|
Some of these posts are very old and might contain outdated information. You may wish to search for newer posts instead.
|
Zartan
Tough Guy



Registered: 04/18/16
Posts: 46
Loc: Land of FAR FAR AWAY
Last seen: 6 years, 4 months
|
G2G inside oven
#23172399 - 04/30/16 11:08 AM (8 years, 8 months ago) |
|
|
A buddy of mine does all his G2G, inoculation, etc inside of his oven. He swears by it! Said that his temps are from 170-200 degrees while working and has never had a contamination problem. My question is if anyone of you done any work inside of an oven? If so what where you results?
-------------------- Never Settle!
|
mupetmower
Mower of Muppets



Registered: 03/29/16
Posts: 3,036
Loc: Here and There
|
Re: G2G inside oven [Re: Zartan]
#23172406 - 04/30/16 11:13 AM (8 years, 8 months ago) |
|
|
i actually did this with my very fist grow, which if fruiting now. I had no contams in 6/6 jars.. but honestly, making a SAB is not hard or expensive, and is much safer. i made one, and will never use the over door method again.
You sig says "Never Settle" so take your own advice. make a SAB.
-------------------- -The wise man never stops seeking knowledge.
-I wanna feel the change consume me, feel the outside turning in. I wanna feel the metamorphosis and cleansing I've endured within.
|
PirateSwazey


Registered: 12/12/12
Posts: 2,993
Loc: Here, Now
|
Re: G2G inside oven [Re: Zartan]
#23172407 - 04/30/16 11:13 AM (8 years, 8 months ago) |
|
|
|
HowToGrow
Enlightener


Registered: 04/28/16
Posts: 43
Loc: In your thoughts
Last seen: 8 years, 7 months
|
|

Just no..
As Mupet said, just use an SAB. Costs like $25 to make and there are many available teks out there on how to properly make and use one.
|
mupetmower
Mower of Muppets



Registered: 03/29/16
Posts: 3,036
Loc: Here and There
|
|
Quote:
HowToGrow said:

Just no..
As Mupet said, just use an SAB. Costs like $25 to make and there are many available teks out there on how to properly make and use one. 
You can even make one for much less than $25. like $10 if you already have a drill or a soldering iron. or even a knife and a lighter.. the tote is what will cost you the most(which is $10 or less at Walmart or somewhere similar). i used a soldering iron to make my arm holes. worked wonders. the soldering iron i got has a 3mm bit and cost me about $20 at Home Depot. and, i used it for my first SGFC before i got an extra drill from my parents garage haha. and sincce the bit is 3mm, you can easily eyeball a 1/4in hole(which is roughly 6.35mm) and then check to make sure it is the right size with a 1/4in alen wrench or something.
I strongly suggest making one. it really isnt hard. and will do much more to ensure you dont fuck up.
-------------------- -The wise man never stops seeking knowledge.
-I wanna feel the change consume me, feel the outside turning in. I wanna feel the metamorphosis and cleansing I've endured within.
Edited by mupetmower (04/30/16 11:22 AM)
|
Supalemonhaze
Spore syringe hater.



Registered: 10/02/15
Posts: 6,725
Loc: 12" down Europe's butthole
|
|
Oven inoculations has been debunked years ago, which is the reason why you never hear of folks using it on here.
|
Zartan
Tough Guy



Registered: 04/18/16
Posts: 46
Loc: Land of FAR FAR AWAY
Last seen: 6 years, 4 months
|
|
Quote:
HowToGrow said:

Just no..
As Mupet said, just use an SAB. Costs like $25 to make and there are many available teks out there on how to properly make and use one. 
LMBO!!
-------------------- Never Settle!
|
Mad Season
hookers and blackjack



Registered: 09/16/12
Posts: 12,666
Loc: Canada
|
|
Worst part about the oven is it's in the kitchen and creating airflow by being on..
If it was a 5 sided box with no heat, in a still room that isn't the kitchen, I'd recommend doing it.
|
GaiaSporeworks
Stranger


Registered: 10/31/15
Posts: 52
Last seen: 7 years, 8 months
|
|
No! Oven=air currents, they aren't sealed off... Go Still air box or best of all, flow hood w/ HEPA filter
|
mupetmower
Mower of Muppets



Registered: 03/29/16
Posts: 3,036
Loc: Here and There
|
|
the idea of the oven door method is to create heat which will rise, and take the contams up with it, while your media stays safe.. but like someone said, it was debunked a while back, and im sure i(and others who have done it successfully like OP's friend) just got lucky. definitely make a SAB.
i would love to build a flow hood but im way to poor to do that right now =p my trusty SAB does the job, and does it well.
-------------------- -The wise man never stops seeking knowledge.
-I wanna feel the change consume me, feel the outside turning in. I wanna feel the metamorphosis and cleansing I've endured within.
|
|
|
You cannot start new topics / You cannot reply to topics HTML is disabled / BBCode is enabled
Moderator: Shroomism, george castanza, RogerRabbit, veggie, mushboy, fahtster, LogicaL Chaos, 13shrooms, hamloaf, cronicr, Stipe-n Cap, Pastywhyte, bodhisatta, Tormato, Land Trout, A.k.a 416 topic views. 23 members, 127 guests and 16 web crawlers are browsing this forum.
[ Show Images Only | Sort by Score | Print Topic ] |
|