|
MasterNeo
The Young Lord


Registered: 10/09/13
Posts: 81
Last seen: 12 hours, 29 minutes
|
KSSS tray has knots, but no pins yet
#28632764 - 01/24/24 01:47 AM (4 days, 5 hours ago) |
|
|
Hey shroomery, I have a few questions about this unmodified monotub I have with a tray of KSSS in it. I made the tray on 1/10 I used WBS spawn made from LC, not MSS, to black kow at a 1:2 ratio (1 qt spawn to 2 qt black kow) I allowed it to colonize, & then added a casing layer of CVG, & let it grow for a few days then introduced it to FC, & began misting, & fanning. I had it in a room that fluctuates a lot in temp so I decided to throw it in a tent for a more controlled environment after no visible progress or growth showed over a week. The temp within monotub in the room was 70% RH & a temp of 79F. A day or two after placing in the tent, knots formed every where on the tray, but now it doesn't seem to be doing anything. Did it possibly dry out or maybe I just need to give it a bit more time? Or is it a lost cause?? Current tent RH is 90%+ & temp is within about 83F Here's a photo for reference
-------------------- "I'm a new Christ Savior - Neo from the Matrix Young God negu, can't fuh with no lame shih High off psychs, yeah, a negu stay t.a.d.e.d - The Underachievers
|
HappinessStan
Fungivore



Registered: 10/10/12
Posts: 1,612
Loc: Worcester, UK
Last seen: 3 hours, 56 minutes
|
Re: KSSS tray has knots, but no pins yet [Re: MasterNeo]
#28632788 - 01/24/24 03:06 AM (4 days, 4 hours ago) |
|
|
It does look quite dry, you can mist gently from above to rehydrate the surface. Stop fanning, that's outdated advice and will only dry the sub more. Mushrooms only need passive fae. Also, we spawn directly to fruiting conditions these days. Mist as needed and remain patient whilst maintaining adequate fae. Some better photos of the sub would help.
|
3.A.M
Boop!



Registered: 10/17/22
Posts: 848
Loc: Oz
Last seen: 4 hours, 8 minutes
|
Re: KSSS tray has knots, but no pins yet [Re: MasterNeo]
#28632791 - 01/24/24 03:12 AM (4 days, 4 hours ago) |
|
|
It looks a little dry and you certainly changed its environment a lot so it had to keep adapting to changes but 2-3 weeks is average for that variety to start fruiting, just be patient and stop fucking with it, it’ll do better in a tub and there shouldn’t be any need to mist or fan it, only mist lightly if the surface looks dry, you should be getting fruits soon👍
|
MasterNeo
The Young Lord


Registered: 10/09/13
Posts: 81
Last seen: 12 hours, 29 minutes
|
Re: KSSS tray has knots, but no pins yet [Re: HappinessStan]
#28632869 - 01/24/24 05:55 AM (4 days, 1 hour ago) |
|
|
Thank you for your reply HappinessStan. I will stop fanning as advised, & I will only mist if the surface looks dry. I usually mist it until there are small beads on the surface. Then I cover the tub again.
I have one question regarding fruiting conditions right after spawn. If I'm making a new unmodified monotub, but going the bulk route instead of trays, once I mix the spawn into the coir/verm, should I go right into fruiting conditions, or let it colonize the sub fully first, then straight to fruiting?
-------------------- "I'm a new Christ Savior - Neo from the Matrix Young God negu, can't fuh with no lame shih High off psychs, yeah, a negu stay t.a.d.e.d - The Underachievers
|
MasterNeo
The Young Lord


Registered: 10/09/13
Posts: 81
Last seen: 12 hours, 29 minutes
|
Re: KSSS tray has knots, but no pins yet [Re: 3.A.M]
#28632870 - 01/24/24 05:57 AM (4 days, 1 hour ago) |
|
|
Quote:
3.A.M said: It looks a little dry and you certainly changed its environment a lot so it had to keep adapting to changes but 2-3 weeks is average for that variety to start fruiting, just be patient and stop fucking with it, it’ll do better in a tub and there shouldn’t be any need to mist or fan it, only mist lightly if the surface looks dry, you should be getting fruits soon👍
Thank you for your response 3.A.M I currently have it in a unmodified tub with a clear plastic covering so light can through the top. Heard, I'll leave it alone, & I'll stop fanning, & only mist lightly if the surface is dry as well.
-------------------- "I'm a new Christ Savior - Neo from the Matrix Young God negu, can't fuh with no lame shih High off psychs, yeah, a negu stay t.a.d.e.d - The Underachievers
|
MasterNeo
The Young Lord


Registered: 10/09/13
Posts: 81
Last seen: 12 hours, 29 minutes
|
Re: KSSS tray has knots, but no pins yet [Re: 3.A.M]
#28632878 - 01/24/24 06:01 AM (4 days, 1 hour ago) |
|
|
Here's more pics of the sub to better help assess

-------------------- "I'm a new Christ Savior - Neo from the Matrix Young God negu, can't fuh with no lame shih High off psychs, yeah, a negu stay t.a.d.e.d - The Underachievers
|
MasterNeo
The Young Lord


Registered: 10/09/13
Posts: 81
Last seen: 12 hours, 29 minutes
|
Re: KSSS tray has knots, but no pins yet [Re: 3.A.M]
#28632879 - 01/24/24 06:02 AM (4 days, 1 hour ago) |
|
|
-------------------- "I'm a new Christ Savior - Neo from the Matrix Young God negu, can't fuh with no lame shih High off psychs, yeah, a negu stay t.a.d.e.d - The Underachievers
|
|