Home | Community | Message Board


Everything Mushrooms
Please support our sponsors.

Mushrooms, Mycology and Psychedelics >> Mushroom Cultivation >> Mushroom Cultivation Archive >> Agar and Liquid Culture

Welcome to the Shroomery Message Board! You are experiencing a small sample of what the site has to offer. Please login or register to post messages and view our exclusive members-only content. You'll gain access to additional forums, file attachments, board customizations, encrypted private messages, and much more!

Amazon Shop for: Agar, Paul Stamets, Petri Dish

Jump to first unread post. Pages: 1
InvisibleATWAR
Connoisseur

Registered: 01/26/03
Posts: 1,640
Loc: #108768 in line...
Agar sandwich isolation TEK... * 3
    #2894662 - 07/15/04 09:38 PM (12 years, 4 months ago)

This method is briefly outlined in Growing Gourmet and Medicinal Mushrooms by Paul Stamets, but it is not illustrated in the book. This method works very well for the isolation from bacterial contaminants. Not only is the growth of bacteria inhibited by the Antibiotic agar, the mycelium is forced to penetrate through the media instead of across the surface, thus leaving the bacteria behind.

First you need the supplies:

10% peroxide solution - optional (10ml 3% peroxide diluted with 90ml water)
Sharp scalpel or knife
Inoculation loop
Fire (for flame sterilizing the loop)
2 Petri?s of Antibiotic Agar. (10mg Gentamicin per 200ml Agar and 2ml 3% peroxide is illustrated here ? Peroxidated agar optional). Both plates should be poured fairly thin to allow adequate room for the sandwich.




First, flame your inoculation loop and cool it by dipping it into the center of the transfer dish. Rescue the healthiest looking mycelium from the wedge, as far away from the bacterial contamination as possible. Try to get an area of 1cm square of mycelium, but do not get any agar. Scrape the mycelium free using your inoculating loop. Here scraping of mycelium from the surface of a plastic bag is illustrated.




Place the rescued mycelium in the center of the plate you used for cooling the loop (into the melted divot) after dipping into the peroxide solution. It is very important to not get any agar in the previous step so the mycelium will lie flat, allowing it to be sealed under the sandwich. Be very careful not to smear the transfer around on the plate, or spread excess peroxide across the surface. You can omit the peroxide but I use it as an additional safety measure. Be sure that if you do use peroxide, you change it between each transfer to avoid cross-contamination.




Cut a 1 inch (3cm) square from the other antibiotic agar plate you have. It is best to pour the agar thin for this plate, so you can see through it, and it is easy for the mycelium to grow through. I recommend at least 1/16th inch minimum thickness (1.5-2mm) and a 1/8th inch maximum (3-4mm). It is also important to make this agar not only thin, but soft as well. You can accomplish this by reducing the agar concentration, but I find the typical recipes to be fine for this purpose (2% agar).




Place the square piece you removed earlier onto the rescued mycelium fragment. Making sure to cover it all, and making sure all edges of the agar sandwich are contacting the lower agar. Be very careful to not smear anything around, spreading possible contamination. Basically you want to seal the contaminated mycelium between the two pieces. Seal the petri and incubate as required for your species.




After a few days mycelium will penetrate through the upper piece. It may take as long as a week or more. Once it pokes through and appears healthy, it is a good sign you now have pure mycelium (contaminant free). Now it is important to keep a careful eye on the colonization to watch for weak growth, or stalling.



(This is Hypsizygus ulmarius)

After a few more days, the mycelium will grow along the surface and crawl down the edge to the base agar. It is important to watch for even growth down onto the bottom layer. If it gets to that point and stops (or stalls), it may indicate that bacteria has crawled out from between the sandwich. Once it completely colonizes the dish, take a transfer 2-3cm away from the edge of the petri to ensure the cleanest tissue...

There you have it; it works very well to keep bacteria from crawling along with your mycelium, and reduces the chances of airborne cross-contamination when the bacteria are sealed under the agar. When working with a contaminated petri, this method will guarantee you will only need one transfer to antibiotic agar. Mycelium from this plate can inoculate standard media recipes without antibiotics or peroxide.

By ATWAR


--------------------
To give is to live...



Post Extras: Print Post  Remind Me! Notify Moderator
InvisibleEffedS
 User Gallery

Registered: 05/15/02
Posts: 7,364
Loc: Daylight Slavings
Re: Agar sandwich isolation TEK... [Re: ATWAR]
    #2895558 - 07/16/04 01:34 AM (12 years, 4 months ago)

Very well put together, you always impress me ATWAR.  :thumbup:


Post Extras: Print Post  Remind Me! Notify Moderator
InvisibleATWAR
Connoisseur

Registered: 01/26/03
Posts: 1,640
Loc: #108768 in line...
Re: Agar sandwich isolation TEK... [Re: Effed]
    #2895696 - 07/16/04 02:25 AM (12 years, 4 months ago)

Quote:

Effed said:
Very well put together, you always impress me ATWAR.  :thumbup:






:thanx:


Post Extras: Print Post  Remind Me! Notify Moderator
Jump to top. Pages: 1

Amazon Shop for: Agar, Paul Stamets, Petri Dish

Mushrooms, Mycology and Psychedelics >> Mushroom Cultivation >> Mushroom Cultivation Archive >> Agar and Liquid Culture

Similar ThreadsPosterViewsRepliesLast post
* Isolating a strain on agar
( 1 2 3 all )
Azmodeus 26,091 42 02/28/03 09:12 AM
by Anonymous
* G.Teacher clone on agar AnnoA 14,906 13 07/18/01 12:53 AM
by Anno
* Peroxide Agar Tek (DD) Anonymous 13,458 2 11/23/01 05:51 AM
by sylo
* Grocery store Agar Tek. Helltick 24,351 4 03/15/07 11:26 AM
by Terillius
* LC Cloning - Newbie friendly pictorial tek!
( 1 2 3 4 5 all )
creamcorn 134,307 96 11/02/08 10:28 AM
by Anno
* multispore agar innoculation
( 1 2 3 all )
mycohomme 27,300 42 03/09/04 07:39 PM
by RogerRabbit
* Orissa India clone on agar AnnoA 9,902 7 08/29/01 03:02 PM
by dimitri211
* Agar with no flowhood?
( 1 2 all )
resin 17,239 21 12/18/02 03:20 PM
by Anonymous

Extra information
You cannot start new topics / You cannot reply to topics
HTML is disabled / BBCode is enabled
Moderator: Ythan, Anno, Thor, Link, Seuss, geokills, Asante, Citric, FooMan
11,230 topic views. 0 members, 0 guests and 0 web crawlers are browsing this forum.
[ Toggle Favorite | Print Topic | Stats ]
Search this thread:
Avalon Magic Plants
Please support our sponsors.

Copyright 1997-2016 Mind Media. Some rights reserved.

Generated in 0.056 seconds spending 0.003 seconds on 14 queries.