Home | Community | Message Board

Original Seeds Store - Cannabis Seeds
Please support our sponsors.

Mushrooms, Mycology and Psychedelics >> Mushroom Cultivation

Welcome to the Shroomery Message Board! You are experiencing a small sample of what the site has to offer. Please login or register to post messages and view our exclusive members-only content. You'll gain access to additional forums, file attachments, board customizations, encrypted private messages, and much more!

Amazon Shop: ½ Pint Jars

Jump to first unread post. Pages: 1
Registered: 07/15/03
Posts: 8
Last seen: 13 years, 1 month
Question about negative pressure while making honey water...
    #1827770 - 08/18/03 09:18 PM (14 years, 2 months ago)


The mole on my left testicle was making some honey water and has some concerns regarding contamination. The jars (4 at 125ml each) , and water and honey were sterilized via boiling (2 for 20 minutes and 2 for 30). I then waited a day to inject the spore solution. Upon removing the tape (there was only one hole in the lid for an injection site) 3 of the jars "sucked" in air. I carried on with the preocedure (which was all done amidst the updraft of my oven) and put the jars in a warm place. So here's my question: from peoples friends' experience, is it quite probable that the "sucking" in of air from the jars caused contamination?

If so, is there anything i can do to prevent contamination?? maybe incubate at high temps, add h2o2 and hope the good guys hatched and survived in time and the bad guys die off? also...really, what's the chances of honey water contaminating? honey should never spoil...

Thanks for any help. My nut is just looking to confirm or toss out his worst fears.

Post Extras: Print Post  Remind Me! Notify Moderator

Registered: 12/07/02
Posts: 2,017
Loc: PNW
Re: Question about negative pressure while making honey water... [Re: snowy]
    #1827867 - 08/18/03 09:55 PM (14 years, 2 months ago)

couple of things your mole could do on the next go .
cover the jar with foil, and wait till jar is cooled before he tapes the hole .
or, draw sterile air through a flame with a syringe and inject through the tape .
sense he used the oven tec (and if he did that properly) probably nothing to worry about .
tape over the inoculation hole isn't realy needed unless you have a problem with ants, like i did . :lol:

Post Extras: Print Post  Remind Me! Notify Moderator
Jump to top. Pages: 1

Amazon Shop: ½ Pint Jars

Mushrooms, Mycology and Psychedelics >> Mushroom Cultivation

Similar ThreadsPosterViewsRepliesLast post
* positive or negative pressure box? nihilist 576 4 12/03/03 11:10 PM
by fidget
* Positive and Negative Pressure Environments in Liquid Cultures bbf 741 6 10/19/13 01:33 AM
by Midnight Cyclone
* Question about pressure cooking paranoid2 1,438 10 06/17/02 05:48 PM
* Negative Pressure newmodel 466 10 02/25/09 02:29 PM
by iskinbash
* NEGATIVE PRESSURE whitesox 537 4 04/23/03 01:48 PM
by whitesox
* positive/negative pressure in fridge..... (advanced) tokey666 776 5 01/20/06 08:14 PM
by Snaggletooth
* A few questions before I make purchases
( 1 2 all )
Kiada09 897 20 02/26/09 05:09 AM
by Spongiform
* Noob question about Pressure cooker kr0nikaldro420 772 6 03/15/05 02:55 PM
by Mobius_Strip

Extra information
You cannot start new topics / You cannot reply to topics
HTML is disabled / BBCode is enabled
Moderator: Roadkill, Magash, Shroomism, george castanza, RogerRabbit, Citric, total, FooMan, 13shrooms, stonesun, cronicr, PussyFart, Tmethyl, Pastywhyte, bodhisatta
294 topic views. 21 members, 98 guests and 30 web crawlers are browsing this forum.
[ Toggle Favorite | Print Topic | Stats ]
Search this thread:

Please support our sponsors.

Copyright 1997-2017 Mind Media. Some rights reserved.

Generated in 0.023 seconds spending 0.004 seconds on 19 queries.