|
Some of these posts are very old and might contain outdated information. You may wish to search for newer posts instead.
|
WWorker
...

Registered: 09/09/07
Posts: 395
|
vaporizing DMT through glass with a flame...when to take the flame away?
#7817454 - 12/31/07 03:08 PM (16 years, 1 month ago) |
|
|
Ok, the spice first melts to liquid and thins out. I roll the bulb a bit and move the flame around until vapor first forms and the fills the bulb in a swirling fashion....when do I remove the flame?
Also, will it be possible to vaporize .06g ll at once and take in one hit or will I need to fill then clear a couple? a few? times?
I fear I will trance out before I get it all.
Any suggestions?
Thanks and happy new year.
--------------------
|
delafonze19
Old school vet



Registered: 03/28/07
Posts: 73
Loc: where the aminitas grow
Last seen: 14 years, 1 month
|
Re: vaporizing DMT through glass with a flame...when to take the flame away? [Re: WWorker]
#7817475 - 12/31/07 03:13 PM (16 years, 1 month ago) |
|
|
I would not worry about taking the flame away unless it seems to be splattering or something like that. The air flow will help cool it off too. I cannot get 60mg in one hit. I can usually get three in a row before it becomes too difficult to operate my bong.
|
muistrue
Inspired by the mystery


Registered: 03/20/05
Posts: 12,899
Loc: Behind the Redwoods
|
Re: vaporizing DMT through glass with a flame...when to take the flame away? [Re: delafonze19]
#7817517 - 12/31/07 03:24 PM (16 years, 1 month ago) |
|
|
It takes me about 2 lungfulls to get 60mg. I keep the flame under the pipe as I hold my first hit in so right when I blow it out, without taking another breath, I go straight for the huge second hit which is ready to go. I usually don't remember blowing out the second hit.
--------------------
|
Robo
R Series 66Y
Registered: 05/08/07
Posts: 14,861
|
Re: vaporizing DMT through glass with a flame...when to take the flame away? [Re: WWorker]
#7817584 - 12/31/07 03:46 PM (16 years, 1 month ago) |
|
|
Some can get 3 uses from 60mg
|
WWorker
...

Registered: 09/09/07
Posts: 395
|
Re: vaporizing DMT through glass with a flame...when to take the flame away? [Re: Robo]
#7817793 - 12/31/07 04:50 PM (16 years, 1 month ago) |
|
|
but is it possible to get the glass too hot...burn the spice?
--------------------
|
d4a2n0k
The Dude


Registered: 07/23/03
Posts: 742
|
Re: vaporizing DMT through glass with a flame...when to take the flame away? [Re: WWorker]
#7818152 - 12/31/07 07:09 PM (16 years, 1 month ago) |
|
|
It is possible to crack the bulb. Unless it is a Pyrex one made for said purpose. I saw a bunch of meth heads crack a light bulb vaporizer while on a binge. You should have seen there faces when all that liquid meth went into the carpet, it was priceless!
*edit* I didn't really answer your question. I don't think the spice will burn, but you could risk some drifting into the air if its vaporizing faster than you can inhale. I would remove the heat source while holding in you first hit, then start heating as you exhale.
-------------------- Row, row, row your boat, Gently down the stream. Merrily, merrily, merrily, merrily, Life is but a dream.
Edited by d4a2n0k (12/31/07 07:12 PM)
|
Amitabha
Stranger

Registered: 10/28/07
Posts: 2
Last seen: 15 years, 11 months
|
Re: vaporizing DMT through glass with a flame...when to take the flame away? [Re: WWorker]
#7818203 - 12/31/07 07:32 PM (16 years, 1 month ago) |
|
|
Quote:
WWorker said: but is it possible to get the glass too hot...burn the spice?
yes it is! be careful and put the flame no nearer to the glass then required for the dmt to vaporize.
|
WWorker
...

