You'll need the Following:
- 1 Plastic tub- you can find these in Walmart.
- 1 Junior Fish heater<-(very important) can also find in Walmart.
- 1 Airline Tubeing 25feet ( youll have some left over, can also find in Walmart)
- 2 Air Stones (wallyworld)
- 1 Humidity and Temp Gage (you can find in petsmart)
- 1 Thermometer
- 1 Mini Fluorescent light
- 1 Gatorade Top
- 1 Glue stick and or Glue Gun
- 1 Super Glue (yes you need both glue's)
- 2 Normal Soda Bottle with tops
- 1 Light timer
- 4 AA battery
- 1 Drill Gun or something to make small holes with.
- First you are going to start by drilling holes in the side of the Tub only the Corners and the bottom but the side bottom as you can see in my pictures, this is very important cause this will control the level of Humidity.
- Now take your soda Bottle and cut of the top as you can see in the picture. then take the drill and put some holes in whats going to be the front of your bottle and two holes in back of the bottle make sure they are opposites of one another this is important.
- Now place the bottle in the tub and measure where you think you are going to put your Airline Tubeing then drill TWO holes and slide the tubing threw them into the bottle, take the tube ends and connect the air stones to them ( make sure there not touching the bottom).
- Now take your Gatorade Top and your Junior Fish heater and slide the wire the wire in the middle where you made your hole.
- WARNING! MAKE SURE ITS NOT TOUCHING THE SIDES AND OR BOTTOM!!!!! this could end up really bad for you ( REALLY BAD!) and also don't turn on the heater without water in the bottle cause this could break your heater.
- Now seal it all up with tape the crap out of the top and make sure it is secure, and the heater is in the middle.
- Now take your bottle cap and Glue it to the bottom of you bottle so the bottle has some support when its sitting look at my pics to see how it looks.
- Take your bottle and that part that is touching the wall of the tub and glue it to it make there are two sides touching both walls of the tub.( glue both of them, if one side is to far then tap it then glue the tape)
- A)Now take your Thermometer and stick it to the side of the bottle just enough so when you pour water it to it its just over it.
- B)Take your Humidity Gage and place "SUPER GLUE" on it and hold it till you are sure it wont drop off ( this is cause when the Humidity raises it will drop off if you use anything else.
- Take your "Fluorescent light" and the top of the tub and use the "Glue Gun" to stick it to the top again this is cause the Humidity will make it fall off. and I'm sure you don't want anything to get smashed =O
- Take the wire from the heater and drill out and hole in the tub so when you close the top everything closes look at my pictures.
- Now take your air tubing and hook it up to your Airpump then take the airpump and the heater and hook them both up to a extension cord or something that you can put more then one pluge in, then take the extension cord and hook it up to the light timer and set it to a time that would be convenient for you ( personally i set it for 12am to 12pm so it runs at Night while i sleep and start at 6pm and runs till 8pm this way it can rest.
A)Now how to fill the bottle- well you have some extra Airtubing i hope, and a soda bottle with a top. take your soda bottle top and cut a hole just big enough to slid in the air tubing.
Then take your glue gun and put it around the Airtube (make sure its not to hot so you don't melt the tube)
B)Now take you empty Soda bottle and fill it with some clean water (if you have a water filter great if not get some bottled water and fill it) then screw on the top till tight and slide the airtube into one of the many holes and flip over the soda bottle and watch the water go in (Make sure the water is just a little over the heater) (Make sure the heater is waterproof- if not then make sure its just over the heating part)
Now take after you have everything rdy to go and your cakes are in there open the top about 3 times a day 1pm 6pm and 10pm dose not really matter you just want to get rid of the CO2.
1)
2-3)
4-5)
6)
7)
8)no pic
9)
How to fill up your humitifier
1
.2
"
3
4
"
5
By-Sterben
