|
Justweed
Bobby's short shorts



Registered: 04/01/20
Posts: 555
Last seen: 3 months, 17 days
|
Purple Mystic tub refuses to fruit
#26605450 - 04/16/20 10:25 AM (3 years, 9 months ago) |
|
|
So this was an old MS syringe used to noc some corn jars, then those jars were g2g onto more corn. Those jars, 3 quarts each, went into these tubs, which were a couple pounds of composted manure and coir. Colonization took standard 8-10 days for both. After full colonization +2-3 days, I removed the masking tape covering my passive FAE holes which are covered in micropore tape, and began fanning 1-2 times a day. RH has been steady in the mid 90's, I haven't misted these at all, and temp is steady in the low 70's, 71-73*F. It's been 10 days now and these two tubs just refuse to fruit. They look pretty identical, and look fine on the surface, so I'm lookin' for some pointers here and what people think I should do...Lower humidity? Paper towel off surface moisture? Increase or lower temp? I'm unfamiliar with this strain, I haven't grown purple mystic in the past but in the past my method has worked fine with various others. Anything special these guys need? Should I bother casing now or has it been too long to bother? Thanks folks.

--------------------
  Keep 'em high and tight guys....
|
A.k.a
Stranger



Registered: 10/27/19
Posts: 16,782
Loc: Gaming the system
Last seen: 3 hours, 49 minutes
|
Re: Purple Mystic tub refuses to fruit [Re: Justweed] 1
#26605459 - 04/16/20 10:27 AM (3 years, 9 months ago) |
|
|
I’d def do more air to try and evaporate some of those beads.
I’ve never grown pm but I know in some of the older threads when it first came around people were having trouble with it.
--------------------
LAGM2020     
|
bigmanmcbig
Stranger
Registered: 02/09/19
Posts: 96
Last seen: 2 years, 11 months
|
Re: Purple Mystic tub refuses to fruit [Re: A.k.a]
#26605598 - 04/16/20 11:07 AM (3 years, 9 months ago) |
|
|
More FAE for sure I think. You need a lot of evaporation and keep in mind RR once said, "humidity does not add to substrate moisture, even at 100%. A higher humidity will simply slow down evaporation from the substrate." If you are at 90 RH you have some RH to lose. Let them breathe.
|
Justweed
Bobby's short shorts



Registered: 04/01/20
Posts: 555
Last seen: 3 months, 17 days
|
Re: Purple Mystic tub refuses to fruit [Re: bigmanmcbig]
#26605625 - 04/16/20 11:15 AM (3 years, 9 months ago) |
|
|
Alright, going to crack the tubs and let them breath for the day, try to get rid of some of that surface moisture. Thanks for the input!
--------------------
  Keep 'em high and tight guys....
|
Justweed
Bobby's short shorts



Registered: 04/01/20
Posts: 555
Last seen: 3 months, 17 days
|
Re: Purple Mystic tub refuses to fruit [Re: Justweed]
#26605695 - 04/16/20 11:52 AM (3 years, 9 months ago) |
|
|
Heh, so I opened the lids to put some paper towels on the surface to soak some moisture off. Tub 1, put the paper towel down, immediately notice a fruit, very thin about an inch long growing on the side, just out of the frame of one of my pictures. Still soaked everything up. Tub 2, paper towels go down, soak soak soak, lift up, and I notice a pin right away, it might have been under the water or under the extra fuzzy growth on top, but either way a pin is a pin!
Soaking up the water showed me some knots under the top fuzzy growth, I don't want to call it overlay but it's kinda like overlay growth. Leaving the lids open about an inch with the heater turned up 2*F and my air purifier running so there's air movement. RH in the tent I grow in is around 35%, so should lower the tub RH and surface moisture in an hour or two I'd think. Either way going to be covering them again in an hour or so, and continuing with FAE 2x daily, unless people think I should do more. Thanks!
--------------------
  Keep 'em high and tight guys....
|
bigmanmcbig
Stranger
Registered: 02/09/19
Posts: 96
Last seen: 2 years, 11 months
|
Re: Purple Mystic tub refuses to fruit [Re: Justweed]
#26606205 - 04/16/20 04:56 PM (3 years, 9 months ago) |
|
|
Yea, my advise would be to just pick a method and stick with it. Then ask questions based on what your doing so you at least know what variable you may have to change. If your seeing pinning then great just keep doing what your doing you got this.
|
staytrippy420


Registered: 03/23/13
Posts: 2,337
Loc: Canada
|
Re: Purple Mystic tub refuses to fruit [Re: bigmanmcbig]
#26606283 - 04/16/20 05:31 PM (3 years, 9 months ago) |
|
|
Evaporation of surface moisture is a pinning trigger.
That’s why lots of us put our tubs and boxes straight into fruiting conditions.
Restricting light or fae is never a good thing.
-------------------- Tek's I use LAGM2020
|
Justweed
Bobby's short shorts



Registered: 04/01/20
Posts: 555
Last seen: 3 months, 17 days
|
Re: Purple Mystic tub refuses to fruit [Re: bigmanmcbig]
#26606291 - 04/16/20 05:34 PM (3 years, 9 months ago) |
|
|
Quote:
bigmanmcbig said: Yea, my advise would be to just pick a method and stick with it. Then ask questions based on what your doing so you at least know what variable you may have to change. If your seeing pinning then great just keep doing what your doing you got this.
Yes, usually I stick with my method since it's tried and true, but I was posting here to see if there's any input on what would be the best variable to change.
--------------------
  Keep 'em high and tight guys....
|
|
|
You cannot start new topics / You cannot reply to topics HTML is disabled / BBCode is enabled
Moderator: Shroomism, george castanza, RogerRabbit, veggie, mushboy, fahtster, LogicaL Chaos, 13shrooms, Stipe-n Cap, Pastywhyte, bodhisatta, Tormato, Land Trout, A.k.a 1,250 topic views. 22 members, 161 guests and 38 web crawlers are browsing this forum.
[ Show Images Only | Sort by Score | Print Topic ] |
|