Registered: 09/09/07
Posts: 395
|
Re: vaporizing DMT through glass with a flame...when to take the flame away? [Re: Amitabha]
#7818331 - 12/31/07 08:26 PM (16 years, 1 month ago) |
|
|
Quote:
Amitabha said:
Quote:
WWorker said: but is it possible to get the glass too hot...burn the spice?
yes it is! be careful and put the flame no nearer to the glass then required for the dmt to vaporize.
well shit...instill doubt now!! I am about to do it. 60 mg in a lightbulb. Wish me luck and good vibes. My heart is racing.
--------------------
|
Dephect




Registered: 08/10/07
Posts: 1,779
|
Re: vaporizing DMT through glass with a flame...when to take the flame away? [Re: d4a2n0k]
#7818351 - 12/31/07 08:32 PM (16 years, 1 month ago) |
|
|
Quote:
d4a2n0k said: It is possible to crack the bulb. Unless it is a Pyrex one made for said purpose. I saw a bunch of meth heads crack a light bulb vaporizer while on a binge. You should have seen there faces when all that liquid meth went into the carpet, it was priceless!
*edit* I didn't really answer your question. I don't think the spice will burn, but you could risk some drifting into the air if its vaporizing faster than you can inhale. I would remove the heat source while holding in you first hit, then start heating as you exhale.
Man you should have seen my face when it dripped on my arm right on the vein.. Then my face about 2 minutes later after it seeped in.. That is when I started buying "Oil Incense Burners" instead of using light bulbs..
|
WWorker
...

Registered: 09/09/07
Posts: 395
|
Re: vaporizing DMT through glass with a flame...when to take the flame away? [Re: WWorker]
#7818395 - 12/31/07 08:44 PM (16 years, 1 month ago) |
|
|
well...it didn't work. I had a decent trip but nthing spectacular.
Keep trying....I will try again in anhour
--------------------
|
Dephect




Registered: 08/10/07
Posts: 1,779
|
Re: vaporizing DMT through glass with a flame...when to take the flame away? [Re: WWorker]
#7818404 - 12/31/07 08:47 PM (16 years, 1 month ago) |
|
|
That sucks I usually get my trips to last at least a hour..
|
WWorker
...

Registered: 09/09/07
Posts: 395
|
Re: vaporizing DMT through glass with a flame...when to take the flame away? [Re: Dephect]
#7818405 - 12/31/07 08:47 PM (16 years, 1 month ago) |
|
|
Quote:
Man you should have seen my face when it dripped on my arm right on the vein.. Then my face about 2 minutes later after it seeped in.. That is when I started buying "Oil Incense Burners" instead of using light bulbs..
yeah i know. And I have a true bulb type freebase pipe coming. I was just hoping to get some practice.
Is it worth it, should I just go back to sandwitching it?
Yes, I know what the answer will be from the guy I ordered the pipe from no worreis bro, I hear it is the best way to go.....just a steep learning curve.
--------------------
|
Dephect




Registered: 08/10/07
Posts: 1,779
|
Re: vaporizing DMT through glass with a flame...when to take the flame away? [Re: WWorker]
#7818470 - 12/31/07 09:37 PM (16 years, 1 month ago) |
|
|
Go to a gas station and find those glass tubes with the flowers inside.. Or just the unmarked tubes with the sphere at the end of it like mine..
Light bulbs are just too thin for me plus that liquid meth that dropped on my arm fucked me up.. I still got a scar from it..
With the true DMT/Meth pipe you want to roll it around gently with the flame underneath the bulb part but not touching it.. Wait till you get a decent amount of vapor flowing then just rip slowly but deeply while still rolling the pipe gently so you dont burn it.. Finish your rip put out your lighter.. blow out.. then this is what I do but you dont have to.. blow the vapor out of the pipe gently then wipe your pipe on the bottom of your pants if it has the black stuff that builds on stuff from flames.. I dont know what its called..
That is the best way I can describe it.. It takes practice but enough drugs and you will learn it
Edited by Dephect (12/31/07 09:40 PM)
|
WWorker
...

