|
Some of these posts are very old and might contain outdated information. You may wish to search for newer posts instead.
|
Mateja
Registered: 07/14/16
Posts: 7,948
Loc: Here
|
Re: Humidity Chamber Tek for fruiting BRF cakes [Re: LogicaL Chaos] 1
#25868186 - 03/11/19 06:34 PM (5 years, 19 days ago) |
|
|
So far most cakes have started fruit formation. These two cakes are producing fatties.
A few have cakes are producing fruits from the surrounding coir.
-------------------- Cakes inside Water Tub
|
LogicaL Chaos
Ascension Energy & Alien UFOs
Registered: 05/12/07
Posts: 69,837
Loc: The Inexpressible...
Last seen: 5 hours, 49 minutes
|
Re: Humidity Chamber Tek for fruiting BRF cakes [Re: Mateja]
#25868326 - 03/11/19 07:39 PM (5 years, 19 days ago) |
|
|
Hell yah.
Looks like its dialing in nicely.
|
Puduwoke
mushroom enthusiastic
Registered: 06/25/17
Posts: 1,666
Last seen: 6 days, 14 hours
|
Re: Humidity Chamber Tek for fruiting BRF cakes [Re: Mateja] 1
#25868823 - 03/11/19 11:55 PM (5 years, 19 days ago) |
|
|
Wow wtf is going in there when they are growing from the coir or does it only look like it?
Is that RW?
Show me your ape! I dont care of they are small!
-------------------- Trade List LAGM2021
|
Mateja
Registered: 07/14/16
Posts: 7,948
Loc: Here
|
Re: Humidity Chamber Tek for fruiting BRF cakes [Re: Puduwoke] 1
#25869037 - 03/12/19 05:50 AM (5 years, 18 days ago) |
|
|
Yeah those pins are definitely not growing out from the cake but from strands of myc that's leaped off into the coir. These are all AA+ except 3 APE cakes that just started pinning.
-------------------- Cakes inside Water Tub
|
Puduwoke
mushroom enthusiastic
Registered: 06/25/17
Posts: 1,666
Last seen: 6 days, 14 hours
|
Re: Humidity Chamber Tek for fruiting BRF cakes [Re: Mateja]
#25869056 - 03/12/19 06:10 AM (5 years, 18 days ago) |
|
|
The verm is enough of a "casing" for the ape i guess?
-------------------- Trade List LAGM2021
|
Mateja
Registered: 07/14/16
Posts: 7,948
Loc: Here
|
Re: Humidity Chamber Tek for fruiting BRF cakes [Re: Puduwoke] 1
#25869066 - 03/12/19 06:31 AM (5 years, 18 days ago) |
|
|
Well technically it's not APE but some leucistic phenotype that was swabbed from APE fruits. I've grown those without a top layer before without problems so Idk if they need anything extra
-------------------- Cakes inside Water Tub
|
juniperus
Frim Fram Sauce
Registered: 12/02/18
Posts: 718
|
Re: Humidity Chamber Tek for fruiting BRF cakes [Re: Mateja] 1
#25869131 - 03/12/19 07:41 AM (5 years, 18 days ago) |
|
|
Quote:
Mateah said: A few have cakes are producing fruits from the surrounding coir.
-------------------- To avoid all evil, to cultivate good, and to cleanse one's mind - this is the teaching of the Buddhas
|
Mateja
Registered: 07/14/16
Posts: 7,948
Loc: Here
|
Re: Humidity Chamber Tek for fruiting BRF cakes [Re: juniperus] 2
#25869276 - 03/12/19 09:21 AM (5 years, 18 days ago) |
|
|
These two produced 111g together
These strands won't get far on the soaking wet coir, they usually stay in one place once 'disconnected'
-------------------- Cakes inside Water Tub
|
teladi
FUNKSOULBROTHER
Registered: 06/27/17
Posts: 1,189
Loc: South Africa
Last seen: 7 months, 19 days
|
Re: Humidity Chamber Tek for fruiting BRF cakes [Re: LogicaL Chaos] 1
#25869331 - 03/12/19 09:54 AM (5 years, 18 days ago) |
|
|
Quote:
LogicaL Chaos said: If u made a syringe from a fresh spore print, it will colonize cakes that fast. Its pretty amazing to watch.
Ever try inoculate a cake with LC? That's even faster.
|
LogicaL Chaos
Ascension Energy & Alien UFOs
Registered: 05/12/07
Posts: 69,837
Loc: The Inexpressible...
Last seen: 5 hours, 49 minutes
|
Re: Humidity Chamber Tek for fruiting BRF cakes [Re: teladi]
#25869334 - 03/12/19 09:55 AM (5 years, 18 days ago) |
|
|
I have not. I gotta try that.
|
SunnyDayze
Finder of shrubberies
Registered: 12/30/17
Posts: 2,230
Loc: Canada
|
Re: Humidity Chamber Tek for fruiting BRF cakes [Re: Mateja] 1
#25869424 - 03/12/19 10:31 AM (5 years, 18 days ago) |
|
|
Quote:
Mateah said: These two produced 111g together
I love how those spread out to the coir. You should put a nice backdrop behind and take pics, they are very pretty.
--------------------
|
Puduwoke
mushroom enthusiastic
Registered: 06/25/17
Posts: 1,666
Last seen: 6 days, 14 hours
|
Re: Humidity Chamber Tek for fruiting BRF cakes [Re: teladi]
#25869644 - 03/12/19 12:34 PM (5 years, 18 days ago) |
|
|
Meatah recommended it to me, to use LI.
Will do that with my next round of cakes
Guess random question about my GH. So I built my own humidifier with a 5 disc pondfogger. Got it connected to a Inkbird controller, set to 95%RH then to get on again at 92%RH.
