Welcome to the Shroomery Message Board! You are experiencing a small sample of what the site has to offer. Please login or register to post messages and view our exclusive members-only content. You'll gain access to additional forums, file attachments, board customizations, encrypted private messages, and much more!
your holes should take into account how deep your substrate will be. if you use a casing layer, take this into account too. you want the holes just above the surface. there are monotub teks that explain this in more detail. go search
I think the point is to have it close to the substrate for gas exchange....no need for super precision, just get it as close as possible. Under an inch would be good.
Threaded
Previous
Index
Next
Shop: 
Some of these posts are very old and might contain outdated information. You may wish to 
Edit 
Reply 
