Home | Community | Message Board


Mycohaus
Please support our sponsors.

Mushrooms, Mycology and Psychedelics >> Mushroom Cultivation

Welcome to the Shroomery Message Board! You are experiencing a small sample of what the site has to offer. Please login or register to post messages and view our exclusive members-only content. You'll gain access to additional forums, file attachments, board customizations, encrypted private messages, and much more!

Shop: Original Seeds Store Buy CBD, Cannabis Seeds   Amazon Rye Grain

Jump to first unread post. Pages: 1
Offlinebeginner
Stranger
Registered: 03/23/04
Posts: 50
Last seen: 11 years, 5 months
layering casing?
    #2707685 - 05/20/04 07:59 PM (13 years, 4 months ago)

the valleys of my casing have mycelium running throughout. i was thinking about putting another 1/4 inch of casing on top of that. i whould wait a bit longer for that layer to be wonderfully colonized. i suppose one could even put another layer if there is a purpose. whould this create a better fruiting perameter?


Post Extras: Print Post  Remind Me! Notify Moderator
InvisibleMykey
spectraltraveler

Registered: 04/07/04
Posts: 542
Re: layering casing? [Re: beginner]
    #2707747 - 05/20/04 08:10 PM (13 years, 4 months ago)

All in all you want a casing layer that is around one fourth as deep as the substrate layer.

What you are referring to is called patching. In order for a casing to be covered in a nice even pinset you need it to be as evenly colonized as possible before you initiate the pinning phase of growth.
The best way to accomplish this is to create a very level surface when you are preparing the substrate and then when it colonizes fully you add your casing layer at a very even depth over the top. This is rarely done as perfectly as one intends so we get into patching.

You described your casing as colonized in the valleys. Instead of adding a complete new layer ,just add fresh sterile casing very selectly over the valley areas sporting the growth. This will allow the other barren areas to catch up and pop through the origional casing about the same time as the recased portion pokes through the new layer. If you were to add a total new layer ,as you intended ,you would have only achieved a deeper layer,and not actually helped the casing to colonize more evenly.

Best of luck to ya,
MYKEY


Post Extras: Print Post  Remind Me! Notify Moderator
Offlinebeginner
Stranger
Registered: 03/23/04
Posts: 50
Last seen: 11 years, 5 months
Re: layering casing? [Re: beginner]
    #2707827 - 05/20/04 08:22 PM (13 years, 4 months ago)

thanks, i have been succesful with rye berries and 50/50 casing. looking for more,more.


Post Extras: Print Post  Remind Me! Notify Moderator
InvisibleMykey
spectraltraveler

Registered: 04/07/04
Posts: 542
Re: layering casing? [Re: beginner]
    #2707862 - 05/20/04 08:32 PM (13 years, 4 months ago)

  Your welcome!

  The benefit of even pinset will be a more simultaneous maturation of the shrooms which means you can pick them all at once ,therefore limiting the handling of the casing. It will also produce more,as you are seeking,but the limited touching will reduce the likelyhood of introducing contamination ,therefore increasing the opportunity for subsequent flushes to be contam free.

  This translates into...MORE>>>MORE>>>MORE>> :lol:


Post Extras: Print Post  Remind Me! Notify Moderator
Offlinebeginner
Stranger
Registered: 03/23/04
Posts: 50
Last seen: 11 years, 5 months
Re: layering casing? [Re: beginner]
    #2707906 - 05/20/04 08:44 PM (13 years, 4 months ago)

right on! this forum is coool. i wish i had more room to experiment with super bulk, like straw and worm castings. 2 bedroom appartment though. maybe ill give my bro the boot and plastic off his whole room. :grin:


Post Extras: Print Post  Remind Me! Notify Moderator
Jump to top. Pages: 1

Shop: Original Seeds Store Buy CBD, Cannabis Seeds   Amazon Rye Grain

Mushrooms, Mycology and Psychedelics >> Mushroom Cultivation

Similar ThreadsPosterViewsRepliesLast post
* casing layer and even pinset? thisone 1,459 7 02/08/06 01:34 PM
by coda
* Idea for more even pinset on casings...or pure lack of intelligence...you decide *DELETED*
( 1 2 all )
supercropper 2,646 31 03/31/07 05:39 PM
by hyphae
* Even pinset urgh brainfreezer187 1,132 4 04/12/06 09:38 PM
by hyphae
* Top layer casing material?? bluelou 654 6 07/29/02 05:03 PM
by pleezr
* Even pinsets?... What`s the trick? Numba9 841 1 02/09/02 04:13 AM
by Anonymous
* How do you get an even pinset? FactorNMR2 864 2 09/06/03 04:23 PM
by
* Even pinset...?
misos
434 1 01/24/08 09:43 PM
by KillerPicklez
* Will not casing a bulk sub adversely affect an even pinset? CDS 752 6 12/25/08 12:37 AM
by trentallica

Extra information
You cannot start new topics / You cannot reply to topics
HTML is disabled / BBCode is enabled
Moderator: Magash, Shroomism, george castanza, RogerRabbit, total, FooMan, 13shrooms, stonesun, cronicr, PussyFart, Tmethyl, Pastywhyte, bodhisatta
523 topic views. 9 members, 44 guests and 38 web crawlers are browsing this forum.
[ Toggle Favorite | Print Topic | Stats ]
Search this thread:
Zamnesia.com
Please support our sponsors.

Copyright 1997-2017 Mind Media. Some rights reserved.

Generated in 0.026 seconds spending 0.006 seconds on 19 queries.