Home | Community | Message Board


Azarius
Please support our sponsors.

Mushrooms, Mycology and Psychedelics >> Mushroom Cultivation

Welcome to the Shroomery Message Board! You are experiencing a small sample of what the site has to offer. Please login or register to post messages and view our exclusive members-only content. You'll gain access to additional forums, file attachments, board customizations, encrypted private messages, and much more!

Amazon Shop for: ½ Pint Jars, Agar, Autoclave, Impulse Sealer

Jump to first unread post. Pages: 1
Offlinedmc_
211
 Arcade Champion: Madness

Registered: 12/24/03
Posts: 559
Loc: Portland, OR
Last seen: 11 years, 4 months
Prints to syringe
    #3657053 - 01/21/05 03:26 AM (12 years, 1 month ago)

I know my method. How do you all transfer your prints to syringe? I ussually just scrape my prints into my jars. (pretty drunk right now)

thanks,
dmc


Edited by dmc_ (01/21/05 03:27 AM)


Post Extras: Print Post  Remind Me! Notify Moderator
Offline13eetleJuice
the ghost with the most
Male

Folding@home Statistics
Registered: 10/29/04
Posts: 2,253
Loc: 6' under pushin up shroom...
Last seen: 5 years, 1 month
Re: Prints to syringe [Re: dmc_]
    #3657080 - 01/21/05 03:33 AM (12 years, 1 month ago)

Squirt boiled (and allowed to cool) water into a ziploc bag. Scrape spores off foil with my fingernail. Clean ziploc with alcohol swab at corner. Insert needle and withdraw spore solution. Viola, my spore syringe.


--------------------


Post Extras: Print Post  Remind Me! Notify Moderator
Invisibleohmatic
searcher
 User Gallery

Registered: 02/28/04
Posts: 6,742
Loc: europe
Trusted Cultivator
Re: Prints to syringe [Re: 13eetleJuice]
    #3657092 - 01/21/05 03:37 AM (12 years, 1 month ago)

wrap shotglass in tinfoil, wrap syringe in tinfoil, wrap scalpell in tinfoil
and load that stuff to the pc.

pc for 20 mins @ 15psi.
reduce heat so u can open the pc and remove content but KEEP WATER BOILING.

draw up boiling STERILE water to syringe couple times and
shoot it back out, finally seal it with water inside and let it cool.

unwrap shotglass/scalpell, scratch spores, shoot in half of syringe water,
stirr with needle, draw up, repeat - et voila.

DA FUNKAAAAY SYRINGOOORRR :laugh:
peace ohm :mushroom2:


--------------------
:penis: MONOTUB tek :sun: HEATBOMB tek :penis:

RIP #cultivation! ....can't associate? well FUCK U !


Post Extras: Print Post  Remind Me! Notify Moderator
Invisibleagar
old hand
 User Gallery

Registered: 11/21/04
Posts: 9,056
Loc: Somewhere Else
Trusted Cultivator
Re: Prints to syringe [Re: dmc_]
    #3657239 - 01/21/05 04:47 AM (12 years, 1 month ago)

Make prints on autoclave bag material. Once layed & dry, lay another same size piece over top & use impulse sealer to seal all four sides.

To extract, use syringe needle to puncture one side of print bag on corner, inject 10 / 20 ml of sterile water, rub bag with fingers - spores go into solution. Asperate with syringe.


--------------------


Post Extras: Print Post  Remind Me! Notify Moderator
InvisibleBurke Dennings

Registered: 11/29/04
Posts: 78,143
Re: Prints to syringe [Re: agar]
    #3657278 - 01/21/05 05:08 AM (12 years, 1 month ago)

agar, that is a great idea! I would've never thought of that...thanks!


--------------------
This will not go undocumented.


Post Extras: Print Post  Remind Me! Notify Moderator
OfflinekronnyQ
SuperstudExtraordinaire
 User Gallery

Registered: 07/23/04
Posts: 2,488
Loc: Anytown USA
Last seen: 7 months, 13 days
Re: Prints to syringe [Re: Burke Dennings]
    #3657307 - 01/21/05 05:38 AM (12 years, 1 month ago)

Scrape spores off with your fingernail?!!

Do you have ANY idea how many bugs and contaminants are under your fingernail?! :laugh:


Post Extras: Print Post  Remind Me! Notify Moderator
Offlinelepiota
expert infailures
 User Gallery

Registered: 10/27/04
Posts: 266
Loc: Europe
Last seen: 9 years, 9 months
Re: Prints to syringe [Re: kronnyQ]
    #3657359 - 01/21/05 06:15 AM (12 years, 1 month ago)

- clean well a small coffee cup with disinfectant
- scrape spores into the cup with a scalpel (pre-sterilized with fire)
- boil water, and suck boiling water in a sterile (=new) syringe
- squirt water into the cup and stir using the syringe needle
- suck water mixed with spores in the syringe
- also suck some air into the syringe (taking air from inside a flame)
- put cap to needle and shake syringe
- store in a clean place for 24 hours before use


--------------------
SUPPORT YOUR LOCAL FSR!


