Home | Community | Message Board


This site includes paid links. Please support our sponsors.


Welcome to the Shroomery Message Board! You are experiencing a small sample of what the site has to offer. Please login or register to post messages and view our exclusive members-only content. You'll gain access to additional forums, file attachments, board customizations, encrypted private messages, and much more!

Shop: Kraken Kratom Red Vein Kratom   Bridgetown Botanicals CBD Topicals

Jump to first unread post Pages: 1
Some of these posts are very old and might contain outdated information. You may wish to search for newer posts instead.
OfflineCykadellick
Stranger
Male

Registered: 02/15/09
Posts: 1
Last seen: 15 years, 1 month
My well organized updated marsofold tek with a few tiny tweeks
    #9805185 - 02/15/09 10:25 PM (15 years, 1 month ago)

Supplies you will need
- 1-Pound of mimosa hostilis rootbark
- Blender
- Empty 1-gallon plastic jug
- 1-Quart white vinegar
- Distilled water
- 3-Liter crockpot
- Something to stir hot liquids
- 1-gallon wide-mouthed glass or stainless container
- Empty 1-gallon glass wine jug
- 5 Tablespoons (63grams) of sodium hydroxide (lye)
- 1-Pint of WARM water
- pH papers or digital pH reader
- 500 milliliters (1 pint) of VM&P naptha
- Glass turkey baster
- 2 pint mason jars
- Freezer
- Funnel
- Quart mason jar
- Small coffee filter paper
- Metal scraper (butter knife)
- NON-SOAPY clear ammonium hydroxide


Step One - What you will need --
- 1-Pound of mimosa hostilis rootbark
- Blender

Break 1-Pound of Mimosa Hostilis rootbark into 2” pieces and grind it all up in a glass-topped blender, a little at a time. Grind the rootbark up to no more than 1mm particle diameter. Less than this will result in decreased yields.


Step Two (Polar Extraction) - What you will need --
- The ground up mimosa hostilis rootbark (From Step One)
- Empty 1-gallon plastic jug
- 1-Quart white vinegar
- 3.5-Quarts of distilled water
- 3-Liter crockpot
- Something to stir hot liquids
- 1-gallon wide-mouthed glass or stainless container

Premix in an empty 1-gallon plastic jug: 1-quart of white vinegar & 3.5-quarts of distilled water. Put the ground up mimosa in a 3-liter crockpot, then fill it with 50% of the water-vinegar solution. Stir well and turn it on “high”. After 2 hours, remove the crockpot ceramic liner, hold the lid on slightly offset, and pour off most of the liquid into a 1-gallon wide-mouthed glass or stainless container.

Add 25% of the water-vinegar solution to the crockpot again. Stir well and turn it on “high”. After 2 hours, remove the crockpot ceramic liner, hold the lid on slightly offset, and pour off all of the liquid into the same container again.

Add the last 25% of the remaining water-vinegar solution to the crockpot again. Stir well and turn it on “high”. After 2 hours, remove the crockpot ceramic liner, hold the lid on slightly offset, and pour off all of the liquid into the same container again.

After the last extraction press out the fiber to squeeze the last bit of liquid from it. Discard the rootbark fiber and save the three combined extractions in the 1-gallon container. Allow the vegetable particles in the extraction in the 1-gallon container to settle to the bottom overnight.


Step Three - What you will need --
- Contents of the 1-gallon container (From Step Two)
- Empty 1-gallon glass wine jug

Then pour off the liquid from 1-gallon container into an empty 1-gallon glass wine jug, being careful not to pour off any of the vegetable sludge at the bottom. Discard the sludge and keep the contents of the wine jug.


Step Four (Basification) - What you will need --
- Contents of the 1-gallon glass wine jug (From Step Three)
- 5 Tablespoons (63grams) of sodium hydroxide (lye)
- 1-Pint of WARM distilled water
- pH papers or digital pH reader

Premix in advance a solution of: 5 tablespoons (63 grams) of sodium hydroxide (lye) with 1-Pint of WARM distilled water. Stir well.