Right now I have moved my GH into a closed for my Pan growth so that I can heat up the closet with a radiator. For whatever reason now the timing on the humidifier is 5-6 min OFF and 2 min ON.
I guess you guys answer will be as long as the trays/casing whatever does not get to wet it shouldn't be a problem?
Before it ran for 2 min but was off for about 10-12 min, I read somewhere that RR said to try not to run it on for me then 1/3 of the time.
Here is a picture of my setup. The mist comes up a through hole from the grey pipe you can make out in the background.
-------------------- Trade List LAGM2021
|
Stu1234
Disco Stu
Registered: 10/28/18
Posts: 58
Last seen: 2 years, 6 months
|
Re: Humidity Chamber Tek for fruiting BRF cakes [Re: Puduwoke]
#25869704 - 03/12/19 01:09 PM (5 years, 18 days ago) |
|
|
Another question if that's OK chaps... Got my humidity chamber set up last night, it's under my bed 😂 with an led blue light set up. 24 hours in and I still can't see any humidity droplets inside. Should I have a heat mat set up underneath the tub??
|
Mateja
Registered: 07/14/16
Posts: 7,948
Loc: Here
|
Re: Humidity Chamber Tek for fruiting BRF cakes [Re: Stu1234] 1
#25869865 - 03/12/19 02:27 PM (5 years, 18 days ago) |
|
|
No need for heat mats. What you can do is spray down the walls completely and take notice after that how evaporation is going. If the lid is closed or just flipped the walls should stay saturated all the time.
-------------------- Cakes inside Water Tub
|
Stu1234
Disco Stu
Registered: 10/28/18
Posts: 58
Last seen: 2 years, 6 months
|
Re: Humidity Chamber Tek for fruiting BRF cakes [Re: Mateja]
#25869919 - 03/12/19 02:42 PM (5 years, 18 days ago) |
|
|
Thank you Mateah....
|
teladi
FUNKSOULBROTHER
Registered: 06/27/17
Posts: 1,189
Loc: South Africa
Last seen: 7 months, 19 days
|
Re: Humidity Chamber Tek for fruiting BRF cakes [Re: Puduwoke] 1
#25870127 - 03/12/19 04:09 PM (5 years, 18 days ago) |
|
|
Quote:
Puduwoke said: Meatah recommended it to me, to use LI.
LI is just as good if done right.
I like to throw my excess LC from grain inoculation into BRF jars. I don't want to waste, especially if I can get results from that culture. Since I pour, I use a polyfill lid and no dry verm layer.
|
Puduwoke
mushroom enthusiastic
Registered: 06/25/17
Posts: 1,666
Last seen: 6 days, 14 hours
|
Re: Humidity Chamber Tek for fruiting BRF cakes [Re: teladi]
#25870886 - 03/12/19 11:59 PM (5 years, 18 days ago) |
|
|
Care to tell me how you do it? I have no pour glass jars with sfd. I thought let it colonize and either with the ship or without just put sterelized water into it with a syringe and suck it back up?
1 small plate ( about 2/3 of a normal plate) should be enough for a 20ml syringe, no?
-------------------- Trade List LAGM2021
|
Mateja
Registered: 07/14/16
Posts: 7,948
Loc: Here
|
Re: Humidity Chamber Tek for fruiting BRF cakes [Re: Puduwoke]
#25871351 - 03/13/19 09:05 AM (5 years, 17 days ago) |
|
|
Quote:
Puduwoke said: Care to tell me how you do it? I have no pour glass jars with sfd. I thought let it colonize and either with the ship or without just put sterelized water into it with a syringe and suck it back up?
1 small plate ( about 2/3 of a normal plate) should be enough for a 20ml syringe, no?
You want to make LI? I like to drop a whole or a half culture into 50ml sterilized water that's inside a 3dl glass container with a rubber band lid that seals hermetically. Lid is unmodified. Drop the culture in, seal the lid and shake the shit out of the jar for 5-10seconds. This breaks the (0.5%) soft agar into a homogenous slush that's easy to pour or aspirate into syringes. I like to pour one of these LI's into 3-5 qt jars. This gives me fast and even colonization.
You asked for APEs yesterday? Here is a new HC with 14 of em. I just made it now. (swabape)
-------------------- Cakes inside Water Tub
|
thisbliss
Stranger
Registered: 02/27/19
Posts: 399
Last seen: 3 years, 10 months
|
Re: Humidity Chamber Tek for fruiting BRF cakes [Re: Mateja]
#25871689 - 03/13/19 12:38 PM (5 years, 17 days ago) |
|
|
Hi you guys having any problems with mold or cobweb in the HC?
My first cake fruited ok but it started getting blue toward the end of the first flush and looks almost green in particular round the hyphal knots. But I can't tell if it's just really dehydrated or mold has set in.
I'll try n get a pic but I'm just wondering if the HC is more susceptible to this. From what I've read plenty of fresh air stops mold forming but I find the cake dries out really quickly in the HC if the lid is left ajar too long. How are some of you controlling this as I understand yous mist just once a day and don't even fan?
|
teladi
FUNKSOULBROTHER
Registered: 06/27/17
Posts: 1,189
Loc: South Africa
Last seen: 7 months, 19 days
|
Re: Humidity Chamber Tek for fruiting BRF cakes [Re: thisbliss]
#25871733 - 03/13/19 12:58 PM (5 years, 17 days ago) |
|
|
Nah. If it's blue it's bruising. Sometimes blueing looks green, but isn't. Green from trich is very obvious.
Also highly unlikely that you'll get cobweb mould, as that requires very low FAE to grow. I'd forget the word "cobweb", since almost no-one ever has it.
|
|