hey i have a question....
so you cant see it in the pics but i placed two holes on the long sides sub level and then one hole on the short sides SUBSTRATE LEVEL
ive been going back through TL's ohmatics and many other monotub logs and even though i looked at these before makeing these tubs i didnt place the side holes high up as shown here

Quote:

a.Remember you want your lower Holes @ substrate depth. So if you have a 1” bit & want the hole bottom to be @ 4” you should mark @ 4.5”.
    b.Also, I place my holes 5-6” from the sides of the tub.
    c.The End holes Don’t matter that much, you just want them as High as you possibly can get them.

---

errr i figure im gona be fanning or will it do just fine?i understand that fresh air comes in through the lower holes following the hot moist air and exiting the top holes. the lid doesnt make a seal but you cant feel warm air moving out of it (like when you open a tub or FC).will the lid be loose enough for hot air to escape drawing fresh air in?

i wont fan until i see probs occur i feel as itll be fine but want to get some input

if thangs go real wonky ill end up drilling holes towards the top. my original holes are 2 inch diameter 2 on long sides one on short substrate level




im gona let it colonise consolidate wait for a good number of pins, then fruit as normal. only fanning misting IF needed and if it slows down way to much then ill go to emergency plan c and drill holes along the top

now we play the game (except with a smile not a grumble face :P )

Toofpaste said:

Lmao I love dumpster divers

---

SimpleFarmer said:

---

QFT

*bangs head against wall*

im makeing plates today to test my verm for cob web and i have one nugget left over any other suggestions to run plates from so i can find the cobweb scource.

im thinking. manure,verm, clothes, hair

idk where it came from cause i never opened the tub