|
Some of these posts are very old and might contain outdated information. You may wish to search for newer posts instead.
|
aNewPerception
candy eater
Registered: 05/16/04
Posts: 285
Last seen: 11 years, 3 months
|
Laying PRO-LAD
#7987053 - 02/06/08 02:42 PM (16 years, 1 month ago) |
|
|
Suppose one were to procure 10 mg PRO-LAD. How would one go about in laying a sheet of this stuff?
|
wildchild68
lion in a coma
Registered: 11/19/07
Posts: 5,115
Last seen: 9 years, 10 months
|
|
I'd imagine you'd have to dilute it into some liquid and then submerge the sheet into said liquid to accurately lay it.
No idea about the specifics though.
I want some PRO-LAD.
--------------------
|
jizmaster
Registered: 02/04/08
Posts: 346
Last seen: 9 years, 6 months
|
|
If you want each hit to be 100ug, you will get 100 hits. Rather than trying to lay one big sheet, i think it would be easier to lay 10 * 10 strips.
Cut some appropriately sized strips and dip some in whatever solvent you're going to use (ethanol probably best) to work out how much solvent will be absorbed. You might as well do all ten for better accuracy, the best way would probably be to dip them directly in a small measuring cylinder with a pair of tweezers. Alternatively the solvent could be applied from a syringe but it might be hard to tell when they're saturated.
Now dissolve the substance in the calculated amount of solvent, maybe a slight excess, and dip the strips, getting them thoroughly wet and letting the excess drain. Any excess can be mopped up with a couple extra little squares of paper.
I guess the best way to dry them would be to lay them perfectly flat on a glass tray. The solvent will inevitably wick some of the substance to the edges of the strips as it evaporates, i can't see any way to avoid this, but it will definitely give more consistant results than hanging them vertically.
Adjusting this for 50ug/hit will make it easier, giving more liquid to work with.
Obviously trying to pass this off as LSD is not cool, though i'm sure you're not going to, it's probably more expensive for one.
|
epilectric
low dose
Registered: 06/28/06
Posts: 1,145
Loc: Vienna
Last seen: 12 hours, 56 minutes
|
Re: Laying PRO-LAD [Re: jizmaster]
#7987525 - 02/06/08 04:29 PM (16 years, 1 month ago) |
|
|
what is PRO-LAD?
|
anyone420
mad buddah abuser
Registered: 02/04/08
Posts: 5,956
Last seen: 14 years, 10 months
|
|
From www.wikipedia.org
Quote:
PRO-LAD, also known as 6-propyl-6-nor-lysergic acid diethylamide, is an analogue of LSD. It is described by Alexander Shulgin in the book TiHKAL. PRO-LAD is a hallucinogenic drug similar to LSD, and is around as potent as LSD itself with an active dose reported at between 100 and 200 micrograms.
-------------------- for all y’all niggaz out there that be puffin shit when the music go on, y’all listen to this alright
|
epilectric
low dose
Registered: 06/28/06
Posts: 1,145
Loc: Vienna
Last seen: 12 hours, 56 minutes
|
Re: Laying PRO-LAD [Re: anyone420]
#7987543 - 02/06/08 04:34 PM (16 years, 1 month ago) |
|
|
in what way are the effects different from / similar to lsd? have you taken it already?
|
aNewPerception
candy eater
Registered: 05/16/04
Posts: 285
Last seen: 11 years, 3 months
|
|
No i havent taken it yet. It's on my to-do list, though. Psychadelic Novelty Thanks for the reply, jizmaster, that helped. Anyone care to share more detailed knowledge?
|
SuperD
Cacti junky
Registered: 10/05/03
Posts: 6,648
Loc: The bridgesii bridge
|
|
I've found a source for this as well but don't have the funds to try it. I think some of the above posts at least give you a head start on how to properly lay it. Try googling how to lay acid, and just use the same procedure.
-------------------- D Manoa said: I need to stop spending all my money on plants and take up a cheaper hobby, like heroin. Looking for Rauhocereus riosaniensis seeds or live specimen(s), me if you have any for trade
|
Yossarian22
Stranger
Registered: 09/12/07
Posts: 415
Last seen: 9 years, 3 months
|
Re: Laying PRO-LAD [Re: SuperD]
#7988253 - 02/06/08 06:55 PM (16 years, 1 month ago) |
|
|
I apologize if this is unecessary, but I feel it needs to be said: Please put some marking or something on the blotter indicating that it's PROLAD and not LSD. Last thing we need is more RCs on blotter being sold as real acid. Assuming this is for distribution and not your personal stash(in which case why not just drop from the liquid?)
|
aNewPerception
candy eater
Registered: 05/16/04
Posts: 285
Last seen: 11 years, 3 months
|
|
I dont know how i feel about having being suspended in liquid kinda hard to dose with 100 doses in it at doses that are active at the 100 ug range.. its for personal use.;) Also easier to hand out to close friends already dosed up on paper, too.
|
FarFromHere
~Teotzlcoatl~
Registered: 01/10/08
Posts: 926
Loc: The 7th Plane
Last seen: 16 years, 1 month
|
|
I'd just drop it on my tongue.