Slowly add this solution to the wine jug, then cap the jug. Gently tilt the wine jug back and forth for 1 full minute to mix the contents. Basify to a pH of 13.
Note: If you don’t have pH papers, basify till it turns black, then add an additional 25% of the amount of basification solution you used.This is to guarantee that you’re at a pH of 13 and then tilt the wine jug back and forth for 1 full minute again.

The brown foam you see floating on top of the basified extract after tilting the jug should flatten out to a thickness of no more than 1/2” after 45 minutes or so if you’ve used enough lye. Add a bit more lye and re-tilt if it’s thicker than that.

Let your mixture cool down.


Step Five (Nonpolar Extraction) - What you will need --
- Contents of the 1-gallon glass wine jug (From Step Four)
- 450 milliliters of warm VM&P naptha
- Warm distilled water
- Glass turkey baster
- Pint mason jar

Add 150ml of warm VM&P naptha to the wine jug. Add exactly enough warm distilled water to the jug to raise the liquid level to an inch below the top, then cap the jug.
Note: To get the naptha warm, heat up some water and place a glass container with the 150ml of VM&P naptha in it, into the hot water and let it sit for a minute or so. Be careful.

Gently tilt the wine jug slowly back and forth for 5 full minutes to mix the contents. Allow the jug to sit undisturbed on a table for at least 4 hours.

There should now be two layers visible in the jug, a lower dark one and a smaller clear one on top filling the neck of the jug. Use a glass turkey baster to suck up the top clear layer into a pint mason jar. Be careful not to suck up any of the lower brown/black layer into the mason jar.

Repeat the last three steps two more times and afterwards the contents of the 1-gallon glass wine jug can now be discarded.

Then gently evaporate the contents of the pint mason jar down to half volume. The contents should look cloudy after its been evaporated enough.
Note: If you want big clean crystals you must evaporate as slowly as possible, and cover it with something on top (preferably not plastic), and just have a small hole so the vapor can escape. For example keeping it on a balcony in a glass dish or container and cover it with something. If you want it fast, let it open so it evaporates quicker into the air.


Step Six (Freeze-precipitation) - What you will need --
- Conents of the pint mason jar (From Step Five)
- Freezer
- Funnel
- Quart mason jar
- Small coffee filter paper
- Metal scraper (butter knife)

Place the sealed mason jar in a freezer for 3 days to precipitate the crystals.
Note: Your freezer can’t be marginally cold. If it doesn’t freeze ice cream HARD, then it isn’t cold enough. -20°C (-4°F) is about where it should be.

Prepare a filter setup by placing a funnel into a quart mason jar and putting a small coffee filter paper into the funnel.

Shake the naptha in the mason jar strongly to stir up all the crystals and use a metal object to break the crystals from the sides of the contianer then very quickly pour into the funnel for filtering. Filter within a minute or two after removal from the freezer so it doesn’t have any time to warm up or else it will get warm and redissolve the DMT. Impure yellow-white DMT crystals will be seen on the coffee filter paper. Pay attention to the crystals that will have formed in the jar after the naptha has been poured out of it and allowed to dry, these can be scraped out and used also.
Note: The leftover naptha can be re-froze/precipitated a couple more times or allowed to evaporate completely to get any of excess DMT from it or even used for another extraction, but this step is completely optional.

Allow the crystals to completely dry out on the filter paper in the funnel.

If your dry crystals are white to very almost white, then there is no need to contine with the last few steps and you are done. If they have a yellowish color to them, then the next steps are required to purify them to the pure white color they are supposed to be.


Step Seven (Wash) - What you will need --
- Distilled water
- NON-SOAPY clear ammonium hydroxide
- Second unused pint mason jar

Premix a wash solution by mixing equal parts of distilled water and NON-SOAPY clear ammonium hydroxide equaling 100 milliliters total of liquid into a pint mason jar.
Note: An alternative to the ammonia-water wash is to use 25 milliliters (5 teaspoons) of ICE COLD distilled water to wash.

Be sure that the crystals are absolutely DRY before washing. Slowly pour 100 milliliters of the wash solution over the crystals (still in the filter paper) to wash them.

