| Home | Community | Message Board |
|
You are not signed in. |

This site includes paid links. Please support our sponsors.
|
|
Finally Grateful Reged: 12/14/09 Posts: 1919 Loc: USA |
|
||
|
I had better results with the one I put SFD on for my first set as of so far, in terms of condensation on the sides they all had it, this one just a bit less than the others. The SFD was dry to the touch under the damp paper towel, and all the micropore taped ones were wet. I added an additional layer of tape and went to town. 4x PE, 2x Syzygy. I accidentally dropped 2 drops of spores in a couple of them, will take some getting used too; at least until I can use my inoc loops. I look forward to cloning with these, blenderless inoculant, tiger dropping, the works. I'll be buying more minirounds very soon... and all of them are getting penny-sized SFD's on the lids. I just make a little circle of RTV around the 1/4" hole, press down hard, wait for it dry and remove the RTV that pushes through the other side in one clean strip. My first run, wish me luck. Have the micropore tape drying out a little in my SAB and then deciding on a place to put them for colonization. This. is. the. tits. God-tier TEK Pasty, major respect. ![]() Only imperfection as far as I could tell was some of them cooked at a slight angle, but they were propped in lid rings so nothing worth fretting about, just something to be mindful of next time (get em' as flat as you can I guess) Edited by plurfekt (03/30/18 11:50 AM)
|
| Extra information | ||||
|
15 members, 145 guests and 51 web crawlers are browsing this forum.
Moderator: Shroomism, george castanza, RogerRabbit, veggie, mushboy, fahtster, LogicaL Chaos, 13shrooms, Stipe-n Cap, Pastywhyte, bodhisatta, Tormato, Land Trout, A.k.a |
Forum Permissions
You cannot start new topics You cannot reply to topics HTML is disabled BBCode is enabled |
Rating:
Thread views: 793642 |
||
|
|
||||

