Welcome to the Shroomery Message Board! You are experiencing a small sample of what the site has to offer. Please login or register to post messages and view our exclusive members-only content. You'll gain access to additional forums, file attachments, board customizations, encrypted private messages, and much more!
|
 podman19
newbie
Registered: 03/18/02
Posts: 47
Last seen: 16 years, 4 months
|
 Steaming and Inoculation questions 
#592253 - 03/28/02 10:06 PM (16 years, 5 months ago) |
|
|
i plan on sterilizing my jars by boiling them in a pot for an hour. does the size of the pot matter at all? the pot will hold about six 1/2 pint jars, but i wasnt sure if the heat would break the jars in that small of a pot.
Do i leave the holes in the lids open during steaming or put tape on them? the jars wont explode with tape on them?
After steaming while the jars are cooling and waiting for inoculation, is it better to leave the tape on or take it off?
When i am inoculating my 10 jars, do i have to sterilize the needle of the syringe with a flame everytime i do a jar?
How far down in do i put the needle into the jar? Do i actually penetrate the BRF and verm. or do i just put the tip of the needle on the inside lip of the jar and let it run down the sides?
|
quack180
journeyman
Registered: 01/29/02
Posts: 89
Loc: new england
Last seen: 15 years, 6 months
|
Re: Steaming and Inoculation questions [Re: podman19]
#592263 - 03/28/02 10:13 PM (16 years, 5 months ago) |
|
|
I'm not gonna lecture you- but someone's about to. *waits and watches patiently*
--------------------
weed is for smoking
|
podman19
newbie
Registered: 03/18/02
Posts: 47
Last seen: 16 years, 4 months
|
Re: Steaming and Inoculation questions [Re: quack180]
#592268 - 03/28/02 10:19 PM (16 years, 5 months ago) |
|
|
why? did i say something wrong? let me guess, i need to go back and read the teks...well i keep reading them and they arent all the same, so i get confused and i just find it easier to come to the forum and ask you guys cause you all seem to know so much about all of this
|
 WakingUpLate
addict
Registered: 12/29/01
Posts: 559
Loc: Born on a mountain, Raise...
|
Re: Steaming and Inoculation questions [Re: podman19]
#592394 - 03/29/02 01:15 AM (16 years, 5 months ago) |
|
|
Ok, noone's took it yet so here goes, lecture free.
1)as far as I know, the size of the pot doesn't matter. Just
keep the jars up off the bottom.
2) tape the holes, leave lids loose
3)leave the tape on, snug the lids
4)some do, I don't. no problems yet
5)past the verm, against the glass
6)yes, penetrate the substrate
If teks conflict with each other, stick to this one: http://www.erowid.org/plants/mushrooms/mushrooms_mmgg.shtml
Hope that helps. 
Free Spore Ring
--------------------
The rest of those, who have gone before us,
cannot settle the unrest of those who follow.
(Finding Forrester)
|
Jammer
Computers areMORE Addictive!
Registered: 11/05/00
Posts: 3,998
Loc: (God's Country) - USA
Last seen: 12 years, 11 months
|
 Re: Steaming and Inoculation questions [Re: podman19]
#592395 - 03/29/02 01:19 AM (16 years, 5 months ago) |
|
|
When in doubt, stick to the PF tek as closely as possible. Then you can look at other teks.
--------------------
>>Jammer>>
|
WakingUpLate
addict
Registered: 12/29/01
Posts: 559
Loc: Born on a mountain, Raise...
|
Re: Steaming and Inoculation questions [Re: Jammer]
#592405 - 03/29/02 01:37 AM (16 years, 5 months ago) |
|
|
I almost used the link for the PF tek ( www.fanaticus.com )
but when I started, I read the PF Tek four times and still had
questions. I asked PF. He basically said "buy the new book"
Then I found the MMGG (Magic Mushroom Growers Guide)
which filled in the missing details. But I did't know about the
shroomery back then.
Free Spore Ring
--------------------
The rest of those, who have gone before us,
cannot settle the unrest of those who follow.
(Finding Forrester)
|
Baby_Hitler
Errorist
Registered: 03/06/02
Posts: 23,140
Loc: To the limit!
Last seen: 1 hour, 18 minutes
|
Re: Steaming and Inoculation questions [Re: WakingUpLate]
#592410 - 03/29/02 01:50 AM (16 years, 5 months ago) |
|
|
Can you tell me if it is better to use a short forcefull burst when injecting spores or a long slow stream?
Oops, should I have posted that in advanced? ...lolzzz
--------------------
|
WakingUpLate
addict
Registered: 12/29/01
Posts: 559
Loc: Born on a mountain, Raise...
|
Re: Steaming and Inoculation questions [Re: Baby_Hitler]
#592428 - 03/29/02 02:09 AM (16 years, 5 months ago) |
|
|
I wouldn't think it would make much difference. But I would
suggest watching the plunger cross the cc marks until you
get a feel for how much it takes per hole or you might run low
on spore water too soon. If this does happen, try to catch it
early and draw up some sterile water, and shake it. If you
can see spores at all, it shouldn't hurt it a bit. Just try not to
let the spores settle to the needle and go out on the first few
jars. Hope that helps.
Free Spore Ring
--------------------
The rest of those, who have gone before us,
cannot settle the unrest of those who follow.
(Finding Forrester)
| |
|
|
You cannot start new topics / You cannot reply to topics
HTML is disabled / BBCode is enabled
Moderator: Roadkill, Magash, Shroomism, george castanza, RogerRabbit, Citric, total, FooMan, 13shrooms, stonesun, cronicr, PussyFart, Tmethyl, Pastywhyte, bodhisatta
1,130 topic views. 25 members, 135 guests and 14 web crawlers are browsing this forum.
[ Toggle Favorite | Print Topic | Stats ]
| | |
|
|
|
Threaded
Previous
Index
Next
Edit 
Reply 
