ruK said:

Question:

Are you guys taping up the holes during colonization of the tub? Or is it free air flow from the very beginning? I guess that leaves the only real switch-up for fruiting the introduction of light after colonization, yes?

---

For what it is worth, ruK, I do no taping at any point and do the normal light cycle from day one with agar all the way through the process to harvest.


I may have mixed up my PE and GT tubs. Still not sure which is what, but they are progressing.


I just noticed this crap ton of side pins starting on what should have been GT. This is the tub that I didn't add the optional holes to. Maybe that is why the GT is so far behind the PE. So I grabbed the drill and added them now to see if that helps. Maybe even in a dry environment the extra hole is necessary when using a casing.


I definitely changed too many factors in my process at once to figure out what the hell is working and what is not. Always next time.

Edit:spelllling.

Mr. Mushie said:

Looking great!

Did you decide to add the optional holes and cover with micropore tape in the event of excess FAE?

Check out eats unbucket tek. Hot water to hydrate coir instead of boiling water... if you plan on doing multiple tubs it can save a considerable amount of time.

https://www.shroomery.org/forums/showflat.php/Number/26216702/page/1/fpart/1

---

ruK said:

Question:

Are you guys taping up the holes during colonization of the tub? Or is it free air flow from the very beginning? I guess that leaves the only real switch-up for fruiting the introduction of light after colonization, yes?

---

eatyualive said:

Round 2 of the Apeu ez dial coming in. Tubs 4-6. Im making a log of notes so i dont muddy up this thread. Im playing with number of holes on the lower short sides. These are all getting two holes.



EZ DIAL LOG

---