|
Some of these posts are very old and might contain outdated information. You may wish to search for newer posts instead.
|
lunarweblink
Stranger
Registered: 12/27/10
Posts: 47
|
getting nervous how long before pinning *DELETED*
#20560249 - 09/12/14 10:46 PM (10 years, 4 months ago) |
|
|
Post deleted by lunarweblinkReason for deletion: Don't want anymore
Edited by lunarweblink (09/12/14 10:47 PM)
|
mra
Mr. Ambiguity

Registered: 07/27/14
Posts: 99
Last seen: 8 years, 7 months
|
Re: getting nervous how long before pinning [Re: lunarweblink]
#20560422 - 09/12/14 11:39 PM (10 years, 4 months ago) |
|
|
I would give it fresh air and light, probably a few days till you see pins.
-------------------- Mra's grow log
|
wowimflabbergasted
supercalifragilistic



Registered: 07/16/12
Posts: 18,919
|
Re: getting nervous how long before pinning [Re: mra]
#20560427 - 09/12/14 11:41 PM (10 years, 4 months ago) |
|
|
Why is it under a blanket?
|
lunarweblink
Stranger
Registered: 12/27/10
Posts: 47
|
|
Quote:
wowimflabbergasted said: Why is it under a blanket?
because that's the instructions i followed for one of the teks on this forum to put a blanket over them for colonization.
http://www.shroomery.org/forums/showflat.php/Number/15362857
Edited by lunarweblink (09/12/14 11:53 PM)
|
cronicr


Registered: 08/07/11
Posts: 62,899
Loc: Van Isle
Last seen: 2 hours, 27 minutes
|
Re: getting nervous how long before pinning [Re: lunarweblink]
#20560461 - 09/12/14 11:53 PM (10 years, 4 months ago) |
|
|
-------------------- It doesn't matter what i think of you...all that matters is clean spawn
I'm tired do me a favor
|
lunarweblink
Stranger
Registered: 12/27/10
Posts: 47
|
Re: getting nervous how long before pinning [Re: cronicr]
#20570439 - 09/15/14 11:42 AM (10 years, 4 months ago) |
|
|
Thanks for the info does it matter if I frosted the entire top layer with wbs spawn don't have any pinning yet the temp is about 72 degrees and the humidity is 99 percent it's been about a little over a week
|
Icon
Bloomer



Registered: 05/15/14
Posts: 3,494
Last seen: 12 hours, 36 minutes
|
Re: getting nervous how long before pinning [Re: lunarweblink]
#20570446 - 09/15/14 11:45 AM (10 years, 4 months ago) |
|
|
A little over a weak is right on time from the looks of it. It's fully colonized so take the blanket off, add the light, and adjust your polyfill. It looks too tight on top, perhaps also on the sides. Once it's loosened, the extra FAE will induce pinning.
Actually, a second look at the 2nd picture has me suspicious. Do you have a liner, or is that the sub we're seeing through the side? It looks like only the top 5th is colonized, everything below still soil looking.
|
lunarweblink
Stranger
Registered: 12/27/10
Posts: 47
|
Re: getting nervous how long before pinning [Re: Icon]
#20570456 - 09/15/14 11:50 AM (10 years, 4 months ago) |
|
|
It is soil no I don't have a liner I been doing 12 on 12 off with light
Edited by lunarweblink (09/15/14 11:51 AM)
|
wowimflabbergasted
supercalifragilistic



Registered: 07/16/12
Posts: 18,919
|
Re: getting nervous how long before pinning [Re: lunarweblink]
#20570518 - 09/15/14 12:16 PM (10 years, 4 months ago) |
|
|
Quote:
lunarweblink said: It is soil no I don't have a liner I been doing 12 on 12 off with light
What else did you use in your sub?
|
lunarweblink
Stranger
Registered: 12/27/10
Posts: 47
|
|
I used coir spent coffee grounds and gypsum for my sub
|
lunarweblink
Stranger
Registered: 12/27/10
Posts: 47
|
Re: getting nervous how long before pinning [Re: lunarweblink]
#20599405 - 09/21/14 11:26 PM (10 years, 3 months ago) |
|
|
thanks icon i think you was right the polyfill was packed two tight a lesson learned after i loosened it 3 days in and
|
cronicr



