Home | Community | Message Board


This site includes paid links. Please support our sponsors.


Welcome to the Shroomery Message Board! You are experiencing a small sample of what the site has to offer. Please login or register to post messages and view our exclusive members-only content. You'll gain access to additional forums, file attachments, board customizations, encrypted private messages, and much more!

Shop: North Spore Bulk Substrate, Injection Grain Bag   MagicBag.co Certified Organic All-In-One Grow Bags

Jump to first unread post Pages: | 1 | 2 | 3 | 4 | 5  [ show all ]
Re: Building a 650 Liter autoclave [Re: 7Suns] * 1
    #29699251 -





Did a little testing and troubleshooting today, there’s some sort of issue with the alarm output on the LWCO circuit but I was able to get everything to turn on I fired up both electrical heating elements and filled the tank with water, i turned the elements off and then filled it with compressed air to test the blow off valve, it had me a little nervous even though i knew I hit 60 psi with hydrostatic testing compressed air carries a greater risk of severe injury and destruction, but with caution I got her up to 20 psi before the blow off popped as it was intended so the safety feature seems to be working, however heat and pressure will be the ultimate test

Additionally i did a risk assessment and I ran some numbers on blast radius and level of destruction in the event of catastrophic failure like a ruptured seam weld and when accounting for substrate and water displacement in a 200gal tank I only have roughly 85 gal of air to account for in the vessel, this is equivalent to a large stand up shop air compressor, it has a leathal proximity of 10ft and a damaging schrapnal radius of 30ft, so then I ran these same figures behind a rebar reinforced concrete filled cinder block blast wall and the limited approach boundary was reduced to 0 !!! So factor in a concrete barrier and I should have no issues whatsoever even though I raw dogged it today and was practically climbing on this thing with it holding 18psi :rofl:


--------------------








Extras: Filter Print Post Top
Re: Building a 650 Liter autoclave [Re: 7Suns] * 1
    #29700013 -






$200 in stainless steel!! time to fabricate lift baskets for the clave !!


--------------------








Extras: Filter Print Post Top
Re: Building a 650 Liter autoclave [Re: 7Suns] * 1
    #29702284 -








started pre-fabing the stainless steel drop in baskets for the autoclave, they are approximately 28”x24” and will hold 45 bags per layer, 2 layers per basket, 2 baskets per load so that’s roughly 180 bags each weighing 2-2.5lbs per bag or approximately 200Lbs per basket and 400Lbs of grain per 4 hour run

:skol:


--------------------








Extras: Filter Print Post Top
Re: Building a 650 Liter autoclave [Re: 7Suns]
    #29702507 -

That's a fuckload of grains

You mentioned something like a winch to pull them out? Mounted in the roof of the autoclave room?

Extras: Filter Print Post Top
Re: Building a 650 Liter autoclave [Re: deadmandave]
    #29702628 -

Yes sir that is correct 👍 I have a manual chain fall in place already but will eventually upgrade to an electric hoist


--------------------








Extras: Filter Print Post Top
Re: Building a 650 Liter autoclave [Re: 7Suns]
    #29706172 -









Slow and steady wins the race, i bought this stainless steel prep table for $50 off market place since it’s 1/3 the price of buying a full sheet, marked it out to 26 inch diameters and cut bottoms out of it for the mesh baskets, this will make it easier to weld and dramatically improve the load capacity because 200Lbs will make a mesh bottom sag even with bracing


--------------------








Extras: Filter Print Post Top
Jump to top Pages: | 1 | 2 | 3 | 4 | 5  [ show all ]

Shop: North Spore Bulk Substrate, Injection Grain Bag   MagicBag.co Certified Organic All-In-One Grow Bags


Similar ThreadsPosterViewsRepliesLast post
* Horizontal autoclaves? newb grower 3,236 17 07/17/08 04:13 PM
by solumvita
* The autoclave of my dreams - 75000 Euros
( 1 2 all )
FreeSporePrints 5,110 21 12/28/06 01:14 PM
by Cryogenicz
* Laundry Basket vs. Straw log jccc 1,022 2 09/14/08 05:18 PM
by jccc
* RR's Laundry Basket 'TEK' with Golden Oysters
( 1 2 all )
FugueRider 7,714 22 05/19/09 10:22 PM
by FugueRider
* anyone seen good prices on small autoclave or retorts? Imorph 1,946 3 01/17/04 01:22 AM
by Imorph
* Vitamin B1 (thiamine hydrochloride) and autoclaving wbastz 6,438 3 05/31/09 06:33 PM
by wbastz
* Autoclave pics
( 1 2 3 all )
crazyredhead 10,417 47 01/13/03 01:27 PM
by Anno
* grey oysters - visions laundry basket zeegos 4,927 18 03/08/07 04:42 AM
by zeegos

Extra information
You cannot start new topics / You cannot reply to topics
HTML is disabled / BBCode is enabled
Moderator: RogerRabbit, cronicr, Pastywhyte, Forrester, Stromrider, SHROOMSISAY01
1,384 topic views. 0 members, 35 guests and 17 web crawlers are browsing this forum.
[ Show Images Only | Sort by Score | Print Topic ]
Search this thread:

Copyright 1997-2026 Mind Media. Some rights reserved.

Generated in 0.028 seconds spending 0.006 seconds on 17 queries.