|
ReverendMyc

Registered: 03/29/19
Posts: 1,494
|
|
Bout time to start cookin some more poop.
-------------------- LAGM 2.024Stoned Gummys tek (Gummies from sclerotia or mushrooms) *Not just for stones any moreHow to succeed in mycology (and life) - know nothing, read everything, try something, and accept advice. Don't Panic   
|
tregar
Stranger


Registered: 08/30/04
Posts: 1,047
Last seen: 12 hours, 2 minutes
|
Re: Official Copelandia/Panaeolus Thread [Re: ReverendMyc] 1
#28636425 - 01/27/24 05:32 AM (13 hours, 40 minutes ago) |
|
|
This is my thread on 50 pan cyan trip reports and combo with 70mg THH or pure tetrahydroharmine: https://www.shroomery.org/forums/showflat.php/Number/28108398/fpart/1/vc/1
Sterilite 54 or 32 Quart Clear Gasket Box with Blue Latches & Gasket
--> Bod's Unmodified Monotub TEK: https://www.shroomery.org/forums/showflat.php/Number/22337800/fpart/1/vc/1
Bod said "This tub fruiting method is extremely low maintenance. No fanning is required, mist if needed, which will be infrequently. The lid is NOT latched down, EVER."
--> Baba Yaga Panaeolus in monotubs: https://www.shroomery.org/forums/showflat.php/Number/27637997/vc/1
Baba Yaga said "Member kirkeng convinced me with his well performing unmodified tubs to give unmodded a try and I have to say that these are my new favorites. With those I fruit right at spawn and run subs without a casing. The lid goes on upside down." ------------------------------------------------------------ Great news!
I ditched the martha tent (only use it to grow out grains, jars, or mycobags, love both). As I had to throw out the cake pan from the attempted fruit in martha tent due to it just not fruiting, lack of pins. Too many variables to adjust and trial and error for a martha at least for this beginner.
And put the estero pan cyan substrate cakes which I birthed and 2 new estero pan cyan completely colonized substrate from the mycobags into 2 cake pans, this is what they look like only 3 days later, almost reconsolidated back together as pure white snow all over the top.
And bought 2 of the 54 quart sterilite clear gasket tubs, put the birthed cakes into it, along with the 2 cake pans.
I put programmable seedling heat mats under the tub but separated by can lids, so not touching, set thermostat to keep it at 80 degrees below, and the tubs stay at 76 degrees even when it's 55 degrees outside and around 70 degrees F inside the house at night. The air outside is humid due to lots of rain outside recently.
Punched holes in a piece of box cardboard to run the LED string light that comes on a reel, and plugged it into the timer that turns it on from 7am till 7pm.
The lid is of course put on upside down as per Bod's tek in first link below, ceiling fan off but I do keep the window cracked 1/4" behind the blinds which lets in a bit of fresh air from outside.
I misted only once the 1st day, and already see baby mushrooms all over the 7 jar cakes, the 2 cake pans should finish substrate reconsolidation after being moved from 100% colonized mycobag to the cake pans in about 3 more days, the mycelium is moving super fast to make it like snow all over the top.
Here is an estero pan cyan mushroom I picked from one of the cakes already.
I did not have any pins or mushrooms what so ever using expensive humidifiers and dual reptile heater at bottom with adjustable fan, while using the martha tent for almost over a month now...and all the sudden after moving into the Bod's tubs I have mushrooms in just 2 days!
The humidity stays between 94 to 99% all the time in the tub and the temp at 76 degrees F as I have electronic temp/humidity gauges in each tub.
I am so excited as the martha tent did not work for me, but the tubs rule at least in my case, so happy! I see baby mushrooms popping up all over the cakes just since yesterday!
Thank you Bod and Baba Yaga !!!!!!!!!!!!!
Pic 1: I'm growing in two of the 54 quart sterlite tubs, and it's working !!! Pic 2: Inside of one of the two tubs, the 7 birthed cakes the very first day they were put into tub, no mushrooms 1st day, but by next day, I have baby mushrooms all over the cakes, will take another pic when full grown. Pic 3: I have a Vivo Home seedling heat mat 10" x 20.75" under each tub with can lids as spacers, and they fit perfectly and keep it perfect temp inside even with it being 55 degrees outside. Pic 4: This estero pan cyan mushroom was picked already. Pic 5: Piece of cardboard with punched holes on each end from large box with LED strip light reel is the lighting fixture. Pic 6: Timer to keep lights on for 12 hours Pic 7: LED strip light reel for price of a movie ticket. Pic 8: Programmable seedling heat mat set to 80 degrees F underneath jar lids keeps it 76 degrees inside tubs during this January winter, even when it dips down to 50 degrees outside and 68 degrees in the house at night. Temp sensor probe for mats is stuffed underneath the heat mat itself as seen in 1st and 5th photos. Pic 9: My pan cyan substrate broken up and added from mycobag seen fully reconsolidated in the cake pans or pyrex dish after 6 days. Pic 10: Even adding a bit of grown out mycelium grain to jars full of sterilized horse poo/straw/vermiculite substrate become colonized in record time. I simply bought pre-packaged and pre-pasteurized 2.5 lbs bags of horse poo mixture substrate on line, added 2 cups or so to each pint jar, put lids on, sterilized at 15 psi for 1 hour, then in front of flow hood, poured some mycelium grain in, shook up, and it colonizes in a week. Pic 11: The wide mouth jar cultivation lids with injection port and 0.2 micron filter can be bought on line for super cheap Pic 12 and 13: The grain I started with, added wedges from Florida estero pan cyan agar plates to grain in front of flow hood.