Registered: 08/07/11
Posts: 62,899
Loc: Van Isle
Last seen: 2 hours, 27 minutes
|
Re: getting nervous how long before pinning [Re: lunarweblink]
#20599422 - 09/21/14 11:32 PM (10 years, 3 months ago) |
|
|
get that digital thing out of there its' doing you no good i hope that makes it to a second flush but it doesn't look happy
-------------------- It doesn't matter what i think of you...all that matters is clean spawn
I'm tired do me a favor
|
lunarweblink
Stranger
Registered: 12/27/10
Posts: 47
|
Re: getting nervous how long before pinning [Re: cronicr]
#20600035 - 09/22/14 06:59 AM (10 years, 3 months ago) |
|
|
Quote:
cronicr said: get that digital thing out of there its' doing you no good i hope that makes it to a second flush but it doesn't look happy
yeah im trying to figure our why it don't look happy my self i would have expected lot more pins and the digital thing is only there to test the humidity levels and temps its attached to a magnet i don't leave it in there lol
Edited by lunarweblink (09/22/14 07:03 AM)
|
Pastywhyte
Say hello to my little friend



Registered: 09/15/12
Posts: 37,972
Loc: Canada
|
Re: getting nervous how long before pinning [Re: lunarweblink]
#20600048 - 09/22/14 07:06 AM (10 years, 3 months ago) |
|
|
Poor conditions is my guess. Your bottom holes are too loose for starters which is why your getting mostly side pins. The top is drying out. Hygrometers are next to useless, the RH is most important at sub level. Think microclimate.
|
tripdawg420
low life with no life



Registered: 02/02/09
Posts: 7,653
Loc: illinois
Last seen: 9 hours, 47 minutes
|
Re: getting nervous how long before pinning [Re: Pastywhyte]
#20600064 - 09/22/14 07:14 AM (10 years, 3 months ago) |
|
|
looks like to me the tubs contamed its pinning because you have alot of fae from the real loose poly and its trying to live
|
cronicr



Registered: 08/07/11
Posts: 62,899
Loc: Van Isle
Last seen: 2 hours, 27 minutes
|
Re: getting nervous how long before pinning [Re: tripdawg420]
#20600099 - 09/22/14 07:30 AM (10 years, 3 months ago) |
|
|
it looks like alot of grain on top, also try a liner next time
-------------------- It doesn't matter what i think of you...all that matters is clean spawn
I'm tired do me a favor
|
lunarweblink
Stranger
Registered: 12/27/10
Posts: 47
|
Re: getting nervous how long before pinning [Re: cronicr]
#20600188 - 09/22/14 08:17 AM (10 years, 3 months ago) |
|
|
Thanks the sub is not Contamed there is no discolor or odors but I packed the polly a little tighter and yes I think k I used to much grain for the top layer
Edited by lunarweblink (09/22/14 08:18 AM)
|
wowimflabbergasted
supercalifragilistic



Registered: 07/16/12
Posts: 18,919
|
Re: getting nervous how long before pinning [Re: Pastywhyte]
#20600219 - 09/22/14 08:30 AM (10 years, 3 months ago) |
|
|
Quote:
Pastywhyte said: Poor conditions is my guess. Your bottom holes are too loose for starters which is why your getting mostly side pins. The top is drying out. Hygrometers are next to useless, the RH is most important at sub level. Think microclimate.
All of this 
I would mist and fan it.
|
lunarweblink
Stranger
Registered: 12/27/10
Posts: 47
|
|
Thanks everyone for all the input misting did the trick the top layer must have been drying to quick now there growing and popping up all over for drying would a fan work I don't got no dehydrator I got an old school fan that I think will work good
|
|