|
jaydeezy817
Stranger



Registered: 11/15/17
Posts: 91
Last seen: 2 years, 8 months
|
Martha tek
#27094253 - 12/17/20 02:04 PM (3 years, 1 month ago) |
|
|
So im about to level up tonight and set up my auto martha tek. I have the temp and humidity controller ready to go.. But when it comes humidity would it be best to have installed from top to fall or blown up from bottom? Also with air flow is it best to only have fans on during lights on? Also, what would be the best recommendation for light cycles in fruiting? I get varied results. Seriously appreciate it. Thank you
|
cronicr



Registered: 08/07/11
Posts: 61,436
Loc: Van Isle
Last seen: 2 years, 8 days
|
|
I put my mist maker up top and draw air from the bottom, fan on in the room constantly but not directly. So i used an ultrasonic mister and a coolm8st, the coolmist was my fresh air so it sat on bottom with the intake coming from outside the martha, this gave me constant fresh air exchange and with the marth loaded and coolmist running 24/7 my rh would get up between 70 and 80% , this is where my ultrasonic cane in to be used like a mister, with the ultrasonic i would time how long it takes to bring the rh to about 92 to 95% , this was on average 15 minutes, then i would time how long it took to drop back down below 85 % which varied through the year but lets say it was 90 minutes, i set my timers so that every 90 minutes the ultrasonic would turn on for 15 minutes. With sonething like inkbird controls the concept is still the same but can be a bit more finicky because they are a bit more precise so when you set the rh to what you desire it may keep misting a bit too often to keep the rh in the chamber but getting your sub surface too wet so when you set it up just keep that in mind and really spend a couple days dialing it in and it will be great
--------------------
  It doesn't matter what i think of you...all that matters is clean spawn I'm tired do me a favor
|
jaydeezy817
Stranger



Registered: 11/15/17
Posts: 91
Last seen: 2 years, 8 months
|
Re: Martha tek [Re: cronicr]
#27094465 - 12/17/20 03:53 PM (3 years, 1 month ago) |
|
|
Thats really helpful. Thank you..would you recommend i try the run for 15 minutes every hour and a half and see what happens first? Would it be better to just set it on a timer instead of the rh reading? Obviously depends on the time of year. Thanks again
|
Dr.Sparkle
Dr

Registered: 06/03/20
Posts: 127
Last seen: 2 years, 1 month
|
|
Air flow all the time ideally if you can keep rh up. 12/12 for lights. Can have them on from spawn day, its up to your preferences. I like day 1 lights on.
|
cronicr



Registered: 08/07/11
Posts: 61,436
Loc: Van Isle
Last seen: 2 years, 8 days
|
|
Quote:
jaydeezy817 said: Thats really helpful. Thank you..would you recommend i try the run for 15 minutes every hour and a half and see what happens first? Would it be better to just set it on a timer instead of the rh reading? Obviously depends on the time of year. Thanks again
Depends on what controls your using , mine flick on when it drops to 85 and off at 95 , my old set of controls didnt give me so much options and it just wanted to keep everything at 95 so i switched to timers
--------------------
  It doesn't matter what i think of you...all that matters is clean spawn I'm tired do me a favor
|
|
|
You cannot start new topics / You cannot reply to topics HTML is disabled / BBCode is enabled
Moderator: Shroomism, george castanza, RogerRabbit, veggie, mushboy, fahtster, LogicaL Chaos, 13shrooms, Stipe-n Cap, Pastywhyte, bodhisatta, Tormato, Land Trout, A.k.a 165 topic views. 27 members, 279 guests and 101 web crawlers are browsing this forum.
[ Show Images Only | Sort by Score | Print Topic ] |
|