|
jdawg333
Stranger
Registered: 08/22/18
Posts: 580
Last seen: 18 days, 16 hours
|
Overdosed Tabs
#26547698 - 03/20/20 09:41 PM (3 years, 10 months ago) |
|
|
When people are laying sheets, is there ever a phenomenon when certain parts of the sheets get more dosed than others? I have read of people's experiences varying by parts of the sheet- some parts 5 hits are required for a proper trip, whereas others a few hits could send you way further than anticipated.
The cause I saw was that sheets can be improperly stored after being dipped in solution and there can be run off, or something like that. I'm not sure though, it's just what I've heard.
|
Korean Jesus



Registered: 11/13/19
Posts: 554
Loc: United States
Last seen: 2 years, 6 months
|
Re: Overdosed Tabs [Re: jdawg333]
#26547748 - 03/20/20 10:33 PM (3 years, 10 months ago) |
|
|
The level of skill required to synthesize LSD makes unlikely the possibility that such a mistake would be made in such an elementary procedure. More plausible are differences due to tolerance, set, setting, etc.
Not saying it's never happened but it's certainly not a widespread phenomenon
|
Ovoidhunter
Buttery Crescent



Registered: 09/17/16
Posts: 2,016
Last seen: 2 years, 8 months
|
Re: Overdosed Tabs [Re: jdawg333]
#26547753 - 03/20/20 10:38 PM (3 years, 10 months ago) |
|
|
I started to buy some lsd crystal but didn't have the slightest clue how to lay it. You gotta be a damn near scientist. Really you just need an expensive set of scales and do a bunch of research. Even then tho I don't think I'd feel comfortable even being around it. What if you sneeze in the bag and it blows up in ur face. Or you even just touch it with your finger. Your fucked. Lol
|
Korean Jesus



Registered: 11/13/19
Posts: 554
Loc: United States
Last seen: 2 years, 6 months
|
|
Why not just weigh the tiniest piece you can break off, dissolve it in a lot of distilled water, and dose volumetrically?
|
Ovoidhunter
Buttery Crescent



Registered: 09/17/16
Posts: 2,016
Last seen: 2 years, 8 months
|
|
I mean I guess you could. I don't know if I could trust myself tho I'm clumsy as hell.
|
Korean Jesus



Registered: 11/13/19
Posts: 554
Loc: United States
Last seen: 2 years, 6 months
|
|
Step 1: Break a piece off Step 2: Weigh the piece Step 3: Dissolve it in distilled water (or vodka but it will taste like shit) Step 4: Measure the amount of water in a beaker if it's small or just use whole number container measurements (quart, gallon, whatever it came in) if it's large Step 5: Drink or lay on a gummy (or whatever food item you want) the proportion of the liquid that would be equivalent to whatever dose you want according to a simple ratio (you want to drink )

It really is that simple and it doesn't matter how clumsy you are
|
Korean Jesus



Registered: 11/13/19
Posts: 554
Loc: United States
Last seen: 2 years, 6 months
|
|
Keep in mind it must be distilled water because chlorine and other chemicals will destroy the acid if you dissolve it in tap water (even bottled water may contain chloride salts). Also keep in mind that both heat and ambient light can decompose acid too. So store it on a cool, dark environment.
|
SFS96
AstroMan



Registered: 12/09/18
Posts: 2,144
Loc: Valleys Of Neptune
Last seen: 2 days, 8 hours
|
|
I havenβt noticed any problems with inconsistencies on lsd sheets, but I used to get pages of research chemicals and you could see the the crystals/powder coating the back of the pages and sometimes it was coated much thicker in certain areas so you would definitely trip harder on those tabs.
-------------------- How I make and preserve tea
Consuming consumes a man That was never a purpose of life To only crave for material joys Is believing the lie - Mellow Mood
|
redgreenvines
irregular verb


Registered: 04/08/04
Posts: 37,532
|
|
Quote:
Korean Jesus said: The level of skill required to synthesize LSD makes unlikely the possibility that such a mistake would be made in such an elementary procedure. More plausible are differences due to tolerance, set, setting, etc.
Not saying it's never happened but it's certainly not a widespread phenomenon
any doofus can purchase carefully manufactured crystal from a lab. then they try to lay sheets on blotter obtained from some other source. the chances that they will be evenly distributed are very very low.
expect hotspots and thank the universe when you fall into one.
--------------------
_ π§ _
|
Korean Jesus



Registered: 11/13/19
Posts: 554
Loc: United States
Last seen: 2 years, 6 months
|
|
I know a fair amount of people who have done a lot of acid and nobody has ever mentioned it. Crystals are super expensive - rarely are they bought by βany doofusβ
|
redgreenvines
irregular verb


Registered: 04/08/04
Posts: 37,532
|
|
lots of doofuses exist without you knowing them personally.
few tab layers have precision lab equipment.
--------------------
_ π§ _
|
mongo lloyd
Lone Free Ranger



Registered: 10/16/09
Posts: 9,351
Loc: UK
Last seen: 3 days, 8 hours
|
|
Quote:
Korean Jesus said: The level of skill required to synthesize LSD makes unlikely the possibility that such a mistake would be made in such an elementary procedure. More plausible are differences due to tolerance, set, setting, etc.
Not saying it's never happened but it's certainly not a widespread phenomenon
You could have people buying crystal or liquid and laying it weirdly
--------------------
|
Pandemoon
αΌ―eαΊeαΎmeαΈsαΉ«eΕ Ν


