|
Dlee92
Stranger
Registered: 10/17/19
Posts: 3
Last seen: 3 years, 11 months
|
Stalled monotub *DELETED*
#26454354 - 01/27/20 12:19 AM (4 years, 2 days ago) |
|
|
Post deleted by Dlee92
Reason for deletion: N/a
|
magicschoolbus



Registered: 02/19/18
Posts: 160
Loc: Shroomery
Last seen: 8 months, 15 days
|
Re: Stalled monotub [Re: Dlee92]
#26454359 - 01/27/20 12:28 AM (4 years, 2 days ago) |
|
|
I think you'll see pins within the next 3-5 days. Just mist it lightly one last good time and forget about it. The last picture clearly shows the surface is knotting.
Edited by magicschoolbus (01/27/20 12:31 AM)
|
staytrippy420


Registered: 03/23/13
Posts: 2,337
Loc: Canada
|
Re: Stalled monotub [Re: Dlee92]
#26454360 - 01/27/20 12:29 AM (4 years, 2 days ago) |
|
|
Only day 12? Shiet I’ve had many shoe boxes pin around 14 days. Give it some more time.
-------------------- Tek's I use LAGM2020
|
Dlee92
Stranger
Registered: 10/17/19
Posts: 3
Last seen: 3 years, 11 months
|
|
Quote:
magicschoolbus said: I think you'll see pins within the next 3-5 days. Just mist it lightly one last good time and forget about it. The last picture clearly shows the surface is knotting.
Good to hear thank you. Temps have been a bit cold. 65-70 I would say. Picking up a space heater tomorrow.
|
HolyBolete
Mold Slayer



Registered: 12/15/19
Posts: 263
Loc: USA 🇺🇸
Last seen: 3 years, 6 months
|
Re: Stalled monotub [Re: Dlee92]
#26454383 - 01/27/20 01:18 AM (4 years, 2 days ago) |
|
|
Quote:
Dlee92 said:
Quote:
magicschoolbus said: I think you'll see pins within the next 3-5 days. Just mist it lightly one last good time and forget about it. The last picture clearly shows the surface is knotting.
Good to hear thank you. Temps have been a bit cold. 65-70 I would say. Picking up a space heater tomorrow.
Careful about using that as it can pose a serious fire hazard from reading a ton posts about this. Not safe to leave on all the time and not practical to just warm the room part of the time.
If you can raise the temp and keep it consistently at the same temp without something like space heater then you are far better off. Even keeping the room in the low 70s should yield great results.
|
gizmo1



Registered: 06/15/11
Posts: 3,831
Loc: FREEDOM
|
|
Quote:
HolyBolete said:
Quote:
Dlee92 said:
Quote:
magicschoolbus said: I think you'll see pins within the next 3-5 days. Just mist it lightly one last good time and forget about it. The last picture clearly shows the surface is knotting.
Good to hear thank you. Temps have been a bit cold. 65-70 I would say. Picking up a space heater tomorrow.
Careful about using that as it can pose a serious fire hazard from reading a ton posts about this. Not safe to leave on all the time and not practical to just warm the room part of the time.
If you can raise the temp and keep it consistently at the same temp without something like space heater then you are far better off. Even keeping the room in the low 70s should yield great results.
Dont most modern space heaters have built in thermostats and a feature where they shut off if knocked over? I dont see how a space heater is dangerous. Atleast not a modern one. I'd go for a radiator style one myself though. If I was going to use one. Quote:
staytrippy420 said: Only day 12? Shiet I’ve had many shoe boxes pin around 14 days. Give it some more time.
In the winter I usually dont see pins until around 15 or 16 days. I have a PE tub that was spawned on the 2nd of this month and barely started spitting out blobs yesterday. PE is already slow but winter temps slow shit down too. I dont try to raise temps just let shit move at it's own pace when it gets cold. Thermostat stays at 70 but only the room the thermostat is in stays close to those temps. House is ancient and no central heat or air.
Edited by gizmo1 (01/27/20 02:11 AM)
|
jbgtaa
extraterrestrial



Registered: 06/09/19
Posts: 1,785
Last seen: 3 years, 3 months
|
Re: Stalled monotub [Re: gizmo1]
#26454405 - 01/27/20 02:25 AM (4 years, 2 days ago) |
|
|
Definitely knotting but also super fluffy, may be too wet.
You’ll see pins in five days max, probably harvest in just under 12 days.
-------------------- If the thunder don't get ya, the lightning will. In another time's forgotten space, your eyes looked through your mother's face. Trade List Forever giving away prints. PM at anytime for a free print.
|
Dlee92
Stranger
Registered: 10/17/19
Posts: 3
Last seen: 3 years, 11 months
|
Re: Stalled monotub [Re: jbgtaa]
#26454415 - 01/27/20 02:37 AM (4 years, 2 days ago) |
|
|
Quote:
jbgtaa said: Definitely knotting but also super fluffy, may be too wet.
You’ll see pins in five days max, probably harvest in just under 12 days.
Thank you everyone. Being a noob I didn’t know what knotting is. Now that i have looked it up I see my tub is defiantly knotting. That’s good. And you think fluffy could be from too wet? But it’s only in the corners and sides. Wouldn’t that lean more towards too dry? As the corners and sides dry out first. Also there is water droplets on the middle. But none on the really white fluffy parts. These 2 tubs are my practice tubs while my g2g jars are finishing. So I would really like to get this dialed. Or is the more white areas around the edges and corners fine I just need to wait it out?
|
HappyHigh
Stranger

Registered: 05/05/17
Posts: 892
Last seen: 2 days, 3 hours
|
Re: Stalled monotub [Re: Dlee92]
#26454493 - 01/27/20 05:06 AM (4 years, 2 days ago) |
|
|
yeah i'm getting some 60's and my jars are all stalling so try for that 75 degrees.
-------------------- Had I the heavens' embroidered cloths, Enwrought with golden and silver light, The blue and the dim and the dark cloths Of night and light and the half light, I would spread the cloths under your feet: But I, being poor, have only my dreams; I have spread my dreams under your feet; Tread softly because you tread on my dreams.
|
TIS87
Stranger

Registered: 11/22/19
Posts: 123
Last seen: 10 months, 1 day
|
|
Looks good so far, just keep waiting.
|
|
|
You cannot start new topics / You cannot reply to topics HTML is disabled / BBCode is enabled
Moderator: Shroomism, george castanza, RogerRabbit, veggie, mushboy, fahtster, LogicaL Chaos, 13shrooms, Stipe-n Cap, Pastywhyte, bodhisatta, Tormato, Land Trout, A.k.a 270 topic views. 25 members, 194 guests and 33 web crawlers are browsing this forum.
[ Show Images Only | Sort by Score | Print Topic ] |
|