Edited by tregar (01/27/24 07:07 AM)
|
tree frog
eats bugs


Registered: 09/14/23
Posts: 442
Loc: lives in trees
Last seen: 10 hours, 45 minutes
|
Re: Official Copelandia/Panaeolus Thread [Re: tregar] 1
#28636581 - 01/27/24 08:27 AM (10 hours, 45 minutes ago) |
|
|
I can see how THH would be a nice combo with Pans. Bisporus have been relatively gentle so far but my second trip the fear did get into me a bit.
THH would have helped ground that without causing a substantial change in potency or duration, unlike its two siblings (harmine and harmaline).
Also tregar, I tried the mat under the tubs and the substrates dried out. Half my trays died, the other half fruited okay. I had a whole layer of perlite between the mat and the tote, which isn't an air gap but still a gap anyway.
Ended up building a jcm tote for the winter but another solution is to put the mats on your lid. Then the heat comes from the top, mimicking the sun.
You're lighting might suffer though.
-------------------- Listen to the silence behind the engines' noise. Jesus, Sweets, listen. Hear it? It's a love song. For whom? You are loved. ~ David Foster Wallace, Westward the Course of Empire Takes Its Way
|
Pnin
Riz Gukgak


Registered: 07/18/23
Posts: 395
Last seen: 1 hour, 59 minutes
|
Re: Official Copelandia/Panaeolus Thread [Re: tree frog] 2
#28636721 - 01/27/24 10:18 AM (8 hours, 54 minutes ago) |
|
|
-------------------- π
π΄ π° πΌ π² π» πΈ π½ πΆ π
π
π° πΏ >my end of 2023 grow journal<
|
rhizoRider
Mycorrhizally expanding



Registered: 12/24/13
Posts: 1,915
|
Re: Official Copelandia/Panaeolus Thread [Re: Pnin]
#28636736 - 01/27/24 10:28 AM (8 hours, 44 minutes ago) |
|
|
plz post bruising frui pics when ur done βοΈ
|
SupaThaRipper
Genetics Hoarder



Registered: 09/02/13
Posts: 1,487
Loc: USA
Last seen: 4 minutes, 5 seconds
|
Re: Official Copelandia/Panaeolus Thread [Re: rhizoRider] 3
#28637135 - 01/27/24 04:42 PM (2 hours, 30 minutes ago) |
|
|
Treefrog encouraged me to try βsomeβ poo in the grain spawn.. fastest I ever seen Bisporus take off π±

Inoculated 1-15 with 10cc LC
|
AspectOfTheCreator
Mastering the Art of Success



Registered: 12/07/22
Posts: 1,262
Last seen: 31 minutes, 53 seconds
|
Re: Official Copelandia/Panaeolus Thread [Re: rhizoRider] 1
#28637144 - 01/27/24 04:47 PM (2 hours, 25 minutes ago) |
|
|
First time trying to make some prints of actual quality in a long time. Just put some foil in a shoebox and put some caps on it. Misted the shoebox to keep humidity up then wiped it afterwards when aiming to let the prints dry. After 12 hours I shifted the caps down to try getting another print. Results were somewhat mixed.. Will these work? Will they be good enough for giveaways?
|
SupaThaRipper
Genetics Hoarder



Registered: 09/02/13
Posts: 1,487
Loc: USA
Last seen: 4 minutes, 5 seconds
|
|
I wouldnβt have wiped the tub down until after they printed. I do the same thing and then let me dry in front of the ffu. If no ffu. I thinking wiping it down would be a good idea. Or removing the top and placing in a closed SAB..
Or are you asking if double printing works? Because it definitely does
|
AspectOfTheCreator
Mastering the Art of Success



Registered: 12/07/22
Posts: 1,262
Last seen: 31 minutes, 53 seconds
|
Re: Official Copelandia/Panaeolus Thread [Re: SupaThaRipper]
#28637248 - 01/27/24 06:04 PM (1 hour, 8 minutes ago) |
|
|
I only wiped them down after printing. Just asking if this process is correct really and how clean theyre likely to be. Id like to get some prints that are up to par with ones Ive received from people here.
|
|