Remove the filter paper from the funnel, spread it out flat and allow the crystals to COMPLETELY dry out.

You should now have at least 2-1/2 grams of white crystalized DMT



Does these seem like a sound plan?? anyone who can give me sum detailed info on increasing swims yeild further please don't hesitate.

Extras: Filter Print Post Top
OfflineCascadian
Feel like a Stranger
Male User Gallery


Registered: 09/13/08
Posts: 1,130
Loc: Cascadia
Last seen: 12 years, 1 month
Re: My well organized updated marsofold tek with a few tiny tweeks [Re: Cykadellick]
    #9808182 - 02/16/09 01:51 PM (15 years, 1 month ago)

Thanks for the writeup, just one question:

Quote:

Premix in an empty 1-gallon plastic jug: 1-quart of white vinegar & 3.5-quarts of distilled water




How does one fit 4.5 quarts into a 1 gallon container?

Extras: Filter Print Post Top
OfflineNature Boy
Stranger than most
Male User Gallery


Registered: 07/09/07
Posts: 8,246
Loc: Samsara
Last seen: 16 days, 9 hours
Re: My well organized updated marsofold tek with a few tiny tweeks [Re: Cykadellick]
    #9808818 - 02/16/09 03:24 PM (15 years, 1 month ago)

While it may be well organized, why anyone would bother with all this I'll never know.

The straight-to-base tek works exceedingly well, gives nice clean product, an excellent yield, and is 1/5 as complicated, time consuming, and labor intensive.

Sheesh.

N.B.


--------------------
All submitted posts under this user name are works of pure fiction or outright lies.  Any information, statement, or assertion contained therein should be considered pure unadulterated bullshit.  Note well:  Sorry, but I do not answer PM's unless you are a long-time trusted friend.  If you have a question, ask it in the appropriate thread.

                                                                               

Extras: Filter Print Post Top
Offlinememory_bakoon
Stranger

Registered: 06/20/08
Posts: 72
Last seen: 11 years, 10 months
Re: My well organized updated marsofold tek with a few tiny tweeks [Re: Cykadellick]
    #9848510 - 02/23/09 04:11 AM (15 years, 1 month ago)

Quote:

Grind the rootbark up to no more than 1mm particle diameter. Less than this will result in decreased yields.




I don't get this.
Finer the better,isn't it?

Extras: Filter Print Post Top
Jump to top Pages: 1

Shop: Kraken Kratom Red Vein Kratom   Bridgetown Botanicals CBD Topicals


Similar ThreadsPosterViewsRepliesLast post
* Marsofold DMT extraction question
( 1 2 3 4 ... 10 11 all )
ItsaMeMario 90,283 210 10/02/15 03:25 AM
by Fractaliopsybe
* Marsofold tek and some questions on ingredients ionicle 3,222 4 09/22/08 07:21 AM
by shroomzey
* Marsofold DMT extraction completed figment 5,813 19 04/09/07 05:49 PM
by Infested
* marsofolds tek tealeaf 2,486 12 09/29/08 02:12 PM
by Lady Luv
* Marsofold's extraction tech Angered Roach 1,407 6 07/27/07 02:24 PM
by Salvia_Antics
* Marsofold Tek Question! *DELETED* smac1009 1,158 5 06/26/08 09:01 PM
by boletusoftruth
* Marsofold tek question - warm water added? Ophanim 805 4 04/14/08 11:55 AM
by Ophanim
* Marsofold's vs. Noman's Tek TheBulb2005 6,326 2 07/15/07 03:57 AM
by Chacer

Extra information
You cannot start new topics / You cannot reply to topics
HTML is disabled / BBCode is enabled
Moderator: psilocybinjunkie, Rose, mushboy, LogicaL Chaos, Northerner, bodhisatta
1,582 topic views. 2 members, 25 guests and 57 web crawlers are browsing this forum.
[ Show Images Only | Sort by Score | Print Topic ]
Search this thread:

Copyright 1997-2024 Mind Media. Some rights reserved.

Generated in 0.02 seconds spending 0.006 seconds on 14 queries.