Yeah, you gotsta nix the mic into the sound card thing man. This is where the buzz and hum noise is being introduced as you probably have an impedance mismatch compounded by unsuitable recording technique.
I paid $200 for this Edirol in like new condition at an instrument shop here in town, great since it's a 500 dollar piece of gear. I paid 750 for my previous interface and the one I have now is about as good as it was. You want an option with analog 1/4inch ins and XLR(mic) ins. If you had to, you could get away with spending less than $200 or even $100 for an interface. I'll post some options below, These are from GuitarCenter's website, but you could probably find these items cheaper on Amazon or ebay or locally.
two 1/4 inch ins, one XLR(mic) in, $100
two mic ins, two 1/4 inch ins, $150
two 1/4 inch ins, two XLR ins AND midi in/out!, $129
same features as option above, a little fancier
one 1/4 in, one XLR, no midi, but cheap - $69
I used the M-Audio Fast Track Pro for a little while and it was ok. Traded it in for a firewire model since theoretically firewire performs better...
USB vs. Firewire - This is a pain in the ass subject. See they both have more or less the same capacity as a bus but USB2.0 operates at a steady stream of data packets whereas Firewire transmits in bursts , which supposedly makes it faster and more stable. Though depending on who you ask it doesn't make much difference. If at all, the difference supposedly counts when you're doing longer recordings, which I tend to do and you obviously do as well, so for that reason I went firewire. Going the firewire route will instantly bump up your price by a few hundred$$. I did it but I fucking hate firewire and I curse Apple and whoever else was involved in its development. It's flaky as fuck, drivers are often unstable and it doesn't like to play nice in a lot of environments unless you have a Texas Instruments chipset in your firewire controller on your motherboard, no wifi enabled, no other fireire/usb devices operating simultanously, and if you plug it in or out while you're booted up you can fry your shit, which I've done, it's just ridiculous.
I've used 6 different interfaces both USB and Firewire to find one I could deal with. You might just go with USB2.0 and unless you run into issues, to hell with Firewire. All the options I listed are USB2.0. I look forward to USB3.0 taking over.
Now, the output jack on your keyboard is 1/4 inch right? If you sent that to an interface with a 1/4" input you would eliminate noise and would have a good solid, clean signal straight into your computer. For color you could also mic the speaker or the room or whatever else using a decent XLR mic with your new interface. A decent enough XLR mic could be had for cheap, just check craigslist. Or maybe the one you already have does have an XLR connector?
And if your interface also has midi in, you can use your keyboard(assuming it has midi out) as a midi controller and that opens up options for triggering softsynths with Audacity(...a quick google shows that the Audacity VST Enabler plugin enables Audacity 1.2.4 or higher for VST softsynths).
You can also plug in a guitar or any line level outboard gear and get a nice clean signal.
Making sense so far?
|