Home | Community | Message Board


Vaposhop
Please support our sponsors.

Mushrooms, Mycology and Psychedelics >> Mushroom Cultivation

Welcome to the Shroomery Message Board! You are experiencing a small sample of what the site has to offer. Please login or register to post messages and view our exclusive members-only content. You'll gain access to additional forums, file attachments, board customizations, encrypted private messages, and much more!

Amazon Shop: Air Pump

Jump to first unread post. Pages: 1
Offlinenegative
Positive
Registered: 07/07/04
Posts: 120
Last seen: 12 years, 4 months
questrion regarding setup
    #2961899 - 08/03/04 11:17 PM (13 years, 10 months ago)

ok, i just need to verify that this will work ok.

For my air pump housing i have a large rubbermaid container that it fits in. there is one hole for the outgoing air, one hole for the plug and one large hole (covered w/ 2 90% dust masks and glued down w/ silicone). All holes a re sealed and soon the lid willn be too. Will this suffice? please help thanks.
also i decided tom pressure cook the geolite in small batches then do my shit.


Post Extras: Print Post  Remind Me! Notify Moderator
InvisiblePsyllyMe
LOST.......
Registered: 07/25/04
Posts: 848
Loc: Center of the Known Unive...
Re: questrion regarding setup [Re: negative]
    #2961980 - 08/03/04 11:40 PM (13 years, 10 months ago)

Well I have a 427 cobra jet, in a 67 mustang, now the factory air is workin fine but, the wind wings seem to be stuck in the closed position.......So I bought a can of WD40 ........I was thinking about spraying it into the gas tank to loosen up the heater motor.......

will that work?

there are so many good informative teks here why dont you just search them and learn something.........IMO its more than half the fun........

peace


Post Extras: Print Post  Remind Me! Notify Moderator
InvisiblePrisoner#1
Even Dumber ThanAdvertized!
 User Gallery

Registered: 01/22/03
Posts: 193,665
Loc: Pvt. Pubfag NutSuck
Trusted Cultivator
Re: questrion regarding setup [Re: negative]
    #2962057 - 08/03/04 11:58 PM (13 years, 10 months ago)

Quote:

negative said:
ok, i just need to verify that this will work ok.

For my air pump housing i have a large rubbermaid container that it fits in. there is one hole for the outgoing air, one hole for the plug and one large hole (covered w/ 2 90% dust masks and glued down w/ silicone). All holes a re sealed and soon the lid willn be too. Will this suffice? please help thanks.




it may be a bit of over kill... a couple of inline filter made from 35mm film canisters and polyfill with a couple of little brass fittins will help to prevent conensation and will clean your incoming air, other than that it does sound like it will work, careful with using the silicon, it can cause some wierd mutants because of the VOCs it releases as it cures, it usualy takes several days.


Quote:

also i decided tom pressure cook the geolite in small batches then do my shit.




it's not really needed but it is a good safety precaution, a great deal depends on how it's packaged after production, but normaly it's sterile in the bags


Post Extras: Print Post  Remind Me! Notify Moderator
OfflineKonkeyDong
newbie
Registered: 07/08/04
Posts: 45
Last seen: 13 years, 10 months
A little off topic.... [Re: Prisoner#1]
    #2962542 - 08/04/04 01:28 AM (13 years, 10 months ago)

I am thinking of using an airstone immersed about 4 inches deep in 3% h2o2 to bring air into my chamber. I am also thinking of using a fermentation airlock to allow a one-way release of gas.

Do you guys think that the h2o2 will be able to kill any contams that the pump sends into the chamber?

I'm sure that if this worked, somebody would have wrote a tek for it. Someone please tell me why my plan sucks.


Post Extras: Print Post  Remind Me! Notify Moderator
Jump to top. Pages: 1

Amazon Shop: Air Pump

Mushrooms, Mycology and Psychedelics >> Mushroom Cultivation

Similar ThreadsPosterViewsRepliesLast post
* RUBBERMAID TERRIUM vs 20 GAL AQUARIUM? PooGrower 1,444 12 12/18/02 07:48 PM
by NSKiller
* Rubbermaid Roughneck fruiting chamber setup susej 3,828 5 08/05/02 08:02 PM
by Killa420
* help please w/ rubbermaid tub & air pump bubbler *DELETED* LuvWallyWorld 521 5 11/21/04 04:20 AM
by atomic1
* Your ideas on my ideas on terrarium setup Anonymous 1,963 8 09/03/02 06:15 PM
by seattlekid
* Terrarium Setup. Humidity problem Under_net 1,415 3 01/09/02 03:23 PM
by Under_net
* Awesome rye grain h2o2 tek dimitri211 5,609 1 08/17/01 10:28 PM
by jonnyshaggs420
* My first setup... Suggestions? GernBlanston 861 9 09/08/03 11:01 PM
by GernBlanston
* Grow Chamber Setup, few questions
( 1 2 all )
Ghosty 3,250 26 12/09/02 10:36 PM
by cheifdog24

Extra information
You cannot start new topics / You cannot reply to topics
HTML is disabled / BBCode is enabled
Moderator: Roadkill, Magash, Shroomism, george castanza, RogerRabbit, Citric, total, FooMan, 13shrooms, stonesun, cronicr, PussyFart, Tmethyl, Pastywhyte, bodhisatta
328 topic views. 30 members, 122 guests and 24 web crawlers are browsing this forum.
[ Toggle Favorite | Print Topic | Stats ]
Search this thread:
Vesp.co, Inc.
Please support our sponsors.

Copyright 1997-2018 Mind Media. Some rights reserved.

Generated in 0.03 seconds spending 0.008 seconds on 19 queries.