages: 1
OfflineMushroomFriend
Vargen ska fanleva!!
Male User Gallery

Registered: 10/12/04
Posts: 4,055
Loc: The Druid Peak Pack.
Last seen: 1 year, 1 month
Holes for airpump lines in PMP (magash?)
    #3280286 - 10/26/04 06:07 PM (12 years, 2 months ago)

Hello I have asked this before but I got different answers on it and ofcourse I want to do it right!

WHen I make the PMP with Geolite, where should I make the holes for the wire of the aquarium heater, and the holes for the airtubes?

The higher the better or the lower the better? Maybe lower more water goes through?

Thanks 4 the help!

MF


--------------------


Post Extras: Print Post  Remind Me! Notify Moderator
Offlineatomic1
enthusiast

Registered: 09/18/03
Posts: 1,103
Last seen: 2 years, 2 months
Re: Holes for airpump lines in PMP (magash?) [Re: MushroomFriend]
    #3280319 - 10/26/04 06:17 PM (12 years, 2 months ago)

I think i commented on this before also. I probably wasn't clear. Every pmp i've seen has the airline holes pretty low ... just above the surface of the geolite. But, they are sealed up around the lines with silicone. If there have been holes for air to escape from, magash has plainly said to put them high or in the lid.


Edited by atomic1 (10/26/04 06:18 PM)


Post Extras: Print Post  Remind Me! Notify Moderator
OfflineMushroomFriend
Vargen ska fanleva!!
Male User Gallery

Registered: 10/12/04
Posts: 4,055
Loc: The Druid Peak Pack.
Last seen: 1 year, 1 month
Re: Holes for airpump lines in PMP (magash?) [Re: atomic1]
    #3280331 - 10/26/04 06:20 PM (12 years, 2 months ago)

Heyaz!!

Yes atomic you responded be4. Maybe I mix up the dedicated airholes with the holes for the wires.

Do other people with succesfull PMP use (high) dedicated airholes (stuffed with filterstuff) in such a PMP?

Your help is highly appreciated!

MF

BTw why dont I dont just trust your word and make high airholes? Hmz cause I am not sure if they are needed, I read many PMP postings but I could not find the answer. Will do some more searching as well!

Found out that people disagree a bit on it and that the experienced guys like Anno and castanze dont recommend the extra airholes....

But indeed if you make them, make them high! :laugh:

Case closed now 4 me, thanks Atomic!


--------------------


Edited by MushroomFriend (10/26/04 06:26 PM)


Post Extras: Print Post  Remind Me! Notify Moderator
InvisibleQbanMoJo
Mr. Brightside

Registered: 09/09/04
Posts: 361
Loc: OutSide
Re: Holes for airpump lines in PMP (magash?) [Re: MushroomFriend]
    #3280354 - 10/26/04 06:25 PM (12 years, 2 months ago)

My "exhaust" holes are set at about the same level as my casings. about 2" about my geolite. The holes for the hoses were made with a drill and the hoses get a tight fit (no need for silicone) but enough to perform normal without clogging the lines. Good Luck.



P.S. Exhaust holes should be filled with either polyfill or tyvek (preferably polyfill).


Post Extras: Print Post  Remind Me! Notify Moderator
OfflineMushroomFriend
Vargen ska fanleva!!
Male User Gallery

Registered: 10/12/04
Posts: 4,055
Loc: The Druid Peak Pack.
Last seen: 1 year, 1 month
Re: Holes for airpump lines in PMP (magash?) [Re: QbanMoJo]
    #3280370 - 10/26/04 06:28 PM (12 years, 2 months ago)

Lol this is a holes-lover! :laugh:

Im not sure yet, I think I start without them!

Thanks,
MF


--------------------


Post Extras: Print Post  Remind Me! Notify Moderator
Offlineatomic1
enthusiast

Registered: 09/18/03
Posts: 1,103
Last seen: 2 years, 2 months
Re: Holes for airpump lines in PMP (magash?) [Re: MushroomFriend]
    #3280381 - 10/26/04 06:31 PM (12 years, 2 months ago)

Check this out and read what magash says or else you're just going to keep getting everyone's different opinions:

http://www.shroomery.org/forums/showflat...rue#Post3080371

If that link doesn't work do a search for "FAE holes for Pmp?"

Hope it helps


Edited by atomic1 (10/26/04 06:34 PM)


Post Extras: Print Post  Remind Me! Notify Moderator
OfflineMushroomFriend
Vargen ska fanleva!!
Male User Gallery

Registered: 10/12/04
Posts: 4,055
Loc: The Druid Peak Pack.
Last seen: 1 year, 1 month
Re: Holes for airpump lines in PMP (magash?) [Re: atomic1]
    #3283025 - 10/27/04 06:27 AM (12 years, 2 months ago)

Hey Atomic, way cool! That particular airhole thread I had not seen yet...

I will test my fruiting chamber also before I will use it. I will start testing without the holes, if temp and humid is ok I want to try a first grow. If things can improve but temp and humid is ok then I will start with 1 dedicated airhole, which I will be filling with that white aquarium filter stuff....

Thanks mister!

MF


--------------------


Post Extras: Print Post  Remind Me! Notify Moderator
Offlineatomic1
enthusiast

Registered: 09/18/03
Posts: 1,103
Last seen: 2 years, 2 months
Re: Holes for airpump lines in PMP (magash?) [Re: MushroomFriend]
    #3283333 - 10/27/04 10:09 AM (12 years, 2 months ago)

Glad to help bro, good luck. :rockon:


Post Extras: Print Post  Remind Me! Notify Moderator
Jump to top. Pages: 1

Amazon Shop for: Aquarium Heater

Mushrooms, Mycology and Psychedelics >> Mushroom Cultivation

Similar ThreadsPosterViewsRepliesLast post
* Noiseless Airpumps for PMP!? abaccusx 872 13 04/01/06 04:38 PM
by agar
* RH too high in PMP ??? Magash Style PMP PhdHater 1,071 3 02/09/05 02:34 PM
by Smushroom
* PMP vs Casings (also PMP 2 Dry)
( 1 2 all )
MushroomFriend 2,116 23 01/07/05 07:46 AM
by ZeroArmy27
* PMP lighting question KnobleJunga 762 4 02/06/04 10:44 PM
by Magash
* 4 - 1/2" Holes for air exchange... robbster 491 5 11/24/04 08:30 AM
by call_me_kido
* pmp
( 1 2 all )
johnnyblaze2316 2,020 29 01/15/09 08:32 PM
by nw_shroomy
* PMP RH (humidity) Too Low DesperateFuture 711 6 03/31/09 10:20 PM
by DesperateFuture
* PMP Question MycoCat 1,110 17 11/13/03 09:20 PM
by MycoCat

Extra information
You cannot start new topics / You cannot reply to topics
HTML is disabled / BBCode is enabled
Moderator: Magash, Shroomism, george castanza, Prisoner#1, RogerRabbit, Citric, total, FooMan, 13shrooms, stonesun, EvilMushroom666, cronicr, PussyFart, Tmethyl
672 topic views. 25 members, 139 guests and 28 web crawlers are browsing this forum.
[ Toggle Favorite | Print Topic | Stats ]
Search this thread:
High Mountain Compost
Please support our sponsors.

Copyright 1997-2017 Mind Media. Some rights reserved.

Generated in 0.045 seconds spending 0.004 seconds on 14 queries.