|
LogicaL Chaos
Ascension Energy & Alien UFOs




Registered: 05/12/07
Posts: 69,323
Loc: The Inexpressible...
Last seen: 28 minutes, 11 seconds
|
DIY Kits
#26478366 - 02/10/20 11:02 AM (3 years, 11 months ago) |
|
|
Im just finish building my TRONXY X3A 3D Printer kit. Its just about done, the manufacturer forgot some hardware, so Im gonna pick up today.
I have to say, building this 3D Printer was pretty fun. A lot of parts but definitely rewarding. Reminds me of when I used to build R/C Cars. Good times.
Anyone done DIY kits?
-------------------- "What you must understand is that your physical dimension affects everyone in the higher dimensions as well. All things are interconnected. All things are One. Therefore, if one dimension is broken or out of balance, then all other dimensions will experience repercussions." - Pleiadian Prophecy 2020 The New Golden Age by James Carwin PROJECT BLUE BOOK ANALYSIS! (312 pages!) | Psychedelics & UFOs | Ready to Contact UFOs? | The Source on Mushrooms | Trippy Gematrix | Dj TeknoLogical | Fentanyl Test Kits R.I.P. Big Worm || The Start of the Ascension Process was 2020. Welcome to the Next Great Era of Earth 🌎🌍🌏
  Oregon Eclipse Festival 2017 :: Aug 19th - 21st :: Pure Paradise   Very Effective LSA Extraction Tek | 💧 Advanced Cold Water LSA Extraction Method 💧 |  Mescajuana - Mescaline with Marijuana | DMT Dab Bongs | UFO Technology! Shpongle
     
|
smokin_cannon
el chupacabra
Registered: 08/12/19
Posts: 22
Last seen: 2 years, 5 months
|
|
I made a couple amps and some smaller electronic kit-based projects, but the 3d printer sounds pretty aggressive. How long did it take? Was it any cheaper than buying a 3d printer?
|
LogicaL Chaos
Ascension Energy & Alien UFOs




Registered: 05/12/07
Posts: 69,323
Loc: The Inexpressible...
Last seen: 28 minutes, 11 seconds
|
|
It was $120. Not bad. I just found out its missing a limit switch for one of the motors. It was missing some hardware which I had to buy, but this limit switch is an issue.
This is pretty aggressive. Its mechanical and electronic based. Its taking me two-days including today. Most of it was prep work thou (pealing paper off acrylic, cleaning the metal extrusion, prepping wires). Im about 90% done.
|
smokin_cannon
el chupacabra
Registered: 08/12/19
Posts: 22
Last seen: 2 years, 5 months
|
|
Must be pretty good instructions, i.e. not Velleman. That's pretty fast.
|
|