|
thelastoneleft
Stranger

Registered: 11/08/12
Posts: 1,556
Last seen: 6 years, 3 months
|
Small Bho Runs
#19303847 - 12/20/13 04:48 PM (10 years, 1 month ago) |
|
|
hey guys just bored and ran out of wax lol but I do have ten grams of some super fire s.a.g.e strain left. I think it would make a fire run of hbo. Although this is my first time trying it, I plan on doing to within an hour or so.
Heres my supplies:
1 tall can 5x butane I have crock pot cooker that I will use for the warm water bath small pyrex lid to the crock pot that can be flipped upside down which i will use to blast into and then put ontop of crock pot with warm water to evap
now for the blasting tube im a little lost, Im sure i have some copper pipe or some type of pipe i can cut to use. but for ten grams how big should it roughly be? for best effeciency?
my plan is to blast the herb with hbo onto the pyrex lid thats is sitting on top of the crock pot filled with hot water. then i will have to let it bubble and evaporate? for how long and then should i finish up by whipping it to get the rest out?
I need some help from someone who has done this before but can give me directions using the tools I have.
|
larry.fisherman
shoulda died already



Registered: 11/03/12
Posts: 36,294
|
|
Weed should be lightly packed and lightly ground. Fine, but not too fine. Spacing on top should be at least around 10% of the volume. If pressure builds too quick let off and give it a second.
The butane should be placed in the fridge/freezer. Butane boils at a low temperature and it's best to keep it cold. I told you this before but you seem to insist hot water is what to do, but you're the expert. Always shake your cans, heavily.
|
larry.fisherman
shoulda died already



Registered: 11/03/12
Posts: 36,294
|
|
Coffee filters will work fine, I usually double or triple the layer. a tight seal is needed on both ends, and you obviously need a proper injection area.
I try not to use whitened filters, I just feel weird about it because you're using a solvent. I buy bamboo filters.
Edited by larry.fisherman (12/20/13 04:57 PM)
|
larry.fisherman
shoulda died already



Registered: 11/03/12
Posts: 36,294
|
|
What brand if butane did you buy?
|
thelastoneleft
Stranger

Registered: 11/08/12
Posts: 1,556
Last seen: 6 years, 3 months
|
|
xlcaps if I used ur tech ? i do what evap without hot water then put on heat at the end to make pliable to scrape?
|
thelastoneleft
Stranger

Registered: 11/08/12
Posts: 1,556
Last seen: 6 years, 3 months
|
|
I got vector butane still how big should i make the extration tube for ten grams? leave 10% space after all bud is in it will be perfect size tube?
|
larry.fisherman
shoulda died already



Registered: 11/03/12
Posts: 36,294
|
|
At first you shouldn't need heat. And you should both smell and see a difference when it's evaporated. Work it in to an area while you're in the middle of it all to minimize the need to scrape. Sometimes I will just hold or prop the dish near the end. If you need heat, let the dish climatize, then hit it with boiling water. If you try direct heat it will either fuck with the consistency or pollute it in to a black carbon mess.
Use cold water to evap. Seriously.
Wear gloves and a mask if you're doing it in an enclosed area.
No one can tell you evap time because it varies due to how much oil you pull, the quality of the bud, the evap method, and your environment.
|
larry.fisherman
shoulda died already



Registered: 11/03/12
Posts: 36,294
|
|
I've never used Vector. It used to be as popular as Colibri but I hear it can leave a residue or something. It's just not a pure but you still bought a good solid butane.
I can't tell you exactly how big the tube needs to be. You have to figure some of this out on your own. It's always a bit of a project.
Proper blasting tubes are handy..
|
thelastoneleft
Stranger

Registered: 11/08/12
Posts: 1,556
Last seen: 6 years, 3 months
|
|
thanks man still a little confused on cold water evaporating, after i blast I should have the pyrex sitting in ice water? then just wait for it to stop bubbling? after that pop the bubbles then put on top of hot water bath to evaporate whatever is reaming and allow it to be workable to scrape?
|
demiu5
humans, lol


Registered: 08/18/05
Posts: 43,948
Loc: the popcorn stadium
|
|

just smoke that shit. also, don't do the extraction in a small area like a bathroom or closet
-------------------- channel your inner Larry David
|
larry.fisherman
shoulda died already



Registered: 11/03/12
Posts: 36,294
|
Re: Small Bho Runs [Re: demiu5]
#19304000 - 12/20/13 05:23 PM (10 years, 1 month ago) |
|
|
Yeah you got it man just try to pay enough attention to the water temp so its steady.
|
thelastoneleft
Stranger

Registered: 11/08/12
Posts: 1,556
Last seen: 6 years, 3 months
|
|
End result only decided to used like maybe 5 grams if that since my buds fire as fuck didnt wana prematurely end its life.

Id say I got a gram i got more though, that i havent scraped yet
anyways the techinque i used gota hella fked for the better lool first time but turned out clean n strong
|
thelastoneleft
Stranger

Registered: 11/08/12
Posts: 1,556
Last seen: 6 years, 3 months
|
|
the consitency super shatter
|
thelastoneleft
Stranger

Registered: 11/08/12
Posts: 1,556
Last seen: 6 years, 3 months
|
|
|
Soluminia
The mind is god



Registered: 03/18/11
Posts: 3,978
Loc: CO
Last seen: 11 months, 15 days
|
|
Are you calling yourself underage?
--------------------
|
Big_Dave


Registered: 07/07/13
Posts: 393
Loc: DC burbs
Last seen: 5 months, 14 days
|
|
I think he's calling himself high as shit in the near future?
|
|