|
Sandstone
Cosmonaut

Registered: 09/23/20
Posts: 88
|
BRF Cake transfer op
#27020710 - 11/04/20 04:36 AM (3 years, 2 months ago) |
|
|
[image] [/image] Here is the original setup.
[image] [/image]
But then I made another fruiting chamber, just cuz I wanted to:D it's a water tub basically, kind of a HC, with cakes suspended on, in this case, PTFE plastic rods, siliconed in place, because that's what I had at hand and it seemed like a good idea atm... [image] [/image]
[image] [/image]
[image] [/image] The drops on the walls of the chamber are from misting I did about two hours ago or something like that.
[image] [/image]
[image] [/image]
[image] [/image]
[image] [/image]
Ok..these cakes, I may have left some of them fruit invitro, while waiting for the others to fully consolidate, cuz I wanted to birth them at the same time, which I now recall as stupid, but whatever.. Some of the pins really grew quite a bit in the jars, so I didn't exactly know what to do with them upon birthing, dunking and rolling so I figured, hell, I'll just eat them raw..it was about 12grams raw, little motherfuckers were potent already, had a really nice buzz going, which made me happy but again, I now recall that as stupid-.- but whatever... So I dunked rolled and chambered. Misted as necessary, for about two or three days, and then I decided to move them to the HC/water tub FC. And these last pics were made today. I regulate FAE through cracking the lid open and having it on sideways to promote evaporation.
Now, I'd love to hear how bad did I mess these up..contamination visible? Too moist? Not enough FAE? Stalled? Worthy of nurturing?  as you can see, some of them have those first round of pins, that I didn't get to cut, getting huge, while the little ones are only just forming properly. Should I just cut those three biggest ones when they reach maturity and leave the cakes go on with the present pinset? I also believe I'll cut down on misting completely until the surface dries to a point. Some of the cakes appear way to moist to my eye? What do you think? Thanks, Cheers
|
Sandstone
Cosmonaut

Registered: 09/23/20
Posts: 88
|
Re: BRF Cake transfer op [Re: Sandstone]
#27021045 - 11/04/20 09:17 AM (3 years, 2 months ago) |
|
|
Bump. Any thoughts?
|
SingularFusion


Registered: 10/31/18
Posts: 1,208
Last seen: 1 hour, 4 minutes
|
Re: BRF Cake transfer op [Re: Sandstone]
#27021060 - 11/04/20 09:27 AM (3 years, 2 months ago) |
|
|
I like your ingenuity
over-engineered for sure, but fine all the same
the cakes look fine from those pics you posted, I can't enlarge them on site so I can't tell that much to be honest, but I reckon you are good to go
it should work
-------------------- π
π΄ π° πΌ π² π» πΈ π½ πΆ π
π
π° πΏ
|
Sandstone
Cosmonaut

Registered: 09/23/20
Posts: 88
|
|
Thx Nef, I know, it's just what I had at hand, never used that rod of PTFE in years:D That sucks. I tried another method, hopefully you'll be able to see pics in full size now.
Edited by Sandstone (11/04/20 09:53 AM)
|
Sandstone
Cosmonaut

Registered: 09/23/20
Posts: 88
|
Re: BRF Cake transfer op [Re: Sandstone]
#27021090 - 11/04/20 09:47 AM (3 years, 2 months ago) |
|
|
|
Sandstone
Cosmonaut

Registered: 09/23/20
Posts: 88
|
Re: BRF Cake transfer op [Re: Sandstone]
#27021096 - 11/04/20 09:50 AM (3 years, 2 months ago) |
|
|





Hope now pics are full size. Cheers
|
SingularFusion


Registered: 10/31/18
Posts: 1,208
Last seen: 1 hour, 4 minutes
|
Re: BRF Cake transfer op [Re: Sandstone]
#27021108 - 11/04/20 09:57 AM (3 years, 2 months ago) |
|
|
yeah I couldn't even see any of the pins before lol
probably more my eyes than the pics if I am being honest
yeah they look good man, nothing obviously bad
-------------------- π
π΄ π° πΌ π² π» πΈ π½ πΆ π
π
π° πΏ
|
Sandstone
Cosmonaut

Registered: 09/23/20
Posts: 88
|
|
Awesome, feelin betterrr!
|
|
|
You cannot start new topics / You cannot reply to topics HTML is disabled / BBCode is enabled
Moderator: Shroomism, george castanza, RogerRabbit, veggie, mushboy, fahtster, LogicaL Chaos, 13shrooms, Stipe-n Cap, Pastywhyte, bodhisatta, Tormato, Land Trout, A.k.a 159 topic views. 16 members, 161 guests and 28 web crawlers are browsing this forum.
[ Show Images Only | Sort by Score | Print Topic ] |
|