|
Some of these posts are very old and might contain outdated information. You may wish to search for newer posts instead.
|
Mycophagest
Mammalian


Registered: 04/07/19
Posts: 9
Last seen: 5 years, 2 months
|
Panaeolus cyanescens growth parameters
#25950487 - 04/23/19 08:32 AM (5 years, 8 months ago) |
|
|
Hi folks I saw this info https://www.shroomery.org/8698/Panaeolus-cyanescens-growth-parameters and says that GE has to be 2 per hour what means, 2 minutes per hour or 2 times per our' Thanks
|
bodhisatta 
Smurf real estate agent


Registered: 04/30/13
Posts: 61,916
Loc: Milky way
|
Re: Panaeolus cyanescens growth parameters [Re: Mycophagest]
#25950489 - 04/23/19 08:36 AM (5 years, 8 months ago) |
|
|
If you're wanting to do well i suggest you don't dig up 40 year old info and methods.
FAE should be constant and passive. Enough to keep the CO2 below 600-1000ppm.
If you had one grow in a huge room vs ten grows in a closet the FAE needs would be much different. 2 FAEs is a ridiculous way to approach the concept
|
mushboy
modboy



Registered: 04/24/05
Posts: 35,378
Loc: eating the cats
|
Re: Panaeolus cyanescens growth parameters [Re: bodhisatta]
#25950492 - 04/23/19 08:39 AM (5 years, 8 months ago) |
|
|
pan cyan thread
lots of relevant and CURRENT info. its almost 9000 replies tho. pop some corn and get a reading
|
Mycophagest
Mammalian


Registered: 04/07/19
Posts: 9
Last seen: 5 years, 2 months
|
Re: Panaeolus cyanescens growth parameters [Re: mushboy]
#25950513 - 04/23/19 08:54 AM (5 years, 8 months ago) |
|
|
Ofc, but let me write something. It's just my 5th post, 1st thread m8 Hello, btw.
IMHO Old info should be updated to save up in popcorn
|
Mycophagest
Mammalian


Registered: 04/07/19
Posts: 9
Last seen: 5 years, 2 months
|
Re: Panaeolus cyanescens growth parameters [Re: bodhisatta]
#25950521 - 04/23/19 09:03 AM (5 years, 8 months ago) |
|
|
Quote:
bodhisatta said: If you're wanting to do well i suggest you don't dig up 40 year old info and methods.
FAE should be constant and passive. Enough to keep the CO2 below 600-1000ppm.
If you had one grow in a huge room vs ten grows in a closet the FAE needs would be much different. 2 FAEs is a ridiculous way to approach the concept
My idea is to use small tubes 32l (8gall I think) With an air pump in water. Summer is comming and temps will fuck me soon. Water is behind the red lid that is a wall to avoid undesired water splashes
Any advice of how mesure it? I know that Co2 make cottony mycelated stems. If someone have a current link/thread would be much appreciated, I have not much time. Thanks in advance.

Edited by Mycophagest (04/23/19 09:17 AM)
|
El Chupacabra
Stoned Ape



Registered: 01/07/19
Posts: 676
Loc: 🇺🇸
Last seen: 2 years, 5 days
|
Re: Panaeolus cyanescens growth parameters [Re: mushboy]
#25950554 - 04/23/19 09:36 AM (5 years, 8 months ago) |
|
|
Quote:
mushboy said: pan cyan thread
lots of relevant and CURRENT info. its almost 9000 replies tho. pop some corn and get a reading
This thread has captivated me for 2 nights of reading. Few more to go at the very least. I got a pan cyan "Jamaican" print that I wanna get going on agar. SOOOO much to digest in there.
OP I would suggest we read that fucker together.
|
Professor X
School for the Gifted


Registered: 04/18/19
Posts: 2,719
Last seen: 3 years, 3 months
|
Re: Panaeolus cyanescens growth parameters [Re: Mycophagest]
#25950557 - 04/23/19 09:37 AM (5 years, 8 months ago) |
|
|
Build a monotub and use a fan to pull air away from it. Pay attention to the pinset and adjust accordingly. The fan should be constant. If you set it up right it will remain 90 to 99% humidity without drying out. If it won't pin in the center then mist it a little. You are complicating a simple procedure and it is not going to work very well the way you are setting it up. You are going to end up with a weak pinset and shriveled tiny Cyansens growing them in that suffocation tub.
|
Mycophagest
Mammalian


