|
Some of these posts are very old and might contain outdated information. You may wish to search for newer posts instead.
|
ZippyDoozy
Stranger


Registered: 04/11/13
Posts: 47
Loc:
Last seen: 9 years, 8 months
|
Made something to smoke DMT, will it work?
#19313918 - 12/22/13 10:10 PM (10 years, 2 months ago) |
|
|
So, basically.. No more money to spare. And I have nothing to smoke out of so I decided to come up with something myself. All I could find online was links to buy meth pipes; or something called the "machine".. Unfortunately, all I had available was a slightly larger than normal water bottle, foil and a straw. This is what I came up with:


I folded a wide piece of foil in half and adjusted it over the where the lid would go. I screwed the cap on a little, to make it contour to the grooves. It ripped it off from the rest of the foil a bit, but completely sealed it for the most part. I tested it and no air goes through it. I then took one more layer of foil (not folded this time) and wrapped it over it and stuck it there with at least 5-6 rubber bands as to keep it in place and seal it even more.. Might be overkill, but what the hell.
I added a carb towards the bottom; which you can see in one of the pictures. And used a regular McDonalds straw for inhalation through the top. (or regularly bottom of the bottle.)
Anyways, seeing as I came up with this myself, I'm not too sure if it'll work. What do you guys think? I feel that having the foil where the lid would typically go will allow all the DMT to settle into one place. Also, having 3 layers of foil will keep it from getting too hot. Or do you think it will keep it from getting hot ENOUGH all together?
Anywho, will this work off of your judgement? I realize the only way to really know is to put it through actual use, but what are your opinions?
--------------------
All great ideas are obvious. But not all obvious ideas are great.
|
weilii-coyote


Registered: 09/13/09
Posts: 207
Loc: South
|
Re: Made something to smoke DMT, will it work? [Re: ZippyDoozy]
#19313933 - 12/22/13 10:14 PM (10 years, 2 months ago) |
|
|
Will it work? Yes. But it probably won't work well and you probably won't be able to break through. I'm thinking the foil will get very hot and burn the DMT.
Do you have a regular pipe? You could throw some weed or tobacco down and put the dmt on top, then add a bit more herb, then smoke as usual. If you dont smoke weed or tobacco you could use parsley or some other dry herb.
|
ZippyDoozy
Stranger


Registered: 04/11/13
Posts: 47
Loc:
Last seen: 9 years, 8 months
|
Re: Made something to smoke DMT, will it work? [Re: weilii-coyote]
#19313946 - 12/22/13 10:17 PM (10 years, 2 months ago) |
|
|
Quote:
weilii-coyote said: Will it work? Yes. But it probably won't work well and you probably won't be able to break through. I'm thinking the foil will get very hot and burn the DMT.
Do you have a regular pipe? You could throw some weed or tobacco down and put the dmt on top, then add a bit more herb, then smoke as usual. If you dont smoke weed or tobacco you could use parsley or some other dry herb.
Unfortunately can't smoke weed due to probation issues. Which I'm set to be off soon! And is also the reason psychedelics were brought into my life. First time using them; just wanted to get fucked up. Now, I enjoy psychedelics for the mindset it gives you, the tranquility, the beauty, the freeing of the mind, etc. But anywho; yes, I do have a regular pipe I used to use for smoking weed. Didn't even think of tobacco though! I smoke cigarettes on a daily basis; and I feel like a complete idiot for not even thinking of using tobacco!
So with tobacco, I would put tobacco on the bottom of the pull, then the DMT, then more tobacco? And do I light the tobacco as if I was regularly smoking weed or not?
EDIT: Also as for the foil, I wasn't planning on putting the flame directly underneath is. Just using it as a barrier and holding the flame away from it.
--------------------
All great ideas are obvious. But not all obvious ideas are great.
Edited by ZippyDoozy (12/22/13 10:18 PM)
|
weilii-coyote


Registered: 09/13/09
Posts: 207
Loc: South
|
Re: Made something to smoke DMT, will it work? [Re: ZippyDoozy]
#19314105 - 12/22/13 11:02 PM (10 years, 2 months ago) |
|
|
Quote:
ZippyDoozy said: So with tobacco, I would put tobacco on the bottom of the pull, then the DMT, then more tobacco? And do I light the tobacco as if I was regularly smoking weed or not?
Yep, that's right
|
ZippyDoozy
Stranger


Registered: 04/11/13
Posts: 47
Loc:
Last seen: 9 years, 8 months
|
Re: Made something to smoke DMT, will it work? [Re: weilii-coyote]
#19314120 - 12/22/13 11:06 PM (10 years, 2 months ago) |
|
|
Quote:
weilii-coyote said:
Quote:
ZippyDoozy said: So with tobacco, I would put tobacco on the bottom of the bowl, then the DMT, then more tobacco? And do I light the tobacco as if I was regularly smoking weed or not?
Yep, that's right
Just to confirm, do I light the tobacco directly? Or just keep the flame overhead?
--------------------
All great ideas are obvious. But not all obvious ideas are great.
|
ChasingBliss
.



