|
Some of these posts are very old and might contain outdated information. You may wish to search for newer posts instead.
|
jagarjt
Stranger
Registered: 09/01/15
Posts: 25
Last seen: 8 years, 2 months
|
Help: ACRB ended up a thin sticky substance when finished? No crystal?
#22423424 - 10/23/15 03:24 PM (8 years, 3 months ago) |
|
|
Someone did a tek involving naphtha and 116g ACRB. After 3 days in the freezer there were tiny bit visible white crystals on the bottom of the pan. Then someone pulled it and let it sit at room temp for 3 days and the crystals seemed to evaporate into a thin layer of sticky goolike substance. Please help someone
|
HeavyToilet
The Heaviest OfThem All


Registered: 08/06/03
Posts: 9,458
Loc: British Columbia
|
Re: Help: ACRB ended up a thin sticky substance when finished? No crystal? [Re: jagarjt]
#22424116 - 10/23/15 06:13 PM (8 years, 3 months ago) |
|
|
Kinda hard to figure out where you went wrong if you don't even post what tek you used.
|
Icon
Bloomer


Registered: 05/15/14
Posts: 2,866
Last seen: 7 hours, 26 minutes
|
Re: Help: ACRB ended up a thin sticky substance when finished? No crystal? [Re: jagarjt]
#22424402 - 10/23/15 07:35 PM (8 years, 3 months ago) |
|
|
aren't you the same swimmer who asked this same question like 4 times now? you are not reading the advice you are given already.
|
wolfiewolfie
Just wingin' it.


Registered: 06/16/15
Posts: 2,177
Loc: Australia
|
Re: Help: ACRB ended up a thin sticky substance when finished? No crystal? [Re: Icon]
#22424438 - 10/23/15 07:44 PM (8 years, 3 months ago) |
|
|
Did you evaporate roughly half of the naphtha before putting it into the freezer? Have you smoked the goo to see if it is active? What tek did you follow? ACRB required a Acid/Base tek and not straight to base (STB).
--------------------
The only reason why T-rex's can't walk backwards is because they're extinct, which perfectly explains why there are no headaches in the rainforest; The parrots eat 'em all. My Drawings
|
wolfiewolfie
Just wingin' it.


Registered: 06/16/15
Posts: 2,177
Loc: Australia
|
Re: Help: ACRB ended up a thin sticky substance when finished? No crystal? [Re: jagarjt]
#22424470 - 10/23/15 07:52 PM (8 years, 3 months ago) |
|
|
Quote:
jagarjt said: Then someone pulled it and let it sit at room temp for 3 days
what do you mean by 'pulled it'? After its been in the freezer for 12-18 hours you should take it out and carefully pour the naphtha out, then set the dish on its side in front of a fan for a few hours.
--------------------
The only reason why T-rex's can't walk backwards is because they're extinct, which perfectly explains why there are no headaches in the rainforest; The parrots eat 'em all. My Drawings
|
jagarjt
Stranger
Registered: 09/01/15
Posts: 25
Last seen: 8 years, 2 months
|
Re: Help: ACRB ended up a thin sticky substance when finished? No crystal? [Re: wolfiewolfie]
#22424493 - 10/23/15 07:57 PM (8 years, 3 months ago) |
|
|
I used joshisoms tek. Yeah I've asked this question quite a few times I just want to be very sure of what I need to do before the rest of the ACRB is used. And yes by pulled it I mean poured the naph off
|
wolfiewolfie
Just wingin' it.


Registered: 06/16/15
Posts: 2,177
Loc: Australia
|
Re: Help: ACRB ended up a thin sticky substance when finished? No crystal? [Re: jagarjt]
#22424523 - 10/23/15 08:06 PM (8 years, 3 months ago) |
|
|
The most simplistic tek I have used with good results is cyb's hybrid ATB salt tek https://wiki.dmt-nexus.me/Cybs'_Hybrid_ATB_'Salt'_Tek. Ive used it 3 times now and it never fails.
The last batch was made using 30g of powdered ACRB. I still haven't perfected it for maximum yeilds but I find it very easy to follow.
Results of 2x warm naphtha pulls:


--------------------
The only reason why T-rex's can't walk backwards is because they're extinct, which perfectly explains why there are no headaches in the rainforest; The parrots eat 'em all. My Drawings
Edited by wolfiewolfie (10/23/15 08:10 PM)
|
wolf8312
Pennywise


Registered: 10/01/12
Posts: 2,356
Last seen: 4 days, 1 hour
|
Re: Help: ACRB ended up a thin sticky substance when finished? No crystal? [Re: wolfiewolfie] 1
#22425210 - 10/23/15 10:59 PM (8 years, 3 months ago) |
|
|
I use a 3x acid boil, pool extracts, boil it down, add base, add naphtha add salt pull combine pulls run them through a sep funnel to drain off black basey liquid evap off till the liquid becomes cloudy Freeze pour off naphtha (through filter) scrape crystals up
Its a very clean way to work and if you add a defat step and reX I would imagine it will work for ACRB. Dont know though I always use mimosa.
Anyway read this...
https://www.dmt-nexus.me/forum/default.aspx?g=posts&t=41652
-------------------- "I'm every nightmare you ever had. I am your worst dreams come true. I am everything you ever were afraid of." Pennywise the dancing clown
|
|