Home | Community | Message Board


This site includes paid links. Please support our sponsors.


Welcome to the Shroomery Message Board! You are experiencing a small sample of what the site has to offer. Please login or register to post messages and view our exclusive members-only content. You'll gain access to additional forums, file attachments, board customizations, encrypted private messages, and much more!

Shop: Mushroom-Hut Substrate Mix   Kraken Kratom Red Vein Kratom

Jump to first unread post Pages: 1
Some of these posts are very old and might contain outdated information. You may wish to search for newer posts instead.
OfflineLearning2Much
One Step @ aTime
Registered: 08/25/05
Posts: 86
Last seen: 17 years, 8 months
Fruting Chamber Question - Perl lite and air pump
    #5382212 - 03/09/06 05:17 PM (17 years, 10 months ago)

I have read from a post that you do not want the Perl lite sitting in standing water ( Only saturated in water) However, I was thinking about adding a bubbler and air pump in standing water and put pear lite over top. What types of problems if any would i Have with this set up or is this a good idea?

Any ideas would be appreciated!


Extras: Filter Print Post Top
OfflineLearning2Much
One Step @ aTime
Registered: 08/25/05
Posts: 86
Last seen: 17 years, 8 months
Re: Fruting Chamber Question - Perl lite and air pump [Re: Learning2Much]
    #5382225 - 03/09/06 05:19 PM (17 years, 10 months ago)

- I thought I should mention this is for casings not cakes.

If some of you have came across some great post in the past for a fruiting camber for casings ( More automatic the BETTER!) If you would post them, that would be great.

THANKS!!


Extras: Filter Print Post Top
OfflineLearning2Much
One Step @ aTime
Registered: 08/25/05
Posts: 86
Last seen: 17 years, 8 months
Re: Fruting Chamber Question - Perl lite and air pump [Re: Learning2Much]
    #5382264 - 03/09/06 05:28 PM (17 years, 10 months ago)

- Here is the setup for the fruiting chamber I was thinking about. I would like to run it by some of you for ideas that others can use for themselves as well.

Large rubber maid bin, app. 4 ft wide by 1.5 ft tall. 5 drilled air holes in the top for gas exchange app. 1 in. in diameter covered by coffee filter taped on with duck tape. 3 Inches of perlite and app. 1.5 of water. Under the layer of perlite a air pump connected to the bubbler. - Did not know if an cool mist humidifier would produce too much humidity for casings. What improvements would you make if this was your set up for casings? What have you done that works or might not?

Thanks for all the input, I really do appreciate it.


Extras: Filter Print Post Top
Offlinehyphae
born to grow
 User Gallery

Registered: 12/13/02
Posts: 6,228
Loc: the rain forests
Last seen: 12 years, 8 months
Trusted Cultivator
Re: Fruting Chamber Question - Perl lite and air pump [Re: Learning2Much]
    #5382375 - 03/09/06 05:57 PM (17 years, 10 months ago)

I've always used water at half the depth of the perlite without ever a problem and always had plenty of humidity. Your setup should work just fine. When I used tubs I did have a coolmist connected to two units (tubs) with perlite humidification when doing casings, the coolmist provided plenty of RH in combination with the perlite.


--------------------
Getting the most out of your casings!, A pinning strategy.
Oyster Shell "Flour" $2 for 1lb. a hell of a deal :wink:
Not what is overlay but rather what overlay is
Gas Exchange vs. FAE

"We all have priorities. I used a closet once setup a nice little lab trouble was all the shit that was in there ended up in the bedroom that pissed off the GF then I ended up dumping her as she was getting in the way of my sterile culture technique! Ya I got priorities too!!!"


Extras: Filter Print Post Top
OfflineLearning2Much
One Step @ aTime
Registered: 08/25/05
Posts: 86
Last seen: 17 years, 8 months
Re: Fruting Chamber Question - Perl lite and air pump [Re: hyphae]
    #5382495 - 03/09/06 06:25 PM (17 years, 10 months ago)

Hyphea, I saw that you used Oyster Shell flower in your post. Where in the world would you find that stuff?


Extras: Filter Print Post Top
Offlinehyphae
born to grow
 User Gallery

Registered: 12/13/02
Posts: 6,228
Loc: the rain forests
Last seen: 12 years, 8 months
Trusted Cultivator
Re: Fruting Chamber Question - Perl lite and air pump [Re: Learning2Much]
    #5384488 - 03/10/06 05:48 AM (17 years, 10 months ago)

Oyster Shell "Flour" $2 for 1lb. a hell of a deal :wink:


--------------------
Getting the most out of your casings!, A pinning strategy.
Oyster Shell "Flour" $2 for 1lb. a hell of a deal :wink:
Not what is overlay but rather what overlay is
Gas Exchange vs. FAE

"We all have priorities. I used a closet once setup a nice little lab trouble was all the shit that was in there ended up in the bedroom that pissed off the GF then I ended up dumping her as she was getting in the way of my sterile culture technique! Ya I got priorities too!!!"


Extras: Filter Print Post Top
Invisibledoubledutch
Morado PR

Registered: 07/19/05
Posts: 266
Loc: Puerto Rico
Re: Fruting Chamber Question - Perl lite and air pump [Re: hyphae]
    #5384656 - 03/10/06 08:08 AM (17 years, 10 months ago)

Any time your perlite is submerged, you might as well be using gravel or human bones ~ cause it isn't doing much.


--------------------
"A delightful, wholesome experience for the family." - Desson Thomson, THE WASHINGTON POST

http://www.shroomery.org/forums/showflat...rue#Post5481456

omfg~dutch!


Extras: Filter Print Post Top
Offlinethenewguy05
The Mushroom Man
 User Gallery

Registered: 02/11/05
Posts: 2,123
Loc: My Underground Layer
Last seen: 2 years, 5 months
Re: Fruting Chamber Question - Perl lite and air pump [Re: doubledutch]
    #5384708 - 03/10/06 08:44 AM (17 years, 10 months ago)

i think the air pump is for air exchange.
you won't have to open the lid again until harvest or the water level goes down too far.


Extras: Filter Print Post Top
OfflineLearning2Much
One Step @ aTime
Registered: 08/25/05
Posts: 86
Last seen: 17 years, 8 months
Re: Fruting Chamber Question - Perl lite and air pump [Re: thenewguy05]
    #5386695 - 03/10/06 04:57 PM (17 years, 10 months ago)

So... if the perlite is useless under the water, could you separate the air pump from the perlite. I don't want to waste perlite if i don't have too, but I like the idea of having an air pump so I don't have to fan it all the time.

ideas?


Extras: Filter Print Post Top
InvisibleMindsEye
AMT Fiend
Male

Registered: 02/20/06
Posts: 645
Loc: cerebral cortex
Re: Fruting Chamber Question - Perl lite and air pump [Re: Learning2Much]
    #5386721 - 03/10/06 05:04 PM (17 years, 10 months ago)

Ok your confused I use the same setup PMP, You dont want to be able to see the water line from the top of pearlite line, fill with water until it is an inch from the surface of pearlite.


--------------------
Easy Poo Cake Tek


Edited by MindsEye (03/10/06 05:05 PM)


Extras: Filter Print Post Top
Invisiblecappa
Nerd
Registered: 02/12/06
Posts: 854
Re: Fruting Chamber Question - Perl lite and air pump [Re: MindsEye]
    #5386730 - 03/10/06 05:09 PM (17 years, 10 months ago)

Just use human bones.. I do!
:smile:


--------------------
Their are 10 types of people. Those that understand binary, and those who don't.
~Cappa.


Extras: Filter Print Post Top
Offlinehyphae
born to grow
 User Gallery

Registered: 12/13/02
Posts: 6,228
Loc: the rain forests
Last seen: 12 years, 8 months
Trusted Cultivator
Re: Fruting Chamber Question - Perl lite and air pump [Re: cappa]
    #5386747 - 03/10/06 05:18 PM (17 years, 10 months ago)

Quote:

cappa said:
Just use human bones.. I do!
:smile:



LOL!!!  :thumbup:


--------------------
Getting the most out of your casings!, A pinning strategy.
Oyster Shell "Flour" $2 for 1lb. a hell of a deal :wink:
Not what is overlay but rather what overlay is
Gas Exchange vs. FAE

"We all have priorities. I used a closet once setup a nice little lab trouble was all the shit that was in there ended up in the bedroom that pissed off the GF then I ended up dumping her as she was getting in the way of my sterile culture technique! Ya I got priorities too!!!"


Extras: Filter Print Post Top
Jump to top Pages: 1

Shop: Mushroom-Hut Substrate Mix   Kraken Kratom Red Vein Kratom


Similar ThreadsPosterViewsRepliesLast post
* fruting chamber question...easy answer axtv 524 1 11/02/02 09:39 PM
by shroomologist
* Fruiting Chamber Question Anonymous 5,615 3 03/09/02 05:06 PM
by WakingUpLate
* Fruiting chamber question Shtoops 764 2 10/28/02 11:24 AM
by MAIA
* would this work in a fruting chamber? axtv 716 3 10/02/02 05:21 PM
by mickey_rourke
* Fruting Chamber Modification no money mods indicaz 813 2 06/04/02 12:53 PM
by DreaMaTrix
* Incubation Chamber question CrzyMoFuCkEr420 1,086 3 10/06/02 07:50 PM
by Skikid16
* Cheap-ass (temporary) dessicant chamber question shroominbloom 1,971 10 01/29/03 10:10 PM
by Jackal
* Growing Chamber Questions FreelanceDSM 985 6 10/05/02 12:46 PM
by whiterastahippie

Extra information
You cannot start new topics / You cannot reply to topics
HTML is disabled / BBCode is enabled
Moderator: Shroomism, george castanza, RogerRabbit, veggie, mushboy, fahtster, LogicaL Chaos, 13shrooms, Stipe-n Cap, Pastywhyte, bodhisatta, Tormato, Land Trout, A.k.a
831 topic views. 23 members, 198 guests and 58 web crawlers are browsing this forum.
[ Show Images Only | Sort by Score | Print Topic ]
Search this thread:

Copyright 1997-2024 Mind Media. Some rights reserved.

Generated in 0.025 seconds spending 0.009 seconds on 14 queries.