Home | Community | Message Board

Avalon Magic Plants
Please support our sponsors.


Welcome to the Shroomery Message Board! You are experiencing a small sample of what the site has to offer. Please login or register to post messages and view our exclusive members-only content. You'll gain access to additional forums, file attachments, board customizations, encrypted private messages, and much more!

Shop: Kraken Kratom Red Vein Kratom   PhytoExtractum Buy Bali Kratom Powder

Jump to first unread post Pages: 1
Offlinetrancefishy
ambiguity

Registered: 07/24/02
Posts: 365
Loc: under the stars
Last seen: 13 years, 4 months
incubator temperature readings whack
    #1046201 - 11/12/02 02:10 PM (18 years, 11 months ago)

Ok, I built that rubbermaid incubator to a tee, few inches of water with a fully submersible 100 watt visitherm heater with thermostat. inside i have some poo and a few jars. the air temperature just off the bottom, where everything sits, has always been 84-85 degrees, but the thermostat is set at 88. So today for kicks, I put the sensor of my thermometer directly on the plastic sitting under the poo. i got temp readings from 92-94 degrees!! definately too hot. anyone else have this problem? It makes it difficult to set things up correctly with 3 different temperatures. I think i may build a rack to suspend my stuff just above the plastic


Extras: Filter Print Post Remind Me! Notify Moderator Top
Offlinethisone
the one theydon't see

Registered: 11/06/02
Posts: 818
Last seen: 16 years, 6 months
Re: incubator temperature readings whack [Re: trancefishy]
    #1046219 - 11/12/02 02:17 PM (18 years, 11 months ago)

I noticed this same problem with jars and felt this was a bad happening. I think that a simple way to solve this problem is to put a blanket or clothing ariticle underneath the casing. there hasn't been any problems with the jars sitting on the plastic as far a colonization but I might try to suspend them. Probably safer.


--------------------
Everything written above this line is completely false. I am terribly bored and write here to pass time. I do not participate or support any illegal activity.


Extras: Filter Print Post Remind Me! Notify Moderator Top
OfflineSkikid16
fungus fan

Registered: 06/27/02
Posts: 5,666
Loc: In the middle of the nort...
Last seen: 16 years, 6 months
Re: incubator temperature readings whack [Re: trancefishy]
    #1046220 - 11/12/02 02:17 PM (18 years, 11 months ago)

Try lowering the thermostate. 85 is optimal, but as long as you get it in the 82-87 range you'll be cool, I'd say shoot for lower than higher.


--------------------
Re-Defeat Bush in '04


Extras: Filter Print Post Remind Me! Notify Moderator Top
OfflineOn_the_Down-Low
Polyfil-ophile-Say it 3 timesfast.

Registered: 10/15/02
Posts: 401
Last seen: 16 years, 8 months
Re: incubator temperature readings whack [Re: trancefishy]
    #1048596 - 11/13/02 05:02 AM (18 years, 11 months ago)

The neighborhood armadillo put 2 thermometers in the cabinet. He found that with the thermostat set to 86,the water temp was 86, as was the bottom of the upper box. The air temp however was only 80degrees. He thinks it has to do with how the heat is absorbed by different materials.

Do you have the upper box surrounded by water,or is it only making contact on the bottom?


Extras: Filter Print Post Remind Me! Notify Moderator Top
Offlinebugabuga420
bUgAbUgaBOO

Registered: 07/18/02
Posts: 488
Last seen: 3 years, 11 months
Re: incubator temperature readings whack [Re: On_the_Down-Low]
    #1049788 - 11/13/02 06:08 PM (18 years, 11 months ago)

i dont have this problem i use a styrofoam cooler with a clampable lid and a jar with aquarium heater in it. I sayat exactly 85.0 degrees at all times. My jars thank me well.


Extras: Filter Print Post Remind Me! Notify Moderator Top
OfflineShaw
hick

Registered: 06/28/01
Posts: 2,220
Loc: midwest, usa
Last seen: 10 months, 11 days
Re: incubator temperature readings whack [Re: trancefishy]
    #1051244 - 11/14/02 02:05 AM (18 years, 11 months ago)

I hated that shit. could never get the temp right with a fishtank heater. If i was still using one now, i would put water and the heater in the bottom of a rubbermaid tub, and put the same size with a lid in that. it'd create a decent seal (minus the cord) and you wouldn't have as much problem with the water coolong the heater. I think una did it like this, but i like having it sealed. some guy had a big ling thread about the sealing idea.


--------------------


Extras: Filter Print Post Remind Me! Notify Moderator Top
Jump to top Pages: 1

Shop: Kraken Kratom Red Vein Kratom   PhytoExtractum Buy Bali Kratom Powder


Similar ThreadsPosterViewsRepliesLast post
* Incubation temperature Drummer 736 1 04/06/02 11:09 PM
by Lapius
* incubation temperatures michael_ahji 1,844 3 06/06/07 12:02 PM
by Kamin
* proper incubation temperatures. Larrythescaryrex 2,155 14 10/20/02 04:20 PM
by Larrythescaryrex
* who uses lights in there incubator?ANNO? nw2shroom 1,951 6 05/30/02 05:04 AM
by GreyMatter
* Incubation Temp, too hot? bladerunnerss 4,152 13 07/18/02 05:49 PM
by WakingUpLate
* What a difference an incubator makes! Green_Velvet 966 7 07/30/02 01:28 PM
by Frog31337
* The Problem of Heat
( 1 2 all )
psilocyberV 6,002 36 11/22/15 06:52 PM
by DiMiTriLee
* Help! Optimal incubation for azures? *DELETED* MeetMeInEleusis 670 1 11/06/01 03:14 PM
by Anno

Extra information
You cannot start new topics / You cannot reply to topics
HTML is disabled / BBCode is enabled
Moderator: Shroomism, george castanza, RogerRabbit, FooMan, mushboy, fahtster, LogicaL Chaos, 13shrooms, stonesun, wildernessjunkie, cronicr, Pastywhyte, bodhisatta
945 topic views. 17 members, 146 guests and 44 web crawlers are browsing this forum.
[ Print Topic | ]
Search this thread:

Copyright 1997-2021 Mind Media. Some rights reserved.

Generated in 0.022 seconds spending 0.007 seconds on 16 queries.