| Home | Community | Message Board |
|
You are not signed in. |
This site includes paid links. Please support our sponsors.
|
|
Finally Grateful Reged: 12/14/09 Posts: 1919 Loc: USA |
|
||
Quote: Mine are usually saturated so I remove them to allow the micropore tape on the lids to dry faster in the SAB. However, one could just wait longer for them to dry and use them for notes. Personally I don't mind switching out a couple 1" pieces of micropore tape on each lid so I can keep relabeling them, all about where you are trying to cut seconds and cut pennies. Either should work fine. Also, I don't bother waiting for a slow decompression as I see the same amount of condensation either way, so I just wait 20 minutes after it loses pressure and set the plates in the SAB before they can solidify, allowing uniform/level solids every time. My preference. Soon I will be using some PP5 containers I found "salad dressing" containers at a local store for a test run. Also going to try the micropore tape on the side of the mini-rounds and see which works best. Edited by plurfekt (05/15/18 01:31 PM)
|
| Extra information | ||||
|
15 members, 161 guests and 49 web crawlers are browsing this forum.
Moderator: Shroomism, george castanza, RogerRabbit, veggie, mushboy, fahtster, LogicaL Chaos, 13shrooms, Stipe-n Cap, Pastywhyte, bodhisatta, Tormato, Land Trout, A.k.a |
Forum Permissions
You cannot start new topics You cannot reply to topics HTML is disabled BBCode is enabled |
Rating:
Thread views: 793642 |
||
|
|
||||