Sounds like a cool chemical...
-------------------- "We are the one's we have been waiting for" -Hopi Proverb
|
2859558484
Growery is Better
Registered: 01/10/06
Posts: 8,752
Last seen: 3 years, 6 months
|
|
i dont think you can lay a single sheet
You will have to make a vial. Go to walgreens and get a sweetbreath vial, empty it out and fill it up a lil more than half way with distilled water. Then dissolve your "pro lad" int here and take a drop to see. Should be around 100ug. tell us how it is. This is crazy that some RC source is selling LSD analogues lol
--------------------
|
FarFromHere
~Teotzlcoatl~
Registered: 01/10/08
Posts: 926
Loc: The 7th Plane
Last seen: 16 years, 1 month
|
|
is it legal?
-------------------- "We are the one's we have been waiting for" -Hopi Proverb
|
2859558484
Growery is Better
Registered: 01/10/06
Posts: 8,752
Last seen: 3 years, 6 months
|
|
fuck no dude. no RCs are legal when you get down to the nitty gritty
--------------------
|
aNewPerception
candy eater
Registered: 05/16/04
Posts: 285
Last seen: 11 years, 3 months
|
|
Probably isn't due to its similar structure to lsd. Does anyone know if its stable in water? Oh, and BTW i would never give Or sell someone stuff that isn't what i say it is. That's just wrong.
|
imachavel
I loved and lost but I loved-ftw
Registered: 06/06/07
Posts: 31,474
Loc: You get banned for saying that
Last seen: 6 hours, 31 minutes
|
|
i've never taken lad(or have I?) i don't much about what it's like, exept that it's about the same as lsd(because it turns into lsd on your tongue, or something), but way cleaner... anyway...
peace
-------------------- I did not say to edit my signature soulidarity! Now forever I will never remember what I said about understanding the secrets of the universe by paying attention to subtleties! I'm never giving you the password again. Jerk
|
imachavel
I loved and lost but I loved-ftw
Registered: 06/06/07
Posts: 31,474
Loc: You get banned for saying that
Last seen: 6 hours, 31 minutes
|
|
i've never taken lad(or have I?) i don't much about what it's like, exept that it's about the same as lsd(because it turns into lsd on your tongue, or something), but way cleaner... anyway...
peace
-------------------- I did not say to edit my signature soulidarity! Now forever I will never remember what I said about understanding the secrets of the universe by paying attention to subtleties! I'm never giving you the password again. Jerk
|
wildchild68
lion in a coma
Registered: 11/19/07
Posts: 5,115
Last seen: 9 years, 10 months
|
Re: Laying PRO-LAD [Re: imachavel]
#7989746 - 02/06/08 11:11 PM (16 years, 1 month ago) |
|
|
This thread is now the 5th result down for PRO-LAD when you search on google.
--------------------
|
kong
Stranger
Registered: 10/12/04
Posts: 43
Last seen: 11 years, 8 months
|
|
Use ethanol (everclear or vodka) not distilled water if making vials.
|
redgreenvines
irregular verb
Registered: 04/08/04
Posts: 38,060
|
Re: Laying PRO-LAD [Re: kong]
#7990492 - 02/07/08 03:53 AM (16 years, 1 month ago) |
|
|
In a shaded & protected area of your home, where no animals will disturb the drying sheet, I would dissolve the material carefully in a glass one ounce jigger cup using about 1/2 ounce of solvent (did someone suggest ethanol?), and then I would use a glass eyedropper to place drops repeatedly and evenly accross a marked sheet of blotter that was purposefully cut to about 4 inches by 4 inches in advance and marked with a grid for 100 1/4 inch blotters. I would be very methodical with this so that no material would get wasted or transferred to any working surfaces except one side of the blotter resting on a large plate, possibly raised from the plate's surface by the corners of 4 silver dimes.
Note: the drops will not be equal sized but they will be close, and each square area will have several drops which will tend to even out the dosage. Note: on the 3rd to 5th pass you will probably run out of drops. put a bit of solvent in the glass jigger to clean the edges of any residual material and finish the job methodically (distributing the results of this cleaning process over the blotter). Note: some of the resulting blotters will have slightly more or slightly less material with a variance of up to 25% but this method will waste nothing.
-------------------- _ 🧠 _
|
|