Home | Community | Message Board


Mushrooms.com
Please support our sponsors.

Mushrooms, Mycology and Psychedelics >> Mushroom Cultivation

Welcome to the Shroomery Message Board! You are experiencing a small sample of what the site has to offer. Please login or register to post messages and view our exclusive members-only content. You'll gain access to additional forums, file attachments, board customizations, encrypted private messages, and much more!

Shop: Original Seeds Store Buy CBD, Cannabis Seeds   Amazon Perlite

Jump to first unread post. Pages: 1
OfflineIC3D
newbie

Registered: 08/24/03
Posts: 42
Last seen: 13 years, 5 months
Pin bust like craze outside edge .........
    #1953520 - 09/26/03 07:38 AM (13 years, 10 months ago)

I was checking on 50/50 case since it not overlayer but, The case layer start pulling away from case walls and pins start popping up all around edge between case and caselayer.But, None in the middle. I was begin to wonder its because I keep mist it everyday to keep it moist to prevent it from dryng? Or Were it normal the outside edge comes first before middle part do? Note: Outside case walls are tape black. Thanks.


Post Extras: Print Post  Remind Me! Notify Moderator
OfflineJazzMatazz
addict

Registered: 09/07/02
Posts: 770
Loc: Vienna, Austria
Last seen: 2 years, 9 months
Re: Pin bust like craze outside edge ......... [Re: IC3D]
    #1953676 - 09/26/03 09:20 AM (13 years, 10 months ago)

Mycelia pulling back from the sides means its driing out. - It's probably been pre-pinning stage for a bit longer, or it's your second flush , right?
Pinning at the sides is common, as the humdity is higher there than at the top. You should try misting more thoroughly throughout the day. (Not the casing, the air)
How often do you mist?(Casing AND Air)


--------------------
Perception is limited to consciousness.Expand it and unfold other realities.


Post Extras: Print Post  Remind Me! Notify Moderator
OfflineIC3D
newbie

Registered: 08/24/03
Posts: 42
Last seen: 13 years, 5 months
Re: Pin bust like craze outside edge ......... [Re: JazzMatazz]
    #1954840 - 09/26/03 05:26 PM (13 years, 10 months ago)

Mycelia pulling back from the sides means its driing out.


True but, it was the first pinhead development. I only mist it only few time per week since the small case are place inside the fruiting chamber and with Perlite suround outside case walls in order to keep humidity level staying at 92-96%. Should I inject sterile water inside layer?


Post Extras: Print Post  Remind Me! Notify Moderator
OfflineStrongBad
pharm lover
Registered: 09/24/03
Posts: 335
Last seen: 13 years, 1 month
Re: Pin bust like craze outside edge ......... [Re: IC3D]
    #1955273 - 09/26/03 07:21 PM (13 years, 10 months ago)

Just a question, how much are you SUPPOSED to mist? I do it like 3x/week and fan like 10 times/day.


Post Extras: Print Post  Remind Me! Notify Moderator
OfflineJazzMatazz
addict

Registered: 09/07/02
Posts: 770
Loc: Vienna, Austria
Last seen: 2 years, 9 months
Re: Pin bust like craze outside edge ......... [Re: IC3D]
    #1955491 - 09/26/03 08:46 PM (13 years, 10 months ago)

well, it should be ok , when only misting. How deep is your casing layer? If it's too deep , it takes ages for the myclium to show itself.
@shroombad: you want the mycelia to colonise the casing up to under just the surface. For that it has to be wet- also under the surface.
You should give it a heavy misting before this stage, and check every day if it's still moist (not with puddels though!), if not mist it. - The idea is to keep it air-shut with an luminium-foil cover in this phase.
The misting should not continue in the pre-pinning phase, as knots and pins dont like water. Try stopping to mist in this stage, and only do so occasionally. Usually the moisture the shrooms get from under the casing should be enough.
for more info check the faq.
Hope it helps,
jazz


--------------------
Perception is limited to consciousness.Expand it and unfold other realities.


Edited by JazzMatazz (09/26/03 08:53 PM)


Post Extras: Print Post  Remind Me! Notify Moderator
Jump to top. Pages: 1

Shop: Original Seeds Store Buy CBD, Cannabis Seeds   Amazon Perlite

Mushrooms, Mycology and Psychedelics >> Mushroom Cultivation

Similar ThreadsPosterViewsRepliesLast post
* Pinning on the Edge? kungpow 893 7 02/23/07 03:59 PM
by kungpow
* Pins around the edges normal? AkashaPrinciple 539 5 03/27/06 06:34 AM
by AkashaPrinciple
* Monotub pinning on bag widowmaker487 920 6 11/22/08 12:20 AM
by widowmaker487
* Re: Pins / Mushroom ratio Russdogg 1,141 13 04/06/01 03:15 AM
by Russdogg
* Pinning on edge of casing. Senovio 1,192 9 09/04/03 06:05 AM
by Senovio
* Monotub Pinning Troubles
( 1 2 3 all )
legallyhomeless 5,671 51 07/08/08 05:41 PM
by billyboy36
* Casing pinning only on the edges? kaky711 875 11 06/07/07 08:45 PM
by hyphae
* quick question concerning pin initiation tiny_rabid_birds 856 3 04/12/06 07:40 PM
by tiny_rabid_birds

Extra information
You cannot start new topics / You cannot reply to topics
HTML is disabled / BBCode is enabled
Moderator: Magash, Shroomism, george castanza, RogerRabbit, total, FooMan, 13shrooms, stonesun, cronicr, PussyFart, Tmethyl, Pastywhyte, bodhisatta
692 topic views. 22 members, 93 guests and 18 web crawlers are browsing this forum.
[ Toggle Favorite | Print Topic | Stats ]
Search this thread:
Out-Grow.com - Mushroom Growing Kits & Supplies
Please support our sponsors.

Copyright 1997-2017 Mind Media. Some rights reserved.

Generated in 0.025 seconds spending 0.005 seconds on 19 queries.