Registered: 11/23/13
Posts: 4,759
Loc: Los Santos
|
Re: Made something to smoke DMT, will it work? [Re: ZippyDoozy]
#19314143 - 12/22/13 11:15 PM (10 years, 2 months ago) |
|
|
Don't torch it, hold the flame a bit away from the tobacco to let the DMT vape. Enjoy
|
ZippyDoozy
Stranger


Registered: 04/11/13
Posts: 47
Loc:
Last seen: 9 years, 8 months
|
Re: Made something to smoke DMT, will it work? [Re: ChasingBliss]
#19314154 - 12/22/13 11:21 PM (10 years, 2 months ago) |
|
|
Quote:
ChasingBliss said: Don't torch it, hold the flame a bit away from the tobacco to let the DMT vape. Enjoy
Alright, I prepared the bowl already for tomorrow! 
I added a layer of tobacco at the bottom. Then some cigarette ash on top of that so there is for sure no combustion of the tobacco and the DMT has a bit something more to melt into. Would it be better for me to load the DMT on top of all that with nothing else covering it; or to put a thin layer of ash on top of the DMT?
--------------------
All great ideas are obvious. But not all obvious ideas are great.
|
TheGreenArrow
Goodbye, Mr. Chops.



Registered: 06/22/12
Posts: 15,270
Last seen: 1 year, 11 months
|
Re: Made something to smoke DMT, will it work? [Re: ZippyDoozy]
#19314243 - 12/22/13 11:51 PM (10 years, 2 months ago) |
|
|
Good luck trying it with tobacco. I would seriously think about ordering some mullein.
-------------------- A human being should be able to change a diaper, plan an invasion, butcher a hog, design a building, conn a ship, write a sonnet, balance accounts, build a wall, set a bone, comfort the dying, take orders, give orders, cooperate, act alone, solve an equation, analyze a new problem, pitch manure, program a computer, cook a tasty meal, fight efficiently, die gallantly. Specialization is for insects.- Robert A. Heinlein Saint RedBow of the Shroomey Loomey-Patron Saint of Sandbaggin Sumbitchs
|
Noven
Stranger


Registered: 11/20/13
Posts: 72
Last seen: 7 years, 4 months
|
Re: Made something to smoke DMT, will it work? [Re: TheGreenArrow]
#19316825 - 12/23/13 03:54 PM (10 years, 2 months ago) |
|
|
I would advise against using foil, it will prolly release some unwanted chemicals from the heat applied I would not want going into my lungs. Secondly the heat might also have an affect on the plastic as well.
Why do you find it so hard to make a machine the materials needed are not hard to come by. I see you are also in America, I heard you can buy roses at gas stations that come in a meth pipe, which people use for DMT they're supposedly really cheap.
You say this was all you have available, is this motivated by time or money, perhaps you should invest a bit more time or a few dollars than wasting DMT.
But if you are really eager then yes I have heard of this method working, but a slightly different alteration - the guy cut the bottom of the bottle and kept the screw lid on the mouth piece until the bottle was filled with vapour before unscrewing and taking his hit. He used foil as well, and made a cone piece as well to hold the DMT, this larger section ensured that no plastic would be burnt, but he was still using foil which I'm not too fond of.
Anyway good luck and as long as you don't burn the plastic you should be fine.
|
larry.fisherman
shoulda died already



Registered: 11/03/12
Posts: 36,294
|
Re: Made something to smoke DMT, will it work? [Re: Noven]
#19316842 - 12/23/13 03:58 PM (10 years, 2 months ago) |
|
|
I just used a bong.
|
TheStonedMushroom
Your Average Shroom



Registered: 07/16/13
Posts: 43
Loc: Brisbane Australia
Last seen: 9 years, 2 months
|
Re: Made something to smoke DMT, will it work? [Re: larry.fisherman]
#19319132 - 12/23/13 11:42 PM (10 years, 2 months ago) |
|
|
^^ it's so fucking easy, if you have what you need to smoke weed, you can smoke DMT. I reckon a bong would be better than a pipe though, as you can get it all in one nice hit and I just prefer smoking bongs to pipes I guess
-------------------- “The syntactical nature of reality, the real secret of magic, is that the world is made of words. And if you know the words that the world is made of, you can make of it whatever you wish.” ― Terence McKenna
|
Agentchewy
Pantheism.


Registered: 12/12/12
Posts: 3,960
Loc: vietnam
Last seen: 1 year, 5 months
|
|
If you can only afford fiendish apertures to experience what is indescribable you may very well put yourself in a position for a trainwreck.
remember,
NOTHING can teach you any spiritual truth you did not once know, all that can be done is to remind you of what you have forgotten.
--------------------
If I knew the way, I would take you home.
|
ZippyDoozy
Stranger


Registered: 04/11/13
Posts: 47
Loc:
Last seen: 9 years, 8 months
|
Re: Made something to smoke DMT, will it work? [Re: Agentchewy]
#19327707 - 12/26/13 05:34 AM (10 years, 1 month ago) |
|
|
Meh, ended up throwing these two jiggy rigs out. Used the sandwich method with a regular bowl. Worked great! Most amazing experience ever.
--------------------
All great ideas are obvious. But not all obvious ideas are great.
|
|