Registered: 04/07/19
Posts: 9
Last seen: 5 years, 2 months
|
Re: Panaeolus cyanescens growth parameters [Re: Professor X]
#25950571 - 04/23/19 09:45 AM (5 years, 8 months ago) |
|
|
Quote:
Professor X said: Build a monotub and use a fan to pull air away from it. Pay attention to the pinset and adjust accordingly. The fan should be constant. If you set it up right it will remain 90 to 99% humidity without drying out. If it won't pin in the center then mist it a little. You are complicating a simple procedure and it is not going to work very well the way you are setting it up. You are going to end up with a weak pinset and shriveled tiny Cyansens growing them in that suffocation tub.
Hi Professor X, ty for your tips
Temperatures are not good for the monotub right now. I can't use the heating mat all the time to get the humidity so I have to enter air with an air pump and a difusser stones under water. Maybe nex winter but not now
|
Professor X
School for the Gifted


Registered: 04/18/19
Posts: 2,719
Last seen: 3 years, 3 months
|
Re: Panaeolus cyanescens growth parameters [Re: Mycophagest]
#25950586 - 04/23/19 09:56 AM (5 years, 8 months ago) |
|
|
You can raise the temp with lights, mats are a really bad idea, a hot spot can develop and ruin your project.
|
Mycophagest
Mammalian


Registered: 04/07/19
Posts: 9
Last seen: 5 years, 2 months
|
Re: Panaeolus cyanescens growth parameters [Re: Professor X]
#25950596 - 04/23/19 10:04 AM (5 years, 8 months ago) |
|
|
Quote:
Professor X said: You can raise the temp with lights, mats are a really bad idea, a hot spot can develop and ruin your project.
here the problem is how to give them humidity without temperature. So, In this case only 2 systems are in my mind an air pump with a difusser stone (what i have decided for) or an intractor circuit with a mist generator (in this case i think is excessive for the size of the tubes)
|
bodhisatta 
Smurf real estate agent


Registered: 04/30/13
Posts: 61,916
Loc: Milky way
|
Re: Panaeolus cyanescens growth parameters [Re: Mycophagest]
#25950636 - 04/23/19 10:29 AM (5 years, 8 months ago) |
|
|
Quote:
Mycophagest said: Ofc, but let me write something. It's just my 5th post, 1st thread m8 Hello, btw.
IMHO Old info should be updated to save up in popcorn
Can't just go edit other people's work though. Best we can do is archive them away. There's dates on every post/thread though. Also, old topics that stand the test of time don't fade into the distance they stay relevant and talked about.
|
Mycophagest
Mammalian


Registered: 04/07/19
Posts: 9
Last seen: 5 years, 2 months
|
Re: Panaeolus cyanescens growth parameters [Re: bodhisatta]
#25950648 - 04/23/19 10:39 AM (5 years, 8 months ago) |
|
|
Quote:
bodhisatta said:
Quote:
Mycophagest said: Ofc, but let me write something. It's just my 5th post, 1st thread m8 Hello, btw.
IMHO Old info should be updated to save up in popcorn
Can't just go edit other people's work though. Best we can do is archive them away. There's dates on every post/thread though. Also, old topics that stand the test of time don't fade into the distance they stay relevant and talked about.
I saw lot of threads of you, very helpful btw. I'm working at little scale using tips and tricks from everybody, I mean you, RR, etc. even Mr.D.Barlow 
I have to mix all the info from you to adapt it to my reality. I had to stop growing mushrooms during 10 years for familiar affairs but my FlowHood is still on shape, I cloned all the trays from the local supermarkets but my purpose this time is to grow pan cyan, hawaii, goliath and jamaica if weather allows me. If not I will see in the obligation to store them as master slants till the end of the summer.

NEXT SLANTS I WILL ADD DUNG (poultry manure)
Edited by Mycophagest (04/23/19 10:50 AM)
|
|