| Home | Community | Message Board |
|
You are not signed in. |
This site includes paid links. Please support our sponsors.
|
|
Some Cow Reged: 08/22/07 Posts: 3994 Loc: Greener Pastures |
|
||
|
I've been working on this project for close to 2 months now. Quite a few fook ups/set backs. But finally I got my first pin. I had just cased this tub about 3 days ago, I had the air holes packed tight with polyfill, just sitting on a shelf waiting for it to pop through the casing. One little pinhead decides to pop up in the corner. I went ahead and opened it to fruiting conditions now. Took out the polyfill and replaced it with very very loose polyfill and set it on a table with a fan nearby. It's the only pin I can see in that tub unless there's more buried under the casing. Update: 3 hours: 11 hours 20 hours 33 hours Some cakes (coir, grains, coffee) started pinning invitro, I wasn't planning on fruiting these alone, but wtf, so I dunked, added a bit of casing mix and stuck in my monotub. A second pin appears! 44 hours it was determined my monotub was starting to dry out, so I began misting at this point. Day 3 afternoon Day 3 - Evening 3 more pins appeared over the last few hours! And the cakes each have 1-2 pins going on. Day 4: Day 5: Tub has 30-35 that I can see (some side pinning growing the wrong way, etc.) plus the lil cakes. Edited by Spongiform (12/25/08 05:39 PM)
|
| Extra information | ||||
|
12 members, 117 guests and 54 web crawlers are browsing this forum.
Moderator: Shroomism, george castanza, RogerRabbit, veggie, mushboy, fahtster, LogicaL Chaos, 13shrooms, Stipe-n Cap, Pastywhyte, bodhisatta, Tormato, Land Trout, A.k.a |
Forum Permissions
You cannot start new topics You cannot reply to topics HTML is disabled BBCode is enabled |
Rating:
Thread views: 2707 |
||
|
|
||||