Registered: 09/09/07
Posts: 395
|
Re: vaporizing DMT through glass with a flame...when to take the flame away? [Re: Dephect]
#7818550 - 12/31/07 10:20 PM (16 years, 1 month ago) |
|
|
Quote:
Dephect said: Go to a gas station and find those glass tubes with the flowers inside.. Or just the unmarked tubes with the sphere at the end of it like mine..
Light bulbs are just too thin for me plus that liquid meth that dropped on my arm fucked me up.. I still got a scar from it..
With the true DMT/Meth pipe you want to roll it around gently with the flame underneath the bulb part but not touching it.. Wait till you get a decent amount of vapor flowing then just rip slowly but deeply while still rolling the pipe gently so you dont burn it.. Finish your rip put out your lighter.. blow out.. then this is what I do but you dont have to.. blow the vapor out of the pipe gently then wipe your pipe on the bottom of your pants if it has the black stuff that builds on stuff from flames.. I dont know what its called..
That is the best way I can describe it.. It takes practice but enough drugs and you will learn it
Thanks for the reply. That is some good advice. I actually have a handblown pipe made for this purpose coming in about 3 weeks. I am just practicing with a lightbulb in the meantime. Luckily I have a little more than 2 grams left
Your description on the process was well detailed and I appreciate it.
--------------------
|
Dephect




Registered: 08/10/07
Posts: 1,779
|
Re: vaporizing DMT through glass with a flame...when to take the flame away? [Re: WWorker]
#7818624 - 12/31/07 10:58 PM (16 years, 1 month ago) |
|
|
No problem.. I learned from smokin tweak everyday for about a year.. I couldnt control myself but I got over that problem and now its just a social thing.. I dont know what it is but since Ive broken addictions to coke and meth I dont really get hooked anymore..
I do my best.. But not like I used too..
|
Robo
R Series 66Y
Registered: 05/08/07
Posts: 14,861
|
Re: vaporizing DMT through glass with a flame...when to take the flame away? [Re: Dephect]
#7818649 - 12/31/07 11:05 PM (16 years, 1 month ago) |
|
|
Stims will make you effin crazy
|
Dephect




Registered: 08/10/07
Posts: 1,779
|
Re: vaporizing DMT through glass with a flame...when to take the flame away? [Re: Robo]
#7818748 - 01/01/08 12:00 AM (16 years, 1 month ago) |
|
|
Oh man I know..Happy New Year! Im so fuckin drunk right now..
And remember you can hold it in if you want.. It will get you more fucked up..
|
Feanor


Registered: 05/07/06
Posts: 1,546
|
Re: vaporizing DMT through glass with a flame...when to take the flame away? [Re: Dephect]
#7818888 - 01/01/08 01:37 AM (16 years, 1 month ago) |
|
|
Quote:
Dephect said: And remember you can hold it in if you want.. It will get you more fucked up..
There's something a bit stupid about that sentence, good sir!
-----------
Anywho, I prefer to vaporize my DMT for quite a long time before removing the flame and taking the first hit. I like to keep the flame going until I hear the little glass pipe "screaming." After you hear that noise, turn off the flame and take your first hit.
I've personally sometimes allowed the flame to touche the glass. I've never had any problems. I use a freebase pipe, your common, everyday freebase pipe. You just want to make sure that the flame never goes through the carb.
Good luck on your travels!
--------------------
May Terence McKenna Live Long The DMT Chronicles
|
Dephect




Registered: 08/10/07
Posts: 1,779
|
Re: vaporizing DMT through glass with a flame...when to take the flame away? [Re: Feanor]
#7818894 - 01/01/08 01:41 AM (16 years, 1 month ago) |
|
|
well did ya read the sentence aboove it?
|
MYSTIQUE
Say Hi to the elves for me.




Registered: 04/28/07
Posts: 1,764
Loc: Canada
Last seen: 5 years, 4 months
|
Re: vaporizing DMT through glass with a flame...when to take the flame away? [Re: Dephect]
#7819702 - 01/01/08 11:21 AM (16 years, 1 month ago) |
|
|
They sell DMT bulb pipes by my place for 9 bucks drop me a mesg if ya need one. Don't want to see ya burn yourself. pic from the store.
-------------------- Dont know what the fuck I just said? READ THIS http://www.shroomery.org/5122/The-Shroomery-Mushroom-Glossary I ain't a hippy but I'm covered in dirt Sippin lots of mushroom tea in a tye-dye shirt Chasin' the Grateful Dead, no shoes on my feet Beggin' in the parking lot for something to eat, DO NOT USE FIRE IN YOUR GLOVE BOX!!!!!!!
|
|