Post Extras: Print Post  Remind Me! Notify Moderator
Invisibletripndicular
My Minds Eye IsRhizomorphic

Registered: 08/25/02
Posts: 2,791
Loc: Bowels of HELL
Re: Prints to syringe [Re: dmc_]
    #3671660 - 01/24/05 11:11 AM (12 years, 1 month ago)

Think ... Reynolds non stick aluminum foil , spores do not stick to it for shit , so is very easy to pour into syringe body , then suck in water to make a soulution . The only problem with this stuff is when you open your little foil pouch you must be carefull to not spill spores all over the damn place .


--------------------
Any information I give is not intended to aide you in the production of potentialy illegal substances !None of my exp comes from growing illegal varities , so take it as you will .
So with that said here is our mission statement .

Then the priest fell into a trance or swoon,& said unto the Queen of heaven ; Write unto us the ordeals; write unto us the rituals; write unto us the law !


Post Extras: Print Post  Remind Me! Notify Moderator
InvisiblePrisoner#1M
Even Dumber ThanAdvertized!
 User Gallery

Registered: 01/22/03
Posts: 193,414
Loc: Pvt. Pubfag NutSuck
Trusted Cultivator
Re: Prints to syringe [Re: tripndicular]
    #3671674 - 01/24/05 11:23 AM (12 years, 1 month ago)

Quote:

tripndicular said:
Think ... Reynolds non stick aluminum foil , spores do not stick to it for shit , so is very easy to pour into syringe body , then suck in water to make a soulution .




thats a really bad way to make a syringe...


Post Extras: Print Post  Remind Me! Notify Moderator
Invisibletripndicular
My Minds Eye IsRhizomorphic

Registered: 08/25/02
Posts: 2,791
Loc: Bowels of HELL
Re: Prints to syringe [Re: Prisoner#1]
    #3671783 - 01/24/05 12:15 PM (12 years, 1 month ago)

Yeah I kinda said it backwards huh ?
But you get the idea . Non stick foil = no scraping , and less spores left behind . :thumbup: :wink:
PS I hate syringes , nothing like agar for me  :wink:
Just trying to get folks to try the foil , when they take prints .


--------------------
Any information I give is not intended to aide you in the production of potentialy illegal substances !None of my exp comes from growing illegal varities , so take it as you will .
So with that said here is our mission statement .

Then the priest fell into a trance or swoon,& said unto the Queen of heaven ; Write unto us the ordeals; write unto us the rituals; write unto us the law !


Edited by tripndicular (01/24/05 12:16 PM)


Post Extras: Print Post  Remind Me! Notify Moderator
OfflineMushroomFriend
Vargen ska fanleva!!
Male User Gallery

Registered: 10/12/04
Posts: 4,055
Loc: The Druid Peak Pack.
Last seen: 1 year, 2 months
Re: Prints to syringe [Re: dmc_]
    #3671816 - 01/24/05 12:29 PM (12 years, 1 month ago)

OK "Syringe TEK a la MF"! :lol:

- small sterilized jar with hole in tyvek/polyfill lid
- put lid on loose
- insert a mushroomcap with "pincet" or a alcohol cleaned nail in the cap
- put lid back and screw
- after 24 hours take cap out of it with pincet or take it by the nail
- scrape the spores with scalpel
- close lid again
- you have a sterilised syringe with sterile water ready
- squirt through the hole and tyvek / polyfill in the jar
- shake the jar (better with tyvek)
- suck back in syringe

VWALA! :laugh:

MF


--------------------


Post Extras: Print Post  Remind Me! Notify Moderator
Jump to top. Pages: 1

Amazon Shop for: ½ Pint Jars, Agar, Autoclave, Impulse Sealer

Mushrooms, Mycology and Psychedelics >> Mushroom Cultivation

Similar ThreadsPosterViewsRepliesLast post
* I am scared to do a Print/syring! fearforce7 4,303 18 02/24/17 09:11 PM
by mushpunx
* spore prints to syringe help! exzile 2,068 6 12/08/08 08:28 AM
by veda_sticks
* spore print greatlakes 1,010 18 08/29/05 11:30 PM
by theBRINK
* prints on foil, want to put them in syringe
( 1 2 all )
CubensisCutter 1,799 21 12/23/08 11:56 PM
by J3illy
* storage of prints XAZIA 2,709 11 01/25/05 02:20 PM
by PlaCoFuGostei
* confused when making a syringe from print. Mdubya 1,210 12 12/12/02 04:52 PM
by KegTheRipper
* making filling syringes from prints.... WWorker 733 8 09/11/07 12:28 AM
by Phreakr
* Making a spore print... hellucinogen 1,011 4 01/19/08 05:29 AM
by galadar

Extra information
You cannot start new topics / You cannot reply to topics
HTML is disabled / BBCode is enabled
Moderator: Magash, Shroomism, george castanza, Prisoner#1, RogerRabbit, Citric, total, FooMan, 13shrooms, stonesun, EvilMushroom666, cronicr, PussyFart, Tmethyl
701 topic views. 29 members, 116 guests and 28 web crawlers are browsing this forum.
[ Toggle Favorite | Print Topic | Stats ]
Search this thread:
RVF Garden Supply
Please support our sponsors.

Copyright 1997-2017 Mind Media. Some rights reserved.

Generated in 0.04 seconds spending 0.003 seconds on 14 queries.