Quote:

---

bw86 said:
i love lipa porn

---

Quote:

---

lipa said:
I mix my sawdust mixtures by hand wetting it a little much at first. I then let it sit for a half a day and then check it again. I add water as needed to bring it up to the highest point of saturation without it sqeezing out too much water. Then I bag it. If you drop a handfull on the concrete and it say's PLOP it is probably too wet. If it breaks up like wet sand when it hits the concrete you're good to go.

Lipa

---

Quote:

---

lipa said:
If you are using cold water to hydrate those pellets you need to wait at least 5 hours for the sawdust to absorb all the moisture. Not much waiting when the waters hot. The sqeeze test should produce a few trickle of water, not absolutely nothing.

Anyways, you should test you're mixture for moisture capacity and write you're findings down on paper so you get it just right every time until you understand what the moisture content and feel of the substrate should be like.

Happy growing
Lipa

---