|
Some of these posts are very old and might contain outdated information. You may wish to search for newer posts instead.
|
Natorade
LsDmThC


Registered: 02/18/10
Posts: 1,568
Loc: WI
Last seen: 2 years, 10 months
|
Will this work?
#14459413 - 05/15/11 10:00 PM (12 years, 8 months ago) |
|
|
ok so i have recently acquired 60mg of dmt!
2nd time obtaining it first time was fairly impure stuff (very orange) and was smoked improperly so i got some wild visuals but definitely no where near breaking through
and as much as id like to test the waters again, i really want to breakthrough... but only have 60mg (though it appears much purer than last time, just a tad yellow), and i may not run into it again for quite some time
so im assuming id have to smoke all of this in one go, correct? just load it all up at once, melt it down and hold in a couple big hits?
but the thing is, neither smoke shop in my town carries oil burners ( ) so i just picked up one of these

its only about 3" and very thin, so if i just dropped the crystals through the bowl into the bottom and heated it from underneath like a regular oil burner, would it still work the same way??
|
AlmostAsCoolAs


Registered: 11/14/09
Posts: 7,215
Loc: California
|
Re: Will this work? [Re: Natorade]
#14459430 - 05/15/11 10:03 PM (12 years, 8 months ago) |
|
|
It should if it's thin and yeah, just do it all at once.
--------------------
|
Natorade
LsDmThC


Registered: 02/18/10
Posts: 1,568
Loc: WI
Last seen: 2 years, 10 months
|
|
yeah its real thin, probably just as thin if not more so than an oil burner
well sweeeeet then! 
thanks 
now i just gotta wait for a time when i know ill have the room to myself for a little while... then its blast off time!
|
argg
Stranger


Registered: 07/20/09
Posts: 4,848
Loc: Nigeria
Last seen: 12 years, 7 months
|
|
I find the oil burner method harder then the vapor genie/machine/ashbed method. The oilburner I have found hard to not burn the stuff. I tried it for a quick minute and went back to a crack pipe where I could control the heat with flame distance and air draw rate. I can break through every time that way as opposed to oil burners doing what the name says it is, a burner.
I would rather smoke a fat bowl of something out of that pipe of load it with turds of cigarette ash then pile the DMT on top. I would melt it in the ash with a little flame then hit it real slow melting the DMT into the ash bed and keep the lighter far enough away so the flame gets drawn to it but does not touch the ash bed.
--------------------
|
Natorade
LsDmThC


Registered: 02/18/10
Posts: 1,568
Loc: WI
Last seen: 2 years, 10 months
|
Re: Will this work? [Re: argg]
#14459639 - 05/15/11 10:41 PM (12 years, 8 months ago) |
|
|
if i had a bunch, id definitely make the effort of putting together a machine, but since its just this once ima stick with either the oil burner method or sandwiching/melting it like you suggested. ill read around a bit more on that method though; id just be kinda scared of straight burning it with the flame, but ill see.
|
|