Registered: 01/28/14 
Posts: 5,844
Loc: Europe
Last seen: 1 hour, 20 minutes
|
|
Quote:
Korean Jesus said: I know a fair amount of people who have done a lot of acid and nobody has ever mentioned it. Crystals are super expensive - rarely are they bought by βany doofusβ
Crystal is cheaper than blotter. In the full gram range it's like 10k+, yes, but you don't have to buy this much. You can get 10mg or 100mg also.
I have noticed hotspots quite a few times already. It's not nice when you expect a mild trip from half a hit and then get completly blasted with like ~200+mics. ..especially not while beeing in a foreign country, sitting in a serious nobel restaurant eating dinner with your fiancee. 
Ah, good times.
-
|
InfiniteDreams


Registered: 10/25/19
Posts: 1,224
|
|
Quote:
Pandemoon said: It's not nice when you expect a mild trip from half a hit and then get completly blasted with like ~200+mics. ..especially not while beeing in a foreign country, sitting in a serious nobel restaurant eating dinner with your fiancee. 
Ah, good times.
-
This sounds like a great story:
βWe were just sitting down to a formal dinner, alone if a foreign country, when the drugs began to take hold.β
|
viraldrome



Registered: 09/21/18
Posts: 4,051
Loc: Parts Unknown
Last seen: 45 minutes, 19 seconds
|
|
I did it with 1p powder. Just figure out how much everclear a sheet can hold and be saturated with nothing left over. I order art blotter sheets from Germany all the time and they throw in extra sheets, I used those to do a few practice runs with. If you get hotspots its because you get your stuff from idiots who tried laying a vial of liquid to paper. It should be fairly even if the sheet is submerged.Trying to drop drops with a needle on to each hit, as I heard people do now, is rookie kid shit.
-------------------- Lysergamides I have tried so far: 1P-LSD, 1cP-LSD, ALD-52, AL-LAD, LSZ, ETH-LAD, MIPLA, EIPLA, 1cP-AL-LAD
|
Eclipse3130
Servant of the Fungi



Registered: 10/06/13
Posts: 6,220
Loc: PNW
Last seen: 1 hour, 4 minutes
|
|
Anyone properly laying sheets with a micropippette and correct volumetric concentrated solutions you will never have a problem. But yes many people don't do it correctly a d hits can bleed if you don't know what you're doing. Dipping pages is old school and isn't nearly as accurate as using a micropippette, plus you'll always lose more than using one.
How I do it is I have a calibrated micropippette tip and I weigh 100 drops on an accurate mg scale and divide by 100 to get my median drop weight, and then I proceed to make my solution based on what uG rating I want my drops to be and add the crystal
-------------------- "In The Material World One seeks retirement and grows Old In The Magical World One seeks Enlightenment and grows Wiser In The Miraculous World One seeks nothing and grows Lighter As we all tread the Homeward Path we will explore many Realms And one day... we will all Realize that all experiences are Simply Different ways in which The All-That Is Perceives Itself"
|
LogicaL Chaos
Ascension Energy & Alien UFOs




Registered: 05/12/07
Posts: 69,333
Loc: The Inexpressible...
Last seen: 2 hours, 46 seconds
|
Re: Overdosed Tabs [Re: jdawg333]
#26550245 - 03/22/20 05:56 AM (3 years, 10 months ago) |
|
|
I would say its possible but rare. Most hits on a sheet of acid are the same dosages. But occassionally, some sheets are laid improperly and have "hot spots" on the edges. Another situation is the whole sheet will be "overdosed" for example the seller claims its 100 micrograms per hit but its really 200 micrograms per hit or more. This is quite rare as its usually the opposite (higher advertized amount than actual amount).
So overall its unlikely (but not impossible) to buy a sheet of acid and have uneven doses on it.
-------------------- "What you must understand is that your physical dimension affects everyone in the higher dimensions as well. All things are interconnected. All things are One. Therefore, if one dimension is broken or out of balance, then all other dimensions will experience repercussions." - Pleiadian Prophecy 2020 The New Golden Age by James Carwin PROJECT BLUE BOOK ANALYSIS! (312 pages!) | Psychedelics & UFOs | Ready to Contact UFOs? | The Source on Mushrooms | Trippy Gematrix | Dj TeknoLogical | Fentanyl Test Kits R.I.P. Big Worm || The Start of the Ascension Process was 2020. Welcome to the Next Great Era of Earth πππ
  Oregon Eclipse Festival 2017 :: Aug 19th - 21st :: Pure Paradise   Very Effective LSA Extraction Tek | π§ Advanced Cold Water LSA Extraction Method π§ |  Mescajuana - Mescaline with Marijuana | DMT Dab Bongs | UFO Technology! Shpongle
     
|
Sugabearcrisp
Not Your Average Bear



Registered: 10/14/19
Posts: 12,047
Loc: maybe I had too much, too fast
Last seen: 1 day, 3 hours
|
|
I've had "mop up" paper doses back in early 90s. Basically the layer makes their sheets by dipping and then when not enough left to get a consistent dip, another sheet is used to mop up what is left. This last sheet is mostly under dosed but some doses may be full strength. When i had it in the 90s at umaine it was represented as such and so we took more than normal, 4-5 hits which could leave you lacking or floored, like russian roullette with doses, but it was free so no complaints.
As eclipse said these days that isn't as much of a thing, with the internet and high quality scales.
Edited by Sugabearcrisp (03/22/20 06:17 AM)
|
Northerner
splelling chceker


Registered: 07/29/12
Posts: 14,141
Loc: FNQ
Last seen: 33 seconds
|
|
Quote:
Eclipse3130 said: Anyone properly laying sheets with a micropippette and correct volumetric concentrated solutions you will never have a problem.
I thought this was how it's done by everyone. I've never had tabs are particularly hot compared to those around them and I've been eating acid for decades.
--------------------
The nearest we ever come to knowing truth is when we are witness to paradox.
|
|