smurfyshmu said:

So SWIM finally crystallized some DMT which looks relatively pure to the eye, and tried to vaporize the substance in a converted light bulb vapo. To which I'll try and describe the experience.

SWIM inhaled the first hit which seemed quite harsh, but remembered hearing that it was like that and to just go deep and slow. Halfway through the hit SWIM noticed his tongue go concernedly numb along with an intense burning all down his throat and in his lungs. SWIM immediatly stopped the dose there due to thought of possibly extracting some of the lye mixture or possibly using the wrong kind of lye that had another additive.

Whats left in the pipe is a oily residue to which SWIM believes could be melted DMT. Is there any chance to save whats extracted with possible recrystallization? Also any thoughts on the adverse reaction? This is SWIM's first time and generally upset with how it went, and sore.

---

Nature Boy said:

moe.phan said:

calcium carbonate(soda ash). not bi-carbonate(baking soda).

---

Actually, what you want is sodium carbonate, not calcium carbonate, although the latter will work, the sodium carbonate is preferable.  I mis-spoke when I wrote calcium carbonate.

Sorry for any confusion.  Sodium carbonate is also ultra-cheap.  Here is what I learned from a PM from a highly respected source.

"Calcium carbonate isn't very water-soluble, so your carbonate water will be cloudy with undissolved calcium carbonate, but it will raise the pH just fine.  It's entirely possible that some of the particulate calcium carbonate will end up in the naphtha phase, but that's really not cause for concern.  Calcium carbonate is quite stable to heat, so the product is quite safe to smoke even if it has some calcium carbonate in it (I've seen it recommended that bufotenine be dissolved onto calcium carbonate to make dosing easier (considering the tiny doses at which vaporized bufotenine is active).

So basically the product may not be quite as pure, but it will still be clean and safe to vaporize."

I hope this clarifies things!

N.B.

---

smurfyshmu said:

Alright, so I (sorry for the SWIM, never to careful ) realized that the greenish tinge to the crystals was from the lye solution getting sucked up with my naptha. I realized this after hitting 10 mg of the pure white dmt crystal (rather than the greenish hued crystals) and received the most warm feelings of ecstasy coat my body with moderate visuals. I'm going to recrystallize since this must be the problem.

For those that have yet to try it, the lye solution is a horrible thing to inhale whatever additive greened my DMT, jeez, I can't even describe the harshness of it. However the pure white DMT was considerably smooth! My technique is fine, just the impure product. I have another 16 oz of MHRB on the way  

Practice makes permanent! 

---

smurfyshmu said:

I thought MHRB was up there in terms of concentration of dmt, any suggestions?

---

http://img41.imageshack.us/img41/9529/dmto.jpg

Information taken off of erowid, made a few minor adjustments to make it a little easier to read.

I also hear that 'phalaris arundinacea' is actually really high in DMT concentration, (a lot more than that chart says), so I'm not quite sure. I mean MHRB is high up there, but I'm sure there is quite a few other plants with higher concentrations.

Just saying, if you think MHRB is good for you, then you do what you think's best. I'm just trying to help a little bit. Personally.. I'd get Yopo seeds and just snort them, but its more of the bufotenine that makes you trip more than the DMT. Look it up, sounds interesting imo.

smurfyshmu said:

actually my naptha is VM & P but my lye is some drain opener from home depot, I know the lye is the white balls but I think they have a faster acting basifier in there as well which is a bluish color, but it turns the top of my water green when stirring it in. Wasn't sure if it was bad or good, but when I extracted crystals I figured it alright. I must've pulled some on the lye water into the final product by accident.

---