|
Some of these posts are very old and might contain outdated information. You may wish to search for newer posts instead.
|
Ace1928
Experimenter



Registered: 08/09/13
Posts: 181
Loc: NSW
Last seen: 5 years, 2 months
|
Weed, DMT, Salvia, Freebase etc etc Vaping Pipe Instructions
#18712762 - 08/16/13 01:42 AM (10 years, 6 months ago) |
|
|
Hey guys,
Figured I would whack this up for all of you to enjoy. Have seen a few things similar but this one is super cheap, nice and neat and costs about $10 - $12 AUD. Which is pretty awesome. Easy to clean. Easy to transport. Easy to store.
Materials

You need a brass U piece, reducing nozzle and a brass nipple with both sides threaded. The reducing nozzle has to have a thread on the inside or this wont work. You also need a kitchen hose piece. The shortest you can find that will fit onto the U piece. Sizing of the threads is up to you. Make it as big or as small as you want for whatever you are using it for. And you also need steel wool
First thing is first. Flame the holy hell out of the steel wool until absolutely no smoke comes from it anymore. It will no longer look super shiny and nice. It should be a grey-ish looking color.

Fill up the little nozzle with steel wool that has been flamed. Ensure that you can get decent air flow through the wool. This will act as an stopper for whatever you are vaporizing while also ensuring no direct flame gets on the substance. It also helps spread the heat evenly.

Fill the U piece up with flamed steel wool also. Just enough to stop anything from getting sucked out of the chamber and up the pipe. As with the nozzle make sure you get good airflow.

Join the reducing nozzle to the smaller nozzle.

When you stand it up with the small end down it should look like this. The gap between the steel wool and the top of the reducing nozzle is where you put your favorite substances. Make sure that the thread of the reducing nozzle is facing up so that the U joint can screw onto it.

Now you screw your U piece onto the reducing nozzle piece. Make sure you fill up the chamber on the reducing nozzle about half way with your favorite vaping substance. Keep it packed loosely so airflow can go through it nicely.

Simply attach your hose and you are good to go. Hold your hand on the hose with the open part of the nozzle facing down. Hold a lighter underneath the open end with your other hand and hold it as far or as close as you need to produce vapors but not smoke. A little experimentation will be needed for each substance
Cheers guys,
Hope you enjoy and if you have any questions just ask
Ace
-------------------- Only by embracing that which mother nature has supplied to us can we hope to ever peacefully exist on this planet
|
Ace1928
Experimenter



Registered: 08/09/13
Posts: 181
Loc: NSW
Last seen: 5 years, 2 months
|
Re: Weed, DMT, Salvia, Freebase etc etc Vaping Pipe Instructions [Re: Ace1928]
#18712812 - 08/16/13 02:06 AM (10 years, 6 months ago) |
|
|
Oh by the way everyone
This will also work wondrously with Shisha. The stuff you use in a hookah. NOW that is a TASTY smoke and portable as all hell.
-------------------- Only by embracing that which mother nature has supplied to us can we hope to ever peacefully exist on